Metrodata WC-Serial Manual de usuario

WC-SERIAL USER MANUAL

76-02-103 Rev.C Page 1 of 17

WC-Serial

User Manual

DATE:

19th May 2021

DOCUMENT NO:

76-02-103

REVISION:

PREPARED BY:

Paul Ingram

Metrodata Ltd

Laxton House, Crabtree Office Village

Eversley Way, Egham Surrey, TW20 8RY, UK

Tel +44 1 784 744700

Fax: +44 1 784 744701

E-Mail: [email protected]

WC-SERIAL USER MANUAL

76-02-103 Rev.C Page 2 of 17

METRODATA LTD

No part of this publication may be reproduced, transmitted, transcribed,

stored in a retrieval system, or translated into any language or

computer language, in any form or by any means, electronic,

mechanical, magnetic, optical, chemical, manual or otherwise, without

the prior written permission of

Metrodata Ltd, Laxton House,

Crabtree Office Village, Eversley Way,

Egham, Surrey, TW20 8RY, United Kingdom.

DISCLAIMER

Metrodata Ltd makes no representations or warranties with respect to

the contents hereof and specifically disclaims any implied warranties

or merchantability or fitness for any particular purpose. Further,

Metrodata Ltd reserves the right to revise this publication and to make

changes from time to time in the content hereof without obligation of

Metrodata Ltd to notify any person of such revision or changes.

WC-SERIAL USER MANUAL

76-02-103 Rev.C Page 3 of 17

Document History

10/04/2017 XA Document Created

26/04/2017 A Document Released

18/01/2019 B Minor corrections

19/05/2021 C Minor corrections

WC-SERIAL USER MANUAL

76-02-103 Rev.C Page 4 of 17

1 INTRODUCTION .................................................................................................. 6

1.1 WC-Serial ...................................................................................................... 7

1.2 Safety ............................................................................................................ 7

1.3 Electro Magnetic Compatibility ...................................................................... 7

1.3.1 EN55022 Statement ............................................................................... 8

1.3.2 FCC Declaration .................................................................................... 8

1.4 WEEE Directive ............................................................................................. 8

1.5 RoHS Compliance ......................................................................................... 8

2 INSTALLATION .................................................................................................... 9

2.1 WC-Serial Rear Panel ................................................................................... 9

2.1.1 Mains Power .......................................................................................... 9

2.1.2 DC Power ............................................................................................... 9

2.1.3 User LAN Ports .................................................................................... 10

2.1.4 Multi-Protocol Serial Port ..................................................................... 10

2.1.5 RJ45 Led Indicators ............................................................................. 10

2.1.6 Serial LED’s ......................................................................................... 11

2.1.6.1 Transmit (TX) LED .......................................................................... 11

2.1.6.2 Receive (RX) LED ........................................................................... 11

2.1.7 Power (PWR) LED ............................................................................... 11

2.1.8 Unit Status (OK) LED ........................................................................... 11

2.2 Base Label and Bit Switches ....................................................................... 12

2.2.1 Switch 1, Data Inversion ...................................................................... 13

2.2.2 Switch 2, TX Clock Inversion ............................................................... 13

2.2.3 Switch 3, RX Clock Inversion ............................................................... 13

2.2.4 Switch 4, Link Loss Forwarding ........................................................... 13

2.2.5 Switch 5, Max Frame Size ................................................................... 13

2.2.6 Network Port Configuration .................................................................. 14

WC-SERIAL USER MANUAL

76-02-103 Rev.C Page 5 of 17

2.2.6.1 Switch 5, Duplex ............................................................................. 14

2.2.6.2 Switch 6, Speed .............................................................................. 14

2.2.6.3 Switch 8, Auto Negotiation .............................................................. 14

2.3 Rack mounting ............................................................................................ 15

3 WC-Serial Fault Finding ..................................................................................... 16

3.1 RED LED ON, WAN Fault ........................................................................... 16

3.2 GREEN LED FLASH, LAN Fault ................................................................. 16

3.3 RED LED FLASH, WAN and LAN Fault ...................................................... 16

3.4 YELLOW LED ON, WAN Sync Alarm ......................................................... 17

3.5 YELLOW FLASH, LINK LOSS FORWARDING .......................................... 17

WC-SERIAL USER MANUAL

76-02-103 Rev.C Page 6 of 17

1 INTRODUCTION

The Metrodata WC-Serial is a two port auto sensing 10/100BaseT Ethernet Switch

with a multi-protocol serial uplink. The WC-Serial can be used to extend two LAN

ports across a serial WAN link to a remote site. Each LAN port may be connected

to a single LAN workstation or to a hub or switch supporting multiple workstations.

The exact configuration will depend upon the user’s network design and workload

characteristics.

An example application is shown below, where a remote office with two users is

connected to the head office servers via a BT Kilostream X.21 service.

The WC-Serial Ethernet Switch can switch between local LANs connected to its two

ports, and the unit may thus reduce the need for local LAN hubs and switches. The

Ethernet switch has full wirespeed filtering so that the WAN serial port carries only

traffic destined for the remote WAN-linked site, and an efficient HDLC encapsulation

of packets ensures maximum throughput over the WAN link. There is internal packet

buffering to smooth out bursty traffic. WC-Serial units are used in pairs, one on either

side of a WAN link due to the proprietary encoding of the serial data.

The serial port uses a HD60 connector and is compatible with the Cisco HD60 cable

set to support DTE interfaces at X.21, EIA-530 or V.35.

