MATSONIC MS9107C Manual de usuario

Preface

This publication, including all photographs, illustrations and software, is protected un-

of the material contained herein, may be reproduced without written consent of the

author.

Version 1.0

Disclaimer

The information in this document is subject to change without notice. The manufactur-

er makes no representations or warranties with respect to the contents hereof and

specifically disclaims any implied warranties of merchantability or fitness for any par-

ticular purpose. The manufacturer reserves the right to revise this publication and to

make changes from time to time in the content hereof without obligation of the manu-

facturer to notify any person of such revision or changes.

Trademark Recognition

Microsoft, MS-DOS and Windows are registered trademarks of Microsoft Corp.

MMX, Pentium, Pentium-II, Pentium-III, Celeron are registered trademarks of Intel

Corporation.

Other product names used in this manual are the properties of their respective owners

and are acknowledged.

Federal Communications Commission (FCC)

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not oc-

cur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

−Reorient or relocate the receiving antenna.

−Increase the separation between the equipment and the receiver.

−Connect the equipment onto an outlet on a circuit different from that to which

the receiver is connected.

−Consult the dealer or an experienced radio/TV technician for help.

Shielded interconnect cables and a shielded AC power cable must be employed with

this equipment to ensure compliance with the pertinent RF emission limits governing

this device. Changes or modifications not expressly approved by the system's manu-

facturer could void the user's authority to operate the equipment.

MS9107C, V1.0

VT8753/October 2001

iii

Declaration of Conformity

This device complies with part 15 of the FCC rules. Operation is subject to the follow-

ing conditions:

−This device may not cause harmful interference, and

−This device must accept any interference received, including interference

that may cause undesired operation.

Canadian Department of Communications

This class B digital apparatus meets all requirements of the Canadian Interference-

causing Equipment Regulations.

Cet appareil numérique de la classe B respecte toutes les exigences du Réglement

sur le matériel brouilieur du Canada.

About the Manual

The manual consists of the following:

Chapter 1

Introducing the Mainboard Describes features of the mainboard,

and provides a shipping checklist.

Go to ⇒page 1

Chapter 2

Installing the Mainboard Describes installation of mainboard

components.

Go to ⇒page 6

Chapter 3

Using BIOS Provides information on using the BIOS

Setup Utility.

Go to ⇒page 23

Chapter 4

Using the Mainboard Software Describes the mainboard software.

Go to ⇒page 48

Preface i

CHAPTER 1 1

Introducing the Mainboard 1

Introduction................................................................................................1

Checklist ....................................................................................................1

Standard Items .................................................................................................1

Features.....................................................................................................2

Choosing a Computer Case.......................................................................3

Mainboard Components.............................................................................4

CHAPTER 2 6

Installing the Mainboard 6

Safety Precautions.....................................................................................6

Quick Guide...............................................................................................6

Installing the Mainboard in a Case.............................................................7

Checking Jumper Settings.........................................................................7

Setting Jumpers................................................................................................7

Checking Jumper Settings................................................................................8

Jumper Settings................................................................................................8

Connecting Case Components ..................................................................9

The Panel Connector........................................................................................9

Installing Hardware ..................................................................................10

Installing the Processor..................................................................................10

Installing Memory Modules...........................................................................13

Installing a Hard Disk Drive/CD-ROM .........................................................14

Installing a Floppy Diskette Drive.................................................................15

Installing Add-on Cards.................................................................................16

Connecting Optional Devices ........................................................................17

Connecting I/O Devices ...........................................................................21

External Connector Color Coding..................................................................22

CHAPTER 3 23

Using BIOS 23

About the Setup Utility..............................................................................23

The Standard Configuration...........................................................................23

Entering the Setup Utility...............................................................................24

Updating the BIOS.........................................................................................24

Using BIOS..............................................................................................25

Standard CMOS Features...............................................................................26

Advanced BIOS Setup Option.......................................................................28

Advanced Chipset Features Option................................................................30

Integrated Peripherals Option ........................................................................34

Power Management Setup Option .................................................................38

PNP/PCI Configuration Option......................................................................43

Frequency/Voltage Control ............................................................................45

Load Fail-Safe Defaults Option.....................................................................46

Load Optimized Defaults Option...................................................................46

Set Password Option......................................................................................46

Save & Exit Setup Option..............................................................................47

Exit Without Saving.......................................................................................47

CHAPTER 4 48

Using the Mainboard Software 48

About the Software CD-ROM...................................................................48

Manual Installation...................................................................................51

Drivers Installation....................................................................................49

Award Flash Memory Utility .........................................................................50

PC-CILLIN....................................................................................................50

MediaRing Talk – Telephony Software..........................................................50

Super Voice – Fax/Modem Software..............................................................50

CD Ghost .......................................................................................................50

Recovery Genius............................................................................................50

Language Genius ...........................................................................................51

PageABC .......................................................................................................51

Introducing the Mainboard

Congratulations on purchasing the MS9107C mainboard. The MS9107C

mainboard is an ATX mainboard that uses a 4-layer printed circuit board and

measures 305 mm x 190 mm. The mainboard features a Socket 478 that ac-

commodates Intel Pentium 4 processors supporting system bus (FSB) speeds

of 400 MHz.

