2. Verify that the appropriate audio cable is connected in the “To
Speaker” label on the back of the RTX 2.0, either the 3.5mm audio
input or the TOSLINK/opcal audio input.
3. Power on the Home RTX 2.0. There are three ways to power on the
Home RTX 2.0: 1) connect the RTX 2.0 to USB power, 2) If already
connected to USB power and powered o, press and hold the
power buon for 5 seconds unl the indicator lights come on,
3) If powered o, switch between TX and RX mode
4. Start the pairing mode on the RTX 2.0: press the mul-funcon
buon for 3 seconds unl the CH 1 light begins ashing rapidly.
You will hear a voicing announcing “Pairing.”
5. Open the Bluetooth menu on your phone, tablet or other
compable A2DP Bluetooth® prole device and select the Miccus
Home RTX 2.0. If your tablet or cell phone requires a passkey, use
“0000.”
6. WAIT for the devices to connect. This may take up to 30 seconds.
7. Once paired, you will hear a voice announcing “Connected” and
the Home RTX 2.0 CH1 indicator light will change to either solid
blue or blink twice every 5 seconds if in Low Latency mode.
8. To begin streaming wireless audio, simply press play on your audio
source, adjust the volume to preference, and enjoy!
9. If you want to pair to a second device, follow these steps:
1. Pair your rst phone or tablet to the Home RTX 2.0 (steps 1-8
above)
2. Start the pairing mode on the RTX 2.0 by pressing the
mul-funcon buon for 3 seconds unl the CH 2 light begins
ashing rapidly
3. Open the Bluetooth menu on your phone, tablet or other
compable A2DP Bluetooth® prole device and select the
Miccus Home RTX 2.0. If your tablet or phone requires a
passkey, use “0000.”
4. Wait for the devices to connect. This may take up to 30
seconds.
5. When the second set is paired, both CH 1 and 2 lights will light
either solid or will blink twice every 5 seconds indicang aptX
Low Latency codec.
9
