Martin RUSH SM 850 Manual de usuario

RUSH SM 850

User Manual

Professional and all affiliated companies disclaim liability for any injury, damage, direct or indirect loss,

consequential or economic loss or any other loss occasioned by the use of, inability to use or reliance

on the information contained in this manual. Martin™, RUSH™, JEM™ and other trademarks

mentioned herein are registered as the property of Harman International Industries.

Martin Professional • Olof Palmes Allé 18 • 8200 Aarhus N •Denmark • www.martin.com

Manual: Revision C

Table of contents

Safety information.............................................................................................4

Introduction .......................................................................................................8

Features at a glance......................................................................................8

Before using the product ...............................................................................8

Fog machine overview......................................................................................9

Physical installation.........................................................................................10

Mounting the fog machine on a truss..........................................................10

Securing with a safety cable........................................................................11

AC power ........................................................................................................11

Remote control................................................................................................12

Wired remote control...................................................................................12

4-channel wireless remote control and receiver..........................................12

Operation ........................................................................................................13

Filling the tank .............................................................................................13

Making fog...................................................................................................13

Maintenance....................................................................................................14

Cleaning ......................................................................................................14

Replacing the primary fuse..........................................................................14

Replacing the wireless remote control battery ............................................15

Service and repairs .....................................................................................15

Troubleshooting ..............................................................................................16

Technical Specifications .................................................................................17

RUSH SM 850TM User Manual

Safety information

WARNING!

Read the safety precautions in this manual before installing,

operating or servicing this product.

The following symbols are used to identify important safety information on the

product and in this manual:

Warning!

Safety hazard.

Risk of severe

injury or death.

Warning!

See user

manual for

important

safety

information.

Warning!

Hazardous

voltage. Risk of

lethal or severe

electric shock.

Warning!

Fire hazard.

Warning!

Hot surfaces.

Burn hazard.

This fog machine is for professional use only and must be

installed by a qualified technician. It is not for household use. It

presents risks of severe injury or death due to fire and burn

hazards, electric shock, falls, and respiratory problems. The fog

produced by the machine is hot enough to cause burns or eye

injury if the safety precautions below are not followed.

Install, operate and service Martin™ products only as directed

in their user manuals, or you may create a safety hazard or

cause damage that is not covered by product warranties.

Follow the safety precautions listed below and observe all

warnings in this manual and printed on the product. Keep this

user manual for future use.

For the latest user documentation and other information for this

and all Martin™ products, please visit the Martin website at

http://www.martin.com

If you have any questions about how to install, operate or

RUSH SM 850TM User Manual

service the fog machine safely, please contact your Martin™

distributor (see www.martin.com/distributors for details) or call

the Martin™ 24-hour service hotline on +45 8740 0000, or in

the USA on 1-888-tech-180.

Respect all locally applicable laws, codes and regulations when

installing, operating or servicing the fog machine.

Protection from electric shock

Do not expose the fog machine to rain or moisture.

Disconnect the fog machine from AC power before carrying out

any installation or maintenance work and when the fog

machine is not in use.

Ensure that the fog machine is electrically connected to ground

(earth).

Use only a source of AC mains power that complies with local

building and electrical codes and has both overload and

ground-fault (earth-fault) protection.

Socket outlets or external power switches used to supply the

fog machine with power must be located near the fog machine

and easily accessible so that the fog machine can easily be

disconnected from power.

Replace defective fuses with ones of the specified type and

rating only.

Disconnect the fog machine from power immediately if the

power plug or any seal, cover, cable, or other component is

damaged, defective, deformed, wet or showing signs of

overheating. Do not reapply power until repairs have been

completed.

Before using the fog machine, check that all power distribution

equipment and cables are in perfect condition and rated for the

electrical requirements of all connected devices.

Protection from burns and fire

Do not operate the fog machine if the ambient temperature (Ta)

exceeds 40° C (104° F).

The surface of the product casing can reach up to 50° C

(122°F) during operation. Avoid contact by persons and

materials. Allow the fog machine to cool for at least 10 minutes

before handling.

RUSH SM 850TM User Manual

Do not touch the fog output nozzle during or after use –it

becomes extremely hot, reaching a temperature of 300° C

(572° F). The nozzle cools slowly and can cause burns for up

to three hours after the machine has been shut down.

The fog produced by the machine is hot enough to cause burns

when it leaves the nozzle, and very hot droplets of fluid escape

occasionally. Keep people and objects at least 1 meter (39

inches) away from the fog output nozzle. Do not install the

machine such that hot droplets can fall on people.

Fog output contains glycol, a flammable alcohol that burns with

an almost invisible blue flame. Do not point fog output at

sources of ignition such as open flames or pyrotechnic effects.