The MS9107C incorporates the VIA VT8753 (V845PRO) Northbridge and

VT8233 Southbridge chipsets which supports the AC 97 audio codec, which

combines support for DDR (Double Data Rate) SDRAM up to 3 GB.

Note: SDRAM provides 800 MBps or 1 GBps data transfer depending on whether

the bus is 100 MHz or 133 MHz. Double Data Rate SDRAM (DDR SDRAM)

doubles the rate to 1.6 GBps or 2.1 GBps by transferring data on both the ris-

ing and falling edges of the clock. DDR SDRAM uses additional power and

ground lines and requires 184-pin DIMM modules rather than the 168-pin

DIMMs used by SDRAM.

Compare the mainboard’s package contents with the following checklist:

Standard Items

•One mainboard

•One diskette drive ribbon cable and bracket

•One IDE drive ribbon cable and bracket

•Retention Module Clamp

•Software support CD

•This user’s manual

Processor The MS9107C mainboard includes a Socket 478 that has the

following features:

•Supports up to a 400 MHz system bus (FSB)

•Accommodates Intel Pentium 4 processors.

Chipset There are VT8753 Northbridge and VT8233 Southbridge in

this chipset in accordance with an innovative and scalable

architecture with proven reliability and performance. A few of

the chipset’s advanced features are:

•An advanced V-Link memory controller architecture that

provides the 266 MB/s bandwidth and performance ne-

cessary for even the most demanding Internet and 3D

graphics

•Support for a 4xAGP interface providing vivid 3D graphics

and video performance

•An ATA 100 interface on the chipset, which helps boost

system performance by providing a high-speed connec-

tion to ATA 100 Hard Disk Drives, delivering maximum

sustained data transfer rates of 100 MB/sec

Additional key features include support for six USB ports, an

AC 97 link for audio and modem, hardware monitoring, and

ACPI/OnNow power management.

Memory The mainboard supports DDR 266 SDRAM. It accommodates

three unbuffered 2.5V 184-pin slots. Each slot supports up to 1

GB with a total maximum capacity of 3 GB.

VGA The MS9107C includes a 4xAGP slot that provides eight times

the bandwidth of the original AGP specification. AGP technol-

ogy provides a direct connection between the graphics sub-

system and the processor so that the graphics do not have to

compete for processor time with other devices on the PCI bus.

AC’ 97 Audio

Codec The AC’ 97 Audio codec is compliant with the AC 97 2.2

specification, and supports 18-bit ADC (Analog Digital Con-

verter) and DAC (Digital Analog Converter) resolution as well

as 18-bit stereo full-duplex codec with independent and vari-

able sampling rates. Further features include support for four

analog line-level stereo inputs.

Expansion

Options MS9107C has five 32-bit PCI slots, an AGP slot, a CNR

(Communications and Networking Riser) slot, and an onboard

PCI LAN interface (optional).

The MS9107C PCI slots are capable of Ultra DMA bus mas-

tering with transfer rates of 33/66/100 MB/sec.

Integrated I/O The mainboard has a full set of I/O ports and connectors:

•Two PS/2 ports for mouse and keyboard

•Two serial port

•One parallel port

•One MIDI/game port

•Four USB ports (two backpanel ports, onboard USB

headers providing two extra ports)

•Audio jacks for microphone, line-in and line-out

BIOS

Firmware This mainboard uses Award BIOS that enables users to con-

figure many system features including the following:

•Power management

•Wake-up alarms

•CPU parameters

•CPU and memory timing

The firmware can also be used to set parameters for different

processor clock speeds.

There are many types of computer cases on the market. The mainboard com-

plies with the specifications for the ATX system case. Some features on the

mainboard are implemented by cabling connectors on the mainboard to indi-

cators and switches on the system case. Ensure that your case supports all

the features required. The mainboard can support one or two floppy diskette

drives and four enhanced IDE drives. Ensure that your case has sufficient

power and space for all the drives that you intend to install.

