7 www.iJetColor.com
Product Technical Bulletin
PTB0625 06.23.14
3. After cleaning the Capping Station; wipe the capping lip with a lint free cloth, dampened with distilled water.
This will help insure that the contaminants on the cap are removed, before the cap makes contact with the
printhead.
NOTE: If either of these items show signs of wear or damage they should be replaced. If the Service Station is
more than one year old, depending on monthly volume, it may be worthwhile to replace the entire Service
Station instead of replacing components.
Install:
1. Allow the Printing Platen and Capping Station to dry.
2. Reinstall Printing Platen and Capping Station into Service Station Tray.
TIP: If you are planning to clean the Service Station Tray; don’t re-install this component until you have
completed the Service Station Tray cleaning process.
Cleaning the Service Station Tray
1. If present; remove the Service Station Printed Circuit Board, Wiper Motor Assembly, Printing Platen and Capping
Station from the Tray; as described on the previous pages.
2. Wipe the Tray with a damp, lint-free cloth to remove the major ink buildup. Be careful not to damage/peel-off
the wicking material; from the surface of the Tray.
3. Then rinse the Tray using tap water.
4. Allow the tray to dry.
NOTE: If the Tray shows signs of wear or damage (wicking material torn or coming loose from surface of tray)
the Tray should be replaced. If the Service Station is more than one year old, depending on monthly volume, it
may be worthwhile to replace the entire Service Station instead of replacing components.
5. Reinstall the Service Station Printed Circuit Board, Wiper Motor Assembly, Printing Platen and Capping Station,
into the Tray; as described on the previous pages.
Suggestion for High Volume Users:
For printers that are being used at high volumes (over 200,000 pieces per month), we recommend purchasing a second
service station to reduce down-time for Service Station Maintenance. The new/clean service station can be swapped
with the dirty one. Then the dirty Service Station can be cleaned according to the above instructions and made ready for
the next time Service Station Maintenance is required.