Keep flammable materials well away from the fog machine.

Ensure that there is free and unobstructed airflow around the

fog machine. Provide a minimum clearance of 500 mm (20 in.)

around the fog machine. Keep combustible materials at least 1

m (40 in.) away from the machine.

Do not attempt to bypass thermostatic switches or fuses.

Replace fuses only with ones of the type and rating specified in

this manual for the machine.

Protection from injury

Ensure that any supporting structure and/or hardware used can

hold at least 10 times the weight of all the devices they support.

If suspending from a rigging structure, fasten the fog machine

to a rigging clamp. Do not use safety cables as the primary

means of support.

Do not install the fog machine over areas where people are

present.

This appliance is not intended for use by persons (including

children) with reduced physical sensory or mental capabilities,

or lack of experience and knowledge, unless they have been

given supervision or instruction concerning use of the appliance

by a person responsible for their safety. Children must be

supervised to ensure that they do not play with the appliance.

If the fog machine is installed in a location where it may cause

injury or damage if it falls, install as directed in this manual a

secondary attachment such as a safety cable that will hold the

RUSH SM 850TM User Manual

fog machine if a primary attachment fails. The secondary

attachment must be approved by an official body such as TÜV

as a safety attachment for the weight that it secures, must

comply with EN 60598-2-17 Section 17.6.6 and must be

capable of bearing a static suspended load that is ten times the

weight of the fog machine and all installed accessories.

Fog machines can cause condensation. Do not point the output

at smooth floors. Floors and surfaces may become slippery.

Check these frequently and wipe dry as necessary to avoid any

danger of slipping.

Ensure at least 2 m (6.5 ft.) visibility in areas where fog is being

produced.

Fog fluid contains food-grade glycols in solution but may

present health risks if swallowed. Do not drink it. Store it

securely. If eye contact occurs, rinse with water. If fluid is

swallowed, give water and obtain medical advice.

Block access below the work area and work from a stable

platform whenever installing, servicing, filling, or moving the fog

machine.

In the event of an operating problem, stop using the fog

machine immediately and disconnect it from power. Do not

attempt to use a fog machine that is obviously damaged.

Do not modify the fog machine in any way. Refer any service

operation not described in this manual to a qualified technician.

Protection from breathing problems

A fog machine can operate safely only with the fog fluid it is

designed for. Use only fluid that is approved by Martin™ (see

‘Approved Fluids on page Error! Bookmark not defined.) with

this machine. Other fluids may cause the release of toxic

gases, presenting a severe health hazard. You will also

probably cause damage to the machine that is not covered by

product warranties.

Do not create dense fog in confined or poorly ventilated areas.

Do not expose people with health problems (including allergic

and/or respiratory conditions such as asthma) to fog output.

Do not point fog output directly at a person’s face or at face

height.

RUSH SM 850TM User Manual

Introduction

The RUSH SM 850™is one of several products in a brand new line of

atmospheric effects from Martin™. With its clean industrial design, rugged,

lightweight and compact construction, and market-leading features including

wireless remote control, LED-illuminated fluid container, automatic pump shut-off,

and a convenient carrying handle, the RUSH SM 850 is an ideal companion for

mobile DJs and bands, and effective in small venues.

Congratulations on your purchase of this Martin™fog machine. Details of the full

range of Martin products are available on our website at www.martin.com.

Features at a glance

●850 W heater element

●200 m3(7062 ft3) per minute output

●Electronic fluid sensor

●Easy to fill removable fluid tank

●Wireless and wired remote controls

The RUSH SM 850™is supplied with this user manual, a wired remote control, a

wireless remote control transmitter and receiver, a 1.5 m (5 ft.) power cable (local

power plug not included on some models) and an adjustable mounting bracket.

Before using the product

1. Read ‘Safety information’on page 4 before installing, operating or servicing

the fog machine.

2. Unpack and ensure that there is no transportation damage before using the

fog machine. Do not attempt to operate a damaged fog machine.

3. If the fog machine is not going to be hard-wired to a mains supply, install as

directed in this manual a local power plug (not supplied) on the supplied

power cable as described on page 11.

4. Before operating, ensure that the voltage and frequency of the power supply

match the power requirements of the fog machine.

5. Check the support pages on the Martin Professional website at

www.martin.com for the most recent user documentation and technical

information about the fog machine. Martin™ user manual revisions are

identified by the revision letter at the bottom of the inside cover.

RUSH SM 850TM User Manual

Fog machine overview

mounting bracket

power switch

clamp attachment point

remote control socket

fluid tank

remote control socket

secondary attachment point

AC power socket

fog output nozzle

“No fluid” light

RUSH SM 850TM User Manual

Physical installation

Warning! Read ‘Safety information’ on page 4 before

installing the fog machine.

