Page 2 For technical questions, please call 1-888-866-5797. Item
58184
Specifications
Flow 60 CFM Max. at 90 PSI
Gauge Range 0 PSI - 160 PSI
Max. Pressure 250 PSI
Filtration 40 Microns
Inlet and Outlet Size 3/8" NPT
IMPORTANT SAFETY INFORMATION
1. Do not exceed maximum pressure.
2. If a problem occurs, have the problem corrected
before further use.
Do not use damaged equipment.
3. RISK OF BURSTING! Never connect
to an air source that is capable of
exceeding 250 psi.
Over pressurizing the tool may cause
bursting, abnormal operation, breakage of the tool
or serious injury to persons. Use only clean, dry,
regulated compressed air at the rated pressure
or within the rated pressure range as marked on
the tool. Always verify prior to using the tool that
the air source has been adjusted to the rated air
pressure or within the rated air-pressure range.
4. Do not operate the Compressor in
explosive atmospheres, such as in the
presence of flammable liquids, gases or
dust. Compressor motors produce sparks
which may ignite the dust or fumes.
5. Assemble only according to these instructions.
Improper assembly can create hazards.
6. Wear ANSI-approved safety goggles,
ANSI-approved ear protection, and heavy-
duty work gloves during assembly.
7. Turn off and unplug compressor before
installing any accessory.
8. Keep assembly area clean and well lit.
9. Keep bystanders out of the area during assembly.
10. Do not assemble when tired or when under the
influence of alcohol, drugs or medication.
11. Only use included adapter. Designed
for compressed air use only.
12. Refer to compressor’s instruction manual
before installing any accessory.
13. This product is not a toy. Do not allow
children to play with or near this item.
14. Always dress appropriately for the task at hand
noting loose articles of clothing, jewelry, or hair
can become entangled in moving parts.
15. Do not leave tools connected to the
air supply when not in use.
16. Do not leave the system pressurized or
connected to the air supply when not in use.
17. Use as intended only.
18. Inspect before every use; do not use
if parts are loose or damaged.
19. The warnings, precautions, and instructions
discussed in this manual cannot cover all possible
conditions and situations that may occur with the
given accessory and system the operator attached
it to. It must be understood by the operator that
common sense and caution are factors which cannot
be built into this product, but must be supplied by the
operator.
20. Maintain product labels and nameplates
on the tool. These carry important safety
information. If unreadable or missing, contact
Harbor Freight Tools for a replacement.
SAVE THESE INSTRUCTIONS.
