M. TRIGGER THE SYSTEM
When armed, your vehicle is protected as follows:
1. Light impacts will trigger the warn-away signal.
2. Heavy impacts / Doors open / Hood open / Trunk open / Turning on the ignition key will trigger the
programmed sequence.
The starter disable relay (if installed) prevents the vehicle’s starter from cranking. The siren, horn, parking
lights, and dome light will turn on to alert of an intrusion for 30 seconds. Then it will stop and automatic
reset and re-arm. If the one of sensors or detectors is still active, the alarm system will sound a maximum
of 6 times of 30 seconds cycles.
STOP THE MELODY SOUND ONLY: While triggering the alarm the LCD screen will alert user through
melody sound and flashing trigger icon, press any button on the LCD remote transceiver to stop melody
sound only
NOISE ABATEMENT CIRCUIT: Your system has “Noise Abatement Circuit”. It prevents annoying
repetitive trigger sequences due to faulty door pin switches or environmental condition such as thunder,
jackhammers, airport noise, etc.
Here’s how “Noise Abatement Circuit” works: The alarm triggers five times. Each time the same sensor or
switch is triggering the alarm, the “Noise Abatement Circuit” will interpret this pattern of triggers or false
alarms. After the fifth trigger, “Noise Abatement Circuit” ignores, or by pass, that sensor or switch until the
other sensor or switch is trigger.
“Noise Abatement Circuit” covers doors, hood, and trunk differently: If the alarm is triggered by an open
door for six full cycles (three minutes), the doors will be bypassed until the trigger ceases.
N. ANTI CAR-JACKING
Warning: If you do not need the car jacking function in this alarm system, be sure to set car-jacking
feature “OFF”. The default setting for this system is all car-jacking “OFF”. (See Alarm Feature I –4
Programming).
ACTIVE ANTI CAR JACKING:
1.Press and hold the transmitter and buttons at the same time for 2 seconds while the vehicle’s
ignition is ON. The parking lights will turns on for 1.5 seconds to indicate the system enters the
car-jacking mode.
2. Once the system in car-jacking mode, if you are forced from the vehicle, the system will be trigger when
the door is opened and closed while the ignition is “ON”.
PASSIVE ANTI CAR-JACKING:
1. Turn the ignition switch to “ON” position; the system enters the car-jacking mode.
2. Once the system in car-jacking mode, if you are forced from the vehicle, the system will trigger when the
door is opened and closed while the ignition is “ON”.
TRIGGER THE ANTI CAR-JACKING MODE:
a). 50 seconds after the system has beer triggered. The siren will start chirping for 15 seconds.
b). During this 15 seconds period of chirping, are being alerted to push the valet switch once to turn off
the car-jacking feature. If not, it will enter the second timer car jacking.
c). 65 seconds after the system has been triggered, the siren starts alarming and the parking light starts
flashing.
d). 90 seconds after the system has been triggered:
1. The siren will continue alarming and the parking lights flashing, and
2. The starter disable will activate to prevent the vehicle from starting.
3. It will remain active until the vehicle's battery power is exhausted.
OVERRIDE THE SYSTEM TO TURN OFF ANTI CAR- JACKING:
Turn the ignition switch from OFF to ON, and within 10 seconds push valet switch, the siren will stop and
the system disarmed
Note: If you use password pin code to double protect the vehicle security, you will need to use it to
completely disarm the system.
O. DOME LIGHT CONVENIENCE DELAY & SUPERVISION
The alarm has a unique feature that will turn on your vehicle dome light as following:
