MF DIGITAL PerfectImage Manual de usuario

Print Head Replacement

and Adjustment Guide

for the CD Printer

110488-001 Revision C

Rimage™ is the trademark of the Rimage Corporation.

Perfect Image®is a registered trademark of the Rimage Corporation.

All other trademarks and registered trademarks are the property of their respective owners.

Notice for USA

Federal Communications Commissions (FCC) Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

Additional FCC Statement

Any unauthorized modification to this equipment may result in the revocation by the FCC of the

user’s authority to operate this equipment.

Product Safety Statement

This product is in compliance with UL 1950 3rd Edition.

Notice for Canada

Canadian Department of Communications (DOC) Statement

This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus

specified in the Radio Interference Regulations of the Canadian Department of Communications.

Product Safety Statement

This product is in compliance with CSA C22.2 No.950.

Description

This guide consists of a set of procedures that describes how to replace and adjust the print head

for the CD printers. You should use an anti-static bracelet or another means of grounding

yourself when you are performing these procedures.

Caution:

Serious print head or media damage can result from improperly adjusting the print

head.

Required Tools

The following procedure to replace and adjust the CD printer’s print head requires a CPR print

head replacement kit (210538-001). This kit includes the necessary screwdrivers along with the

print head.

Print Head Replacement

Removing the Print Head

1. Make sure the CD drawer is in the out position. If necessary, power up the printer and

press the Unit Attention button to open the drawer. See Figure 1.

Figure 1

2. Power off the printer, then disconnect the power cord.

3. Remove the top printer cover by lifting the cover up.

4. If the ribbon is present, remove the Take-up roller by pulling back the Take-up shaft

retainer , then lifting up on the Take-up roller. See Figure 2.

Figure 2

1. Place the Take-up roller with the attached ribbon on the table in front of the

printer. See Figure 3.

Figure 3

Note: If no ribbon is present, place a piece of paper on the drawer under the print head to

protect the print head.

6. Using a T10 Torx Screwdriver, remove the four screws located on the sides of the Print

Head cover. See Figure 4.

Figure 4

7. Slide the Print head cover towards the back of the printer, then lift up.

8. Disconnect two printer cables located on top of the print head bycarefully pulling

upward. See Figure 5.

Figure 5

9. While supporting the print head with your hand, use a T10 Torx screwdriver to

remove the screws inside the two access holes. These holes are located at the top

of the print head pivot arm assembly (see Figure 6). The print head is released

from the print head assembly.

Figure 6

10. Remove the print head by sliding it under the print head pivot-arm assembly toward the

front of the printer. See Figure 7.

Figure 7

11. Go to “Installing the Print Head,” on page 7.

Installing the Print Head

This procedure should be done after removing the print head. If you have not removed the print

head, go to Removing the Print Head on page 3.

1. Power down the printer.

2. With the cable connectors facing up and placed toward the back of the printer, slide the

new print head under the print head pivot-arm assembly. See Figure 8.

Figure 8

3. Plug in one cable to the print head, then use the cable and your hand to hold it into

position.

4. Remove the screws from the access holes, then align the Print head holes to the Print

head pivot arm assembly.

5. Replace the two screws through the access holes. See Figure 9.

Figure 9

Caution:

Handle the print head with care to avoid damage to the printing elements. Do NOT

use any objects to prop or position the print head in position.

6. Replace the other printer cable on the print head. See Figure 10.

Figure 10

7. Clean the print head using a cleaning pad with isopropyl. See “Cleaning the Print Head”

in the CD Printer User Guide for more information.

8. If a piece of paper was placed on the drawer, remove it.

9. Carefully replace the print head cover by replacing the four screws on the side of the

cover. See Figure 11.

Figure 11

10. Replace the Take-up roller making sure the ribbon is properly tensioned and no creases

exist. See “Installing Ribbons” in the CD Printer User Guide.

11. Replace the top cover.

12. Go to the “Print Head Test and Adjustment,” page 10.

Print Head Test & Adjustment

Once a new print head is installed or if an old one is not printing correctly, you need to test and

adjust the unit.

Note: This test works best with lacquered discs and ribbon with the part number

201737-006. The print head cover should be removed. If the cover is present, see

steps 1-7 in the “Removing the Print Head ” section in this guide for more

information.

1. If the top cover is present, remove it.

2. Ensure the ribbon is properly tensioned and no creases exist.

3. Power on the printer in “Diagnostics Mode” (hold down the Unit Attention button for at

least eight seconds while turning on the power—this will open the printer drawer). See

Figure 12.

Figure 12

Tabla de contenidos

Otros manuales de Impresora de MF DIGITAL

MF DIGITAL

MF DIGITAL Spectrum 2 Manual de usuario

MF DIGITAL

MF DIGITAL PicoJet 6000 Manual de usuario

MF DIGITAL

MF DIGITAL PicoJet 6000 Manual de usuario

MF DIGITAL

MF DIGITAL Spectrum 2 Manual

MF DIGITAL

MF DIGITAL PicoJet 6000 Manual de usuario

MF DIGITAL

MF DIGITAL PJ-6000 D Manual de usuario

MF DIGITAL

MF DIGITAL Scribe 9600 series Instrucciones de montaje

MF DIGITAL

MF DIGITAL PicoJet 6000 Manual de usuario

MF DIGITAL

MF DIGITAL Scribe EC 3000 Manual de usuario

MF DIGITAL

MF DIGITAL 5000 Platform Series Manual

MF DIGITAL

MF DIGITAL 5906 series Instrucciones de montaje

MF DIGITAL

MF DIGITAL ScribeEC Manual de usuario

MF DIGITAL

MF DIGITAL OptiPrinter Manual de usuario

MF DIGITAL

MF DIGITAL PicoJet 6000 Instrucciones de montaje

MF DIGITAL

MF DIGITAL OptiEC OptiPrinter Manual de instalación y operación

MF DIGITAL

MF DIGITAL Scribe SA series Instrucciones de montaje

MF DIGITAL

MF DIGITAL SCRIBE EC Manual de usuario

MF DIGITAL

MF DIGITAL Signature Pro Manual de usuario

MF DIGITAL

MF DIGITAL SCRIBE EC Manual de usuario

MF DIGITAL

MF DIGITAL PicoJet 6000 Manual de usuario

MF DIGITAL

MF DIGITAL P-55 Manual de usuario

MF DIGITAL

MF DIGITAL SCRIBE EC Manual de usuario

MF DIGITAL

MF DIGITAL Signature IV Manual de usuario

Manuales populares de Impresora de otras marcas

Lexmark

Lexmark 1400 Series Manual

Canon

Canon i70 Series Manual de usuario

Evolis

Evolis Elypso Manual de usuario

Kyocera

Kyocera FS-9530DN Manual de usuario

Canon

Canon LASER SHOT LBP-1210 Manual de usuario

Samsung

Samsung BIXOLON SRP-350plusF Manual de usuario

Canon

Canon PIXMA PRO-1 Series Manual de usuario

Canon

Canon PIXMA G3560 Guía de configuración

Dell

Dell Color Laser Printer 2130cn Manual de usuario

Tektronix

Tektronix Phaser 840 Manual de usuario

Epson

Epson ET-7750 Instrucciones de funcionamiento

Canon

Canon CLBR 460ps Manual de usuario

Eltron

Eltron P210 Guide Manual de usuario

Ricoh

Ricoh MD-P1 Manual de usuario

Epson

Epson SC-F7100 series Manual de usuario

Epson

Epson Stylus C40UX Manual de usuario

Canon

Canon imagePASS-A2 Manual de usuario

Canon

Canon S820D Manual de usuario