LENNY-MD-092 4ZONES control
Smart LED control system
by
9
RGBW
Remote control functions: LENNY-MD-088
by
Note: One driver is necessary per every zone.
Slide your finger over the coloured ring to
change colors.
Color brightness level and white changing.
Turns on white channel (from 4th channel) at
full brightness. To regulate white, slide bar for
“white channel regulation” must be used. It
is not possible to achieve white with R+G+B
combination.
Increasing or decreasing white brightness
channel only (from 4th channel). If there is a
previously selected RGB colour, adds white to
the RGB colour.
4 zones ON.
4 zones OFF.
Dinamic modes.
Under dynamic mode running, you can get light
running faster with this switch.
Under dynamic mode running, you can get slow
speed with this switch.
Selected zone ON. Also used to link and unlink
driver from this zone.
Selected zone OFF.
Brightness regulation
Pre-loaded modes
Zone ON
Master ON
Color ring
White color
regulation
Speed +
Zone OFF
Speed –
Master OFF
ON of the white color
Working mode
• Select color: Touch color wheel on desired color (e.g.blue).
• Brightness bar: Adjust brightness level.
• Activate only white: Click on the bar “ON white colour”. It will be activated at 100%. To regulate brightness we will use
slide bar “brightness regulation”.
• Activate Colour + White: Choose colour with slide colour wheel and adjust white with slide saturation bar (0%
-downwards - white channel off, 100% - upwards - white channel on at maximum).
• Colour + White and colour removing: Press slide bar “ON white colour”.
• Colour + white and white removing: slide bar “white channel regulation” up to 0% (downwards).
