Important Notice:
In order to better display wireless microphone system performance, please read the manual
carefully before use.
Don’t use the system in above environment
Non-professionals person could not dismantle the system at will.
Vents should not be covered such as newspapers, tablecloths, curtains and so on items
to obstruct ventilation.
Equipment should not be placed on the naked flame sources, such as lighted candles.
Don’t throw waste batteries, please put in the designated recycling bins
System can only work within -10℃-55℃.
Equipment should not be subjected to water or water splash, the equipment should not
be placed on the liquid items such as vase decoration.
Equipment with hazard “S” marked on the terminal is dangerous charged warned that
outside of these terminals connected wires need to be installed by a personnel or use
the thread guide leads or cord.
Characteristics and control functions of receiver
1, Power switch: Power supply on and off. (ON: Power on, the microphone work; OFF: turn
off the power; CHARGE: charging state.)
2, Recharging interface of USB
3, Antenna: Receiving signals from the transmitting microphone. Because customer use
the microphone transmitter in different location, it will cause the receiver antenna 1 and
antenna 2 receives the signal intensity changes, then function with automatic selection
information of the receiver will automatically switch to the reception signal strength channel
connected to the receiving system to ensure the best working condition, effectively
overcome the reception “blind spot” problem.
4, Volume: Output volume control knob, clockwise volume increase, counterclockwise
volume reduced.
5, RF indicated light: When the receiver to receive the signal from wireless transmitter, the
light bright.
Characteristics and control functions of back panel of receiver
1, Refer to below picture, connect with external devices: receiver MIC port connect with
Karaoke power amplifier MIC, MIC A as the left sound channel, MIC B is right channel,
MDING is mixed output.
2, Power supply: 220V/110V, turn on the power switch of receiver, adjust volume.
