Metra Electronics 99-3410 Manual de usuario

5 6

Locate the factory wiring harness in the

dash. Metra recommends using the

proper mating adaptor and making

connections as shown. (Isolate and

individually tape off the ends of any

unused wires to prevent electrical short

circuit).

Re-connect the battery terminal and test the unit

for proper operation. Slide (4) Speed Clips over

the holes in the sub-dash mounting brackets and

mount the head unit/kit assembly with (4) Phillips

Pan-Head Screws supplied.

A) Strip wire ends back ½"

B) Twist ends together

C) Solder

D) Tape

PAGE

APPLICATIONS

CAR

CHEVROLET

Tracker 1998-04..........................................................1

GEO

Metro 1992-94............................................................1

Tracker 1992-97..........................................................1

SUZUKI

Aerio 2003.................................................................. 2

Esteem 1995-03..........................................................2

Sidekick 1992-98........................................................1

Swift 1992-94............................................................. 1

Vitara series 1999-04.................................................1

KIT COMPONENTS

TOOLS REQUIRED

Equalizer

Dummy Plate

(4) #8 x 1" Phillips

Pan-Head Screws

(4) Speed Clips

Cutting tool

Wrench

Phillips screwdriver

Radio Housing

KIT FEATURES

Shaft and

DIN unit

provisions

Equalizer

provisions

99-3410

AW -341GO

DW -3410

INSTALLATION

INSTRUCTIONS

REV. 07-29-09

1-800-221-0932 www.metraonline.com

2-SHAFT HEAD UNITS: Slide the

aftermarket head unit into the kit and

secure with shaft nuts. (see Fig. A)

DIN HEAD UNITS: Cut and remove the

shaft supports. Slide the DIN cage into the

Radio Housing and secure by bending the

metal locking tabs down. Slide the

aftermarket head unit into the cage until

secure. (see Fig. B)

ALL VEHICLES

Fig. A Fig. A

Fig. B Fig. B

IF AN EQUALIZER WILL BE INCLUDED :

Slide the aftermarket equalizer into the back of

the Radio Housing. Using the hardware

included with the equalizer, mount the unit to

the kit. (see Fig. A)

IF AN EQUALIZER WILL NOT BE

INCLUDED: Snap the Equalizer Dummy

Plate into the Radio Housing. (see Fig. B)

KOWER

NOWLEDGE IS

nhance your installation and fabrication skills

by enrolling in the most recognized and respected

mobile electronics school in our industry.

Log onto www.installerinstitute.com

or call 800-354-6782 for more information

and take steps toward a better tomorrow.

Harness:

Antenna Adapter:

WIRING AND ANTENNA CONNECTIONS (Sold Separately)

• Please visit www.metraonline.com for specific interface

applications

• 40-GM10 - GM antenna adapter 88-up

Disconnect the negative battery terminal to

prevent an accidental short circuit. Remove

the climate control knobs. Remove (1)

Phillips screw located above the radio

opening. Unclip the radio trim bezel.

Remove (4) screws from the factory head

unit, slide the unit out and disconnect the

wiring.

Disconnect the negative battery terminal to

prevent an accidental short circuit. Unclip

the dash trim bezel and remove. Remove

(4) Phillips screws securing the factory head

unit and disconnect the wiring.

Cut and remove all mounting tabs on the

Radio Housing EXCEPT tabs "A". The

mounting tabs can be identified by the

stamped letter on the back of each tab. Skip

to the Installation Instructions for ALL

VEHICLES on Page #3.

Cut and remove all mounting tabs on the

Radio Housing EXCEPT tabs "B". The

mounting tabs cab be identified by the

stamped letter on the back of each tab. Skip

to the Installation Instructions for ALL

VEHICLES on Page #3.

Cut and remove all mounting tabs on the

Radio Housing EXCEPT tabs "B". The

mounting tabs cab be identified by the

stamped letter on the back of each tab. Skip

to the Installation Instructions for ALL

VEHICLES on Page #3.

Disconnect the negative battery terminal to

prevent an accidental short circuit. Remove

the climate control knobs. Remove (1)

Phillips screw above and (2) Phillips screws

below the climate controls. Unclip the radio

trim bezel. Remove (4) screws from the

factory head unit, slide the unit out and

disconnect the wiring.

