METREL A 1475 Manual de usuario
3G and Wi-Fi Router
A 1475
Instruction manual
Version 1.1, Code No. 20 752 510
2
Distributor:
METREL d.d.
Ljubljanska cesta 77
1354 Horjul
Slovenia
web site: http://www.metrel.si
e-mail: metre[email protected]
Manufacturer:
HQ JSC Teltonika
Saltoniskiu st. 10c
LT-08105, Vilnius,
Lithuania
Tel: +370 5 212 74 72
Tel: +370 5 265 73 60
Fax: +370 5 276 13 80
web site: http://www.teltonika.lt/
e-mail: i[email protected]
Mark on your equipment certifies that this equipment meets the requirements of the EU
(European Union) concerning safety and interference causing equipment regulations
© 2016 METREL
No part of this publication may be reproduced or utilized in any form or by any means
without permission in writing from METREL.
A 1475 - 3G and Wi-Fi Router Table of contents
3
1Introduction...........................................................................................................4
2Remote Communication over 3G / GPRS network .............................................4
2.1 Router connection............................................................................................4
2.2 Router Setup....................................................................................................6
2.3 Connection status ..........................................................................................10
2.4 Connection check and further steps...............................................................11
3Remote Communication over Wi-Fi network.....................................................11
3.1 Router connection..........................................................................................11
3.2 Router Setup..................................................................................................12
3.3 Connection status ..........................................................................................19
3.4 Connection check and further steps...............................................................19
4Technical Specifications ....................................................................................20
4.1 General specification......................................................................................20
4.2 LAN and Wi-Fi................................................................................................20
4.3 HSUPA/HSDPA/UMTS ..................................................................................21
4.4 GSM/GPRS/EDGE.........................................................................................21
A 1475 - 3G and Wi-Fi Router Introduction
4
1 Introduction
Metrel instruments (MI 2892 Power Master, MI 2885 Master Q4, etc.) can be remotely
accessed through Ethernet communication port.
However on measurement locations where 3G/2G mobile or Wi-Fi communication is
available, this router can be used to establish communication bridge to the instrument.
3G and Wi-Fi Router A 1475, is a high speed Wi-Fi and 3G gateway, for remote access
to the measurement certified and tested by Metrel. In this manual MI 2892 Power
Master is used as example, however other Metrel instruments with Ethernet port are
used in similar way. Two configurations are supported and described:
Instrument remote communication over 3G / GPRS network
Instrument remote communication over Wi-Fi network
For other means of connections and configuration please check RUT 500 instruction
manual, provided by OEM manufacturer Teltonika www.teltonika.lt.
Standard set include:
- 3G/2G RUT 500 Modem
- Ethernet patch cable
- Wi-Fi 5dBi Stub Antenna
- 3G/2G 3dBi antenna
- 12V power supply adapter
2 Remote Communication over 3G / GPRS
network
2.1 Router connection
After you unpack box, follow the steps, documented below, in order to properly connect
the router.
1. Remove back panel and insert SIM card which was given by your Internet
Service Provider (ISP). Correct SIM card orientation is shown in the figure below.
Figure 1: SIM card insertion into router
2. Attach GSM and Wi-Fi antennas.
3. Connect devices, as shown on figure below
oUse Ethernet cable to connect instrument and router
A 1475 - 3G and Wi-Fi Router Remote Communication over 3G / GPRS network
5
oUse Ethernet cable to connect Router with PC. PC will be used to set up
router.
oAlternatively router can be set up over Wi-Fi network, by finding Teltonika
access point on PC. In that case Ethernet connection with PC is not
needed.
Connect instrument
MI 2892
Power
Master
A 1475
Connect antenas
Connect PCby:
- ethernet cable
or
- WiFi connection
(Access Point: Teltronika)
Enteraddress:
http://192.168.1.1
into your internet browser
Connect power adapter
Figure 2: Router 3G connection
4. Power up router, instrument and PC.
On following figures description of router plates can be found.
A 1475 - 3G and Wi-Fi Router Remote Communication over 3G / GPRS network
6
Figure 3: Router front plate
1
Power socket
2,3,4
LAN Ethernet ports
5
WAN Ethernet ports
6
Power LED
7,8,9
LAN LEDs
10
WAN LED
Figure 4: Router back plate
1
GSM main antenna connector
2
Wi-Fi antenna connector
3
GSM auxiliary antenna connector
(unavailable on alternate model)
4
Reset button
5
GSM LED
2.2 Router Setup
Before first use, router should be setup in order to work with 3G network.
1. To connect to the router
- Through Wi-Fi, look up for Access Point Teltonika on your computer, and
connect to it (no password is required).
- through LAN (Ethernet) network, plug Ethernet cable into computer and LAN
Ethernet port marked as “LAN1” on the router.
2. Connect instrument and modem with Ethernet cable. Use Ethernet port marked
as “LAN2”
3. Launch your browser and enter the router IP into the address field:
4. If connection was successful, a login screen will appear:
A 1475 - 3G and Wi-Fi Router Remote Communication over 3G / GPRS network
7
Enter the default password admin01 into the Password field and then click on
Login button.
5. A wizard will start in order to setup router. Change default password with your
own.
6. Set up mobile network parameters, according to the mobile provider
requirements.
A 1475 - 3G and Wi-Fi Router Remote Communication over 3G / GPRS network
8
7. Change LAN setup if necessary, otherwise leave it as is.
8. Set up wireless network if you would like to use router as access point. Don’t
forget to protect it with password and encryption.
A 1475 - 3G and Wi-Fi Router Remote Communication over 3G / GPRS network
9
9. Press Finish button. Router will now apply new settings and restart. Router
should be connected and ready to use afterwards.
A 1475 - 3G and Wi-Fi Router Remote Communication over 3G / GPRS network
10
2.3 Connection status
Modem connection status can be observed under Status Network information menu.
Shows the state of the
Modem (3G / 2G) connection.
Shows the status of instrument
connection. In this example
instrument MI 2892 with serial number
14430002 is connected to the router.
3G/2G modem connection is
used for internet access.
Tabla de contenidos
Manuales populares de Enrutador de red de otras marcas
NETGEAR
NETGEAR FS526T - Switch Manual de usuario
Korenix
Korenix JetNet 5710G Series Manual de usuario
Automated Logic
Automated Logic ZN551 Manual del propietario
Cisco
Cisco ASR 1000 Series Manual del operador
EnGenius
EnGenius ESR-9710 Manual de usuario
Cisco
Cisco 805 Series Instrucciones de funcionamiento y seguridad