WC-SERIAL USER MANUAL

76-02-103 Rev.C Page 7 of 17

1.1 WC-Serial

The WC-Serial is a compact unit as shown occupying half a shelf in a traditional

19inch rack. All connectors and LED status indicators are accessible from the rear

of the unit.

1.2 Safety

The WC-Serial must not be connected to cabling which would be required by

BS6701 to equipped with over voltage protection. The following ports on the

FCM5000 are designated SELV ( Safety Extra Low Voltage ) within the scope of

EN41003

Terminal RJ45

LAN Port(s) RJ45 10/100BaseT

These ports must only be connected to SELV ports on other equipment in

accordance with EN60950 clause 2.3

1.3 Electro Magnetic Compatibility

In order to ensure EMC compliance, all signal and data cables must be shielded and

use screened connector shells. The cable screens must be terminated to the

screened connector shell and not connected to any pins of the connector. Failure to

use the correct connectors may compromise EMC compliance.

WC-SERIAL USER MANUAL

76-02-103 Rev.C Page 8 of 17

1.3.1 EN55022 Statement

The WC-Serial is a Class A product. In a domestic environment, this product may

cause radio interference, in which case the user will be required to take adequate

measures.

1.3.2 FCC Declaration

This equipment has been tested and found to comply with the limits of the Class A

digital device, pursuant to Part 15 of the FCC rules. These limits are designed to

provide reasonable protection against harmful interference when the equipment is

operated in a commercial environment. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the

Installation and Operation manual, may cause harmful interference to the radio

communications. Operation of this equipment in a residential area is likely to cause

harmful interference in which case the user will be required to correct the

interference at his own expense.

1.4 WEEE Directive

The WC-Serial is covered by Directive 2002/96/EC ( OJ:L37/24/2003 ) on Waste

Electrical and Electronic Equipment ( WEEE ) Units must therefore not be disposed

of in standard landfill.

1.5 RoHS Compliance

The WC-Serial is compliant with the EU RoHS Directive 2002/95/EC. The RoHS

directive bans the use of six hazardous materials in products placed on the market

after July 1st 2006. The six banned materials are Lead, Mercury, Hexavalent

Chromium, Polybrominated Biphenyls, Polybrominated Diphenyl Ethers and

Cadmium.

The FCM5000 is manufactured using a lead free soldering process and as such is

fully RoHS 6/6 compliant.

WC-SERIAL USER MANUAL

76-02-103 Rev.C Page 9 of 17

2 INSTALLATION

2.1 WC-Serial Rear Panel

The WC-Serial is available with either AC Mains or DC power options.

2.1.1 Mains Power

The WC-Serial has an internal power supply and is supplied via an IEC mains power

socket. The WC-Serial operates over the wide range 100 to 250V AC and draws

less than 6 watts.

2.1.2 DC Power

The WC-Serial is available with an internal DC power supply with two variants

available,

DC -48V ( 36 to 72V DC )

DC 24V ( 7 to 36V DC )

DC powered units have an external earth stud which must be securely connected to

an earth connection to ensure EMC compliance.

WC-SERIAL USER MANUAL

76-02-103 Rev.C Page 10 of 17

2.1.3 User LAN Ports

The WC-Serial has two User LAN ports presented on RJ45 connectors. The two

ports support 10/100BaseT with auto MDI/MDI-X crossover switching. The ports are

configured as a pair using the bit switches on the underside and therefore may be

manually configured with auto negotiation disabled.

The two LAN ports are connected internally via a wirespeed switch and so local

switching is supported.

2.1.4 Multi-Protocol Serial Port

The multi-protocol serial port is presented on a HD60 connector. The pinout is

compatible with Cisco, and as such uses the following conversion cables to present

the required DTE or DCE interfaces

DTE DCE

X.21 CAB-X21-MT CAB-X21-FC

EIA-530 CAB-530-MT CAB-530-FC

V.35 CAB-V35-MT CAB-V35-FC

V.36 (RS449) CAB-449-MT CAB-449-FC

Please note that DCE operating modes have a fixed data rate of 2.048Mbps and are

for lab testing purposes.

2.1.5 RJ45 Led Indicators

Each RJ45 connector has two LED’s, one green and one yellow and these are

combined to show the Link State, Link Activity and Link Speed as shown below:

The Green LED is used as a Link/Activity indicator. If the LED is off there is no link.

If the LED is on the link is up but there is no activity. If the green LED is flashing the

link is up and data is passing.

The Yellow LED is used to indicate port speed.

All LED’s off indicates the link is down.

Tabla de contenidos

Manuales populares de Cambiar de otras marcas

URC

URC Total Control MFS-8 Manual de usuario

Azbil

Azbil HPQ-D11 Manual de usuario

Sony

Sony DFS-900M Manual de usuario

SICK

SICK i17S Manual de usuario

F&F

F&F SZR-277 Manual de usuario

Shure

Shure UAMS/BK Manual de usuario

Dräger

Dräger X-zone Switch Off Manual de usuario

Asco

Asco Joucomatic 349 Series Manual de usuario

BT Mini Hub Manual de usuario

D-Link

D-Link DES-1226G Manual de usuario

Johnson Controls

Johnson Controls FS80-C Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manual de usuario

MicroNet

MicroNet SP1200A Manual de usuario

Ruijie

Ruijie RG-PF2920 Series Manual de instalación y funcionamiento

Altinex

Altinex DA1914SX Manual de usuario

MiLAN

MiLAN MIL-SM2401M Manual de usuario

RJM

RJM MASTERMIND PBC/6X Manual de usuario

Atlas

Atlas MMK-KVM8 Manual de usuario