SUZUKI Esteem 1995-03

SUZUKI Aerio 2003

GEO Metro / SUZUKI Swift 1992-94

1 2

Cut and remove all mounting tabs on the Radio Housing

EXCEPT tabs "B". (The mounting tabs can be identified by

the stamped letter on the back of each tab). (see Fig. A). Cut

and remove the (2) side clips on the back side of the radio trim

bezel. (This will provide proper clearance when re-attaching

the bezel after the aftermarket head unit has been installed).

(see Fig. B). Skip to the Installation Instructions for ALL

VEHICLES on Page #3.

CHEVROLET Tracker 1998-04 • GEO Tracker 1992-97

SUZUKI Sidekick 1992-98 / Vitara series 1999-04

Disconnect the negative

battery terminal to prevent an

accidental short circuit.

Remove the cigarette lighter

and climate control knobs.

Remove the ashtray and (1)

screw exposed. Pull out on the

climate control cluster and

remove (2) screws exposed.

Unclip the radio trim bezel.

Remove (4) screws from the

factory head unit, slide the unit

out and disconnect the wiring.

Fig. A

Fig. B

Este manual sirve para los siguientes modelos

Otros manuales de Accesorios para automóviles de Metra Electronics

Metra Electronics

Metra Electronics 99-9326B Manual de usuario

Metra Electronics

Metra Electronics 99-7316 Manual de usuario

Metra Electronics

Metra Electronics 99-4000 Manual de usuario

Metra Electronics

Metra Electronics AW-333GM Manual de usuario

Metra Electronics

Metra Electronics 99-7414 Manual de usuario

Metra Electronics

Metra Electronics 95-3009 Manual de usuario

Metra Electronics

Metra Electronics 95-7953 Manual de usuario

Metra Electronics

Metra Electronics 99-8724B Manual de usuario

Metra Electronics

Metra Electronics 108-TO7HG Manual de usuario

Metra Electronics

Metra Electronics 98-5999 Manual de usuario

Metra Electronics

Metra Electronics 99-5803 Manual de usuario

Metra Electronics

Metra Electronics 99-9001 Manual de usuario

Metra Electronics

Metra Electronics SWC-01 Manual de usuario

Metra Electronics

Metra Electronics 99-7425 Manual de usuario

Metra Electronics

Metra Electronics 99-7524B Manual de usuario

Metra Electronics

Metra Electronics 99-7875 Manual de usuario

Metra Electronics

Metra Electronics HONDA RIDGELINE 99-7870G Manual de usuario

Metra Electronics

Metra Electronics 99-3012G Manual de usuario

Metra Electronics

Metra Electronics 71-5520 Manual de usuario

Metra Electronics

Metra Electronics 98-8999 Manual de usuario

Metra Electronics

Metra Electronics 99-9100 Manual de usuario

Metra Electronics

Metra Electronics 99-7953 Manual de usuario

Metra Electronics

Metra Electronics 99-5816 Manual de usuario

Metra Electronics

Metra Electronics 99-8206 Manual de usuario

Manuales populares de Accesorios para automóviles de otras marcas

James Baroud

James Baroud Odyssey Manual de usuario

Motorola

Motorola i50sx Manual de usuario

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manual de usuario

Feniex

Feniex T3 Manual de usuario

Renault

Renault 77 11 423 180 Manual de usuario

Kia

Kia E8300-4D000 Manual de usuario

Brink

Brink 756843 Manual de usuario

Whispbar

Whispbar K085W Manual de usuario

v.link

v.link CI-VL2-PC-HSD Manual de usuario

Viking

Viking Stack-Rack Guía de configuración rápida

Aries

Aries 203015 Manual de usuario

Choetech

Choetech AT0005 Manual de usuario

ZZ2

ZZ2 ZZAIR-PRO Manual de usuario

Holman

Holman 4A80L Manual de usuario

Thule

Thule 2075 Manual de usuario

Motorola

Motorola T325 Manual de usuario

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guía de instalación

DV8

DV8 FBJL-02 Manual de usuario