RS 300 K / Rev. A 05 - Page 3 / 24
Target group
Only qualified and trained electricians may connect, program and service the controls.
Qualified and trained electricians meet the following requirements:
-knowledge of the general and specific safety and accident prevention regulations,
-knowledge of the relevant electrical regulations,
-trained in the use and care of appropriate safety equipment,
-capable of recognizing the dangers associated with electricity.
Instructions for installation and connection
-The controls must be disconnected from the electricity supply before carrying out
electrical works. It must be ensured that the electricity supply remains disconnected
during the works.
-Local protective regulations must be complied with.
Regulations and bases for testing
For connecting, programming and servicing, the following regulations must be observed
(the list is not exhaustive).
Electromagnetic compatibility
(radio disturbance, household appliances)
(disturbances in supply system –harmonic currents)
(disturbances in supply system –voltage fluctuations)
(electromagnetic compatibility (EMC) –Part 6-2: Generic standards -
immunity for industrial environments)
(electromagnetic compatibility (EMC) –Part 6-2: Generic standards -
emission standard for residential, commercial and light-industrial environ-
ments)
Dock levellers –safety requirements
(safety of machinery, electrical equipment of machines, part 1: general
requirements)
(safety of machinery, basic concepts, general principles for design. Basic
terminology, methodology)
(household and similar electrical appliances - safety)
