Maxxair MaxxFan 5100 Manual de usuario
Step 1
Remove the old existing roof vent and remove all old roof sealant for a minimum of 2” entirely around the
roof opening.
Place the MaxxFan Roof Receiving Flange into the roof opening and trace a pencil line around it to verify
the clean seal area that will be required. Note that the Roof Receiving Flange must be centered in the roof
opening with the metal clips facing the sides of the vehicle (not facing the front or rear of the vehicle).
MaxxFanTM Installation Instructions
Model 5100 and 5200
MaxxAir – the leader in RV ventilation
From MaxxAir Vent Corporation
NOTE
The MaxxFan installs into a standard RV roof opening of 14 by 14 inches.
To determine if your roof opening is correctly sized simply remove the interior ceiling garnish trim
ring of your existing roof vent and measure the ceiling opening or verify the opening is large enough
by sliding the MaxxFan interior Garnish trim ring into the opening.
Due to the rear exhaust louvers, the MaxxFan requires a roof that is clear of obstructions such as air
conditioners, storage boxes, etc. for at least 8 inches to the rear of the existing standard roof vent
flange outside rear edge.
The MaxxFan is designed for a minimum roof thickness of 1 1/8 inches to maximum of 6 1/2 inches.
If your roof thickness is less than 1 1/8 inches build additional thickness at the ceiling opening using
wood or other suitable material.
The MaxxFan requires a 12 Volt 5 amp service. Confirm that the circuit you intend to use will accom-
modate the additional service load. Use the proper gauge stranded wire for electrical connection.
P/N 10-50201 - Rev. 5/01/04
Patent Pending
Step 2
Apply factory recommended roof sealant to
the area traced with the pencil. Apply roof sealant
carefully so that no gaps are present that may
allow water to enter.
Step 3
Fasten the Roof Receiving Flange to the roof
with the screws provided.
Apply additional roof sealant over the screw
heads and around the edge of the roof flange.
Caution: Remove main vehicle
power before connecting
12 volt power to the MaxxFan!
Step 4
Using the insulated electrical connectors
provided connect the vehicle 12 volt power to the
two MaxxFan power wires located on the driver
side of the MaxxFan.
Note: The MaxxFan black wire identified with a
tag showing (+) must be connected to the
vehicle 12 volt (+) positive supply.
Disconnect main vehicle power
before proceeding!
Step 5
With the MaxxFan open and the exhaust
louvers facing the rear of the vehicle lower the
MaxxFan onto the Roof Receiving Flange.
Make sure the power wire slide to the vehicle
interior and do not become entangled on the
Roof Receiving Flange upward edge.
Step 6
Verify the MaxxFan is fully seated down on the
Roof Receiving Flange and fasten the MaxxFan
to the Roof Receiving Flange using the four 3/4
inch by #10 Stainless Steel screws provided.
This completes the roof top portion of
the installation.
NOTE
After making the 12 volt power connec-
tions you may re-apply vehicle power and
temporarily operate the MaxxFan to verify
proper wire connection. Please note that the
MaxxFan motor only operates when the
MaxxFan is fully opened. Use the Vent Open
Knob and fully raise the MaxxFan vent lid.
Verify that the fan operates in exhaust
when the exhaust switch is selected, if not
then reverse the 12 volt power leads to the
MaxxFan and verify correct operation.
3
6
5
Step 7
The interior Garnish Trim Ring must be
trimmed to fit your particular RV roof thickness.
To accomplish this, measure the distance from
the vehicle ceiling surface to each corner of the
MaxxFan Control Plate.
Most RV roofs have some slope so measuring
each corner is necessary. The Garnish ring
should be cut 1/4 to 1/2 inch longer than the
dimensions measured at each corner.
7
7A - After adding 1/2 inch more, a line is drawn
on the outside of the Garnish Ring at 4 inches.
7B - Connect all four corners with a line at the
required dimension and trim as required.
Step 8
Complete the installation by placing any excess
wiring to the side of the roof opening and sliding
the Garnish Ring into position. Fasten in place
using the four painted flat head screws provided.
For additional information about your
MaxxFan, please read the enclosed
“Information and Operating Guide”.
AB
Congratulations!
You have successfully
completed the installation
of your new MaxxFan.
If there is anything we can
do for you, please visit
our website www.maxxair.com
or call us at:
(800) 780-9893
8
In the picture shown to the left, the installation
measured 3 and 1/2 inches from the ceiling to
the Control Plate.
Visit our website at www.maxxair.com
MaxxAir Vent Corp •5513 W. Sligh Ave •Tampa, FL 33634 •Phone (800) 780-9893 •(813) 882-8282 •Fax (813) 876-2550
MaxxAir Vent Corp. warrants this product to be free of manufacturing defects for a period of two years from
the original date of purchase. This guarantee does not include failure due to accidents, acts of God, misuse
or improper installation. If, during that period of time, your MaxxFan fails to operate properly under normal
conditions, please call us on our toll free line 1-800-780-9893 for instructions. Proof of purchase is required.
Please have your original sales receipt and MaxxFan Serial Number readily available when calling. MaxxAir
will promptly correct the defect by repair or replacement, at its option, without charge for materials or labor.
Unless otherwise authorized by MaxxAir, this warranty does not cover any transportation costs for return of
the product or for reshipment of any repaired or replaced product, or cost associated with the installation,
removal or reinstallation of the product.
We invite your comments and suggestions regarding our products. Any information you supply is for MaxxAir’s
internal use and will not be shared or sold to others.
The Serial number for you MaxxFan is located on the fan control plate under the round insect screen
frame. Rotate the four retaining knobs and remove the screen to view. Do not operate the MaxxFan with
the screen removed
MaxxFanTM Two Year Limited Warranty
Model 5100 and 5200
Este manual sirve para los siguientes modelos
1
Otros manuales de Admirador de Maxxair
Maxxair
Maxxair MAXXFAN DOME 3810 Manual de usuario
Maxxair
Maxxair SKYMAXX LX 97000 Manual
Maxxair
Maxxair Maxxfan Mini 4301M Manual de usuario
Maxxair
Maxxair HVWM 18CD Manual de usuario
Maxxair
Maxxair MAXXFAN 4401K Manual de usuario
Maxxair
Maxxair MAXXFAN Guía
Maxxair
Maxxair MAXXFAN Plus 4000KI Manual de usuario
Maxxair
Maxxair HVPF 22 OSC Manual de usuario
Maxxair
Maxxair SH Series Manual de usuario
Maxxair
Maxxair CX1500 RED Manual de usuario
Maxxair
Maxxair SKYMAXX LX 97000iA Manual
Maxxair
Maxxair CX242DDWT Manual de usuario
Maxxair
Maxxair MAXXFAN Deluxe Series Manual de usuario
Maxxair
Maxxair BF60BDBLKP4 Manual de usuario
Maxxair
Maxxair HVPF16 Instrucciones de instalación
Maxxair
Maxxair HVWM 18CDHUB Manual de usuario
Maxxair
Maxxair MAXXFAN Plus 4500KI Manual de usuario
Maxxair
Maxxair MAXXFAN Plus 4700N Manual de usuario
Maxxair
Maxxair HVWM 18 Manual de usuario
Maxxair
Maxxair SKYMAXX 97500 Manual
