4
The Picture button lets you look at ictures stored on the SD card in the Pictures folder.
The Settings button lets you change settings for the device.
Charging the device
The Adventurer 2800’s battery can be charged using the included mains charger, car charger or USB
charger when connected to your PC. For the quickest charge we recommend using the mains
charger.
When not in use lease make sure the battery switch is set to off to reserve the ower in the
battery for when you next use the device.
Getting the most from the battery
To get the most from the battery we recommend setting the backlight timeout to either 30 seconds
or 1 minute, de ending on what suits you. These o tions can be changed by ta ing the Settings
button on the main menu when the device is turned on and then selecting Power Save and adjusting
the Backlight Off Time.
Using Memory-Map
Ta the Maps button to launch Memory-Ma
Once Memory-Ma has o ened it will automatically begin looking for a GPS signal. Once a signal has
been acquired the GPS Lock button will become solid. Ta on this lock button and your current
location will be dis layed and locked to the screen. You are now ready to go! As you move the ma
will scroll underneath your osition so you will always know where you are.
You can get further GPS information, such as signal strength and ositional data by ta ing the
Menu button, then the Settings button. On the Settings menu ta GPS and then either Satellites to
dis lay satellite strength information, or Position to dis lay ositional information such as grid
reference, s eed etc.
Connecting the GPS to Memory-Map on your PC
Unlike Pocket PCs or Garmin GPS units the Adventurer 2800 is seen by your PC as a removable drive.
This means in Memory-Ma you do not connect or interact with the device using the o tions under
the GPS menu. Ma s, routes and tracks can be sent to the device using the ste s in the following
sections.