The fog machine is designed for indoor use only and must be

used in a dry location with adequate ventilation.

Martin™ can supply suitable safety cables and rigging clamps for use with the fog

machine (see ‘Accessories’ on page 19).

Do not suspend the machine immediately over areas with public access.

Ensure that there is at least 500 mm (20 in.) clearance all around the machine

and at least 1 m (40 in.) clearance in front of the output nozzle. Keep combustible

materials at least 1 m (40 in.) away from the machine.

The machine can be tilted up to 45 degrees up or down from horizontal if the tank

is partially filled. Overfilling or steeper tilting may cause fluid leakage.

Mounting the fog machine on a truss

The fog machine can be clamped to a truss or similar rigging

structure and tilted up to 45 degrees from horizontal. When

installing the fog machine with the mounting bracket hanging

vertically down, you can use an open-type clamp such as a

G-clamp. If installing with the mounting bracket in any other

orientation, you must use a half-coupler clamp (see

illustration on right) that completely encircles the truss chord.

To clamp the fog machine to a truss:

1. Install the mounting bracket on the fog machine and secure with both

tightening handles.

2. Check that the rigging structure can support at least 10 times the weight of all

fog machines and other equipment to be installed on it.

3. Block access under the work area.

4. Bolt a rigging clamp securely to the mounting bracket. The bolt used must be

M12, grade 8.8 steel minimum. It must pass through both mounting bracket

legs and be fastened with a self-locking nut.

5. Working from a stable platform, hang the fog machine with its clamp on the

truss and fasten the clamp securely.

6. Secure the fog machine with a safety cable as directed below.

Tabla de contenidos

Otros manuales de Equipo de DJ de Martin

Martin

Martin EFX500 Manual de usuario

Martin

Martin MAC Encore Performance CLD Manual de usuario

Martin

Martin MAC 600 NT Manual de usuario

Martin

Martin RUSH PAR 4 UV Manual de usuario

Martin

Martin Alien 05 Manual de usuario

Martin

Martin RUSH MH 10 Beam FX Manual de usuario

Martin

Martin MAC Axiom Hybrid Manual de usuario

Martin

Martin MAC 575 Krypton Manual de usuario

Martin

Martin JEM Glaciator X-Stream Manual de usuario

Martin

Martin MAC 2000 Profile II Manual

Martin

Martin Mania EF1i Manual de usuario

Martin

Martin THRILL Compact PAR 64 LED Guía de configuración

Martin

Martin Ego X4 Manual de usuario

Martin

Martin ELP WW Manual de usuario

Martin

Martin THRILL Manual de usuario

Martin

Martin Starflash III Manual de usuario

Martin

Martin MAC Aura XB Manual de usuario

Martin

Martin MAC 700 WASH Manual de usuario

Martin

Martin THRILL Multi-FX LED Guía de configuración

Martin

Martin RUSH MH 11 Beam Manual de usuario

Martin

Martin THRILL Compact PAR 64 LED Manual de usuario

Martin

Martin Exterior Projection 500 Manual de usuario

Martin

Martin MAC 2000 Wash XB Manual de usuario

Martin

Martin MX-10 Manual de usuario

Manuales populares de Equipo de DJ de otras marcas

ALPHA LITE

ALPHA LITE ALPHA 1500 Manual del propietario

Chauvet

Chauvet OVATION E-930VW Manual de usuario

Zumtobel

Zumtobel APHRODITE Home Manual de usuario

Snow Masters

Snow Masters Zig Oscillator Manual de usuario

EuroLite

EuroLite 50530554 Manual de usuario

Beamz

Beamz BUV243 Manual de usuario

thomann

thomann Stairville DJ Lase 40-G MK-III Manual de usuario

Eagletone

Eagletone 6 Eyes Flower Manual de usuario

EuroLite

EuroLite FLD-1508 Manual de usuario

Technical Pro

Technical Pro LG8xSEA Manual de usuario

JB Systems

JB Systems Lounge Laser DMX Manual de usuario

Lightmaxx

Lightmaxx Vega Halo 90 Manual de usuario

Elation

Elation FUZE WASH Z350 Manual de usuario

Maverick

Maverick MK3 WASH Manual de usuario

Infinity

Infinity TF-260C7 Fresnel Manual de usuario

Chauvet

Chauvet EVE E-50Z Manual de usuario

Eliminator Lighting

Eliminator Lighting E 138 Manual de usuario

EuroLite

EuroLite Mini Multicolor LED Flashing Light SC Manual de usuario