Most cases have a choice of I/O templates in the rear panel. Make sure that

the I/O template in the case matches the I/O ports installed on the rear edge

of the mainboard.

This mainboard has an ATX form factor of 305 x 190 mm. Choose a case that

accommodates this form factor.

Table of Mainboard Components

Label Component

AGP1 Accelerated Graphics Port

ATX1 Power connector

AUDIO Mic/speaker-out header

BAT1 Three volt realtime clock battery

CASFAN1 Case fan connector 1

CD1 Primary CD-in connector

CD2 Secondary CD-in connector

CNR1 Communications Network Riser (CNR) slot

CPU SOCKET Micro PGA 478-pin socket for Pentium 4 CPUs

CPUFAN1 Cooling fan for CPU

DIMM1 ~ DIMM3 Three 184-pin DIMM sockets

FDD1 Floppy disk drive connector

IDE 1 Primary IDE channel

IDE 2 Secondary IDE channel

JP1 Clear CMOS jumper

JP3 BIOS protect jumper

LAUDIO MIC/speaker-out header

LPANEL Second front panel header

LSJ1 Single color LED header

LUSB1 Connector for front panel USB ports

LUSB2 Connector for front panel USB ports

PANEL Front panel header

PCI1 ~ PCI5 Five 32-bit add-on card slots

SIR Serial infrared cable header

SJI Single-color MSG (message) LED

SMART IO Connector used with media storage devices

USB2 Connector for front panel USB ports

USB3 Connector for front panel USB ports

WOL1 Wake On LAN wakeup connector

WOM1 Wake On Modem wakeup connector

Note: LED1 is usually connected to a light that indicates that the computer is

powered on. Do not install hardware or disconnect power cables while the

LED is on.

This concludes Chapter 1. The next chapter explains how to install the main-

board.

Tabla de contenidos

Otros manuales de Placa madre de MATSONIC

MATSONIC

MATSONIC MS9007C Manual de usuario

MATSONIC

MATSONIC MS9158 Series Manual de usuario

MATSONIC

MATSONIC MS7380SG Manual de usuario

MATSONIC

MATSONIC MS7057CT Manual de usuario

MATSONIC

MATSONIC MS7112C Manual de usuario

MATSONIC

MATSONIC MS7188DSeries Manual de usuario

MATSONIC

MATSONIC MS7192S Manual de usuario

MATSONIC

MATSONIC MS7012D Manual de usuario

MATSONIC

MATSONIC MS7177CT Manual de usuario

MATSONIC

MATSONIC MS7101C Manual de usuario

MATSONIC

MATSONIC MS9118E Series Manual de usuario

MATSONIC

MATSONIC MS7122A Manual de usuario

MATSONIC

MATSONIC MS7167D Manual de usuario

MATSONIC

MATSONIC MS7117C Manual de usuario

MATSONIC

MATSONIC MS7308E Series Manual de usuario

MATSONIC

MATSONIC MS8157E Manual de usuario

MATSONIC

MATSONIC MS7157C Manual de usuario

MATSONIC

MATSONIC MS7191SM Manual de usuario

MATSONIC

MATSONIC MS7177C Manual de usuario

MATSONIC

MATSONIC MS6261 Manual de usuario

MATSONIC

MATSONIC MS8137C Manual de usuario

MATSONIC

MATSONIC MS7080SG Manual de usuario

MATSONIC

MATSONIC MS7381SGM Manual de usuario

MATSONIC

MATSONIC MS7023D Manual de usuario

Manuales populares de Placa madre de otras marcas

DFI

DFI SD170 Manual de usuario

ASROCK

ASROCK ROMED8-2T Manual de usuario

Asus

Asus P2L97A Manual de usuario

Winmate

Winmate IC70 Manual de usuario

Asus

Asus MES-B Manual de usuario

Grantech

Grantech SYS8F377VGGA-3OMN Manual de usuario

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manual de usuario

Gigabyte

Gigabyte GA-9IVDT Manual de usuario

Texas Instruments

Texas Instruments ADS8372EVM Manual de usuario

Commell

Commell MS-C73 Manual de usuario

IBT Technologies

IBT Technologies MB860 Manual de usuario

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manual de usuario

Biostar

Biostar M7VIT Bravo Instrucciones de funcionamiento e instalación

Intel

Intel D33217CK Manual de usuario

Asus

Asus F1A55-M LX PLUS R2.0 Manual de usuario

EPC

EPC EPC9147C Manual de usuario

Asus

Asus EX-B760M-V5 D4 Manual de usuario

EPOX

EPOX MU-8KHA0010 Manual de usuario