Manitowoc CNF201A Manual de usuario
Part Number 000015432 4/18
Countertop Nugget
Ice Machines
CNF201 & CNF202
Technician’s Handbook
Safety Notices
Read these precautions to prevent personal injury:
• Read this manual thoroughly before operating,
installing or performing maintenance on the
equipment. Failure to follow instructions in this
manual can cause property damage, injury or death.
• Routine adjustments and maintenance procedures
outlined in this manual are not covered by the
warranty.
• Proper installation, care and maintenance are essential
for maximum performance and trouble-free operation
of your equipment.
• Visit our website www.manitowocice.com for manual
updates, translations, or contact information for
service agents in your area.
• This equipment contains high voltage electricity and
refrigerant charge. Installation and repairs are to be
performed by properly trained technicians aware of
the dangers of dealing with high voltage electricity
and refrigerant under pressure. The technician
must also be certified in proper refrigerant handling
and servicing procedures. All lockout and tag out
procedures must be followed when working on this
equipment.
• This equipment is intended for indoor use only. Do not
install or operate this equipment in outdoor areas.
As you work on this equipment, be sure to pay close
attention to the safety notices in this handbook.
Disregarding the notices may lead to serious injury and/or
damage to the equipment.
nWarning
Follow these electrical requirements during
installation of this equipment.
• All field wiring must conform to all applicable
codes of the authority having jurisdiction. It is
the responsibility of the end user to provide the
disconnect means to satisfy local codes. Refer to
rating plate for proper voltage.
• This appliance must be grounded.
• This equipment must be positioned so that the plug
is accessible unless other means for disconnection
from the power supply (e.g., circuit breaker or
disconnect switch) is provided.
• Check all wiring connections, including factory
terminals, before operation. Connections can
become loose during shipment and installation.
nWarning
Follow these precautions to prevent personal injury
during installation of this equipment:
• Installation must comply with all applicable
equipment fire and health codes with the authority
having jurisdiction.
• To avoid instability the installation area must be
capable of supporting the combined weight of the
equipment and product. Additionally the equipment
must be level side to side and front to back.
• Ice machines require a deflector when installed on
an ice storage bin. Prior to using a non-OEM ice
storage system with this ice machine, contact the
bin manufacturer to assure their ice deflector is
compatible.
• Remove all removable panels before lifting and
installing and use appropriate safety equipment
during installation and servicing. Two or more
people are required to lift or move this appliance to
prevent tipping and/or injury.
• Do not damage the refrigeration circuit when
installing, maintaining or servicing the unit.
• Connect to a potable water supply only.
• This equipment contains refrigerant charge.
• Installation of the line sets must be performed by
a properly trained and EPA certified refrigeration
technician aware of the dangers of dealing with
refrigerant charged equipment.
nWarning
Follow these precautions to prevent personal injury
while operating or maintaining this equipment.
• Legs or casters must be installed and the legs/casters
must be screwed in completely. When casters
are installed the mass of this unit will allow it to
move uncontrolled on an inclined surface. These
units must be tethered/secured to comply with all
applicable codes. Swivel casters must be mounted
on the front and rigid casters must be mounted on
the rear. Lock the front casters after installation is
complete.
• Some 50 Hz models may contain up to 150 grams
of R290 (propane) refrigerant. R290 (propane)
is flammable in concentrations of air between
approximately 2.1% and 9.5% by volume (LEL lower
explosion limit and UEL upper explosion limit). An
ignition source at a temperature higher than 470°C
is needed for a combustion to occur.
• Refer to nameplate to identify the type of refrigerant
in your equipment.
• Only trained and qualified personnel aware of the
dangers are allowed to work on the equipment.
• Read this manual thoroughly before operating,
installing or performing maintenance on the
equipment. Failure to follow instructions in this
manual can cause property damage, injury or death.
• Crush/Pinch Hazard. Keep hands clear of moving
components. Components can move without
warning unless power is disconnected and all
potential energy is removed.
• Moisture collecting on the floor will create a
slippery surface. Clean up any water on the floor
immediately to prevent a slip hazard.
nWarning
Follow these precautions to prevent personal injury
while operating or maintaining this equipment.
• Objects placed or dropped in the bin can affect
human health and safety. Locate and remove any
objects immediately.
• Never use sharp objects or tools to remove ice or
frost.
• Do not use mechanical devices or other means to
accelerate the defrosting process.
• When using cleaning fluids or chemicals, rubber
gloves and eye protection (and/or face shield) must
be worn.
DANGER
Do not operate equipment that has been misused,
abused, neglected, damaged, or altered/modified
from that of original manufactured specifications.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
concerning use of the appliance by a person
responsible for their safety. Do not allow children to
play with, clean or maintain this appliance without
proper supervision.
nWarning
Follow these precautions to prevent personal injury
during use and maintenance of this equipment:
• It is the responsibility of the equipment owner to
perform a Personal Protective Equipment Hazard
Assessment to ensure adequate protection during
maintenance procedures.
• Do Not Store Or Use Gasoline Or Other Flammable
Vapors Or Liquids In The Vicinity Of This Or Any
Other
• Appliance. Never use flammable oil soaked cloths or
combustible cleaning solutions for cleaning.
• All covers and access panels must be in place and
properly secured when operating this equipment.
• Risk of fire/shock. All minimum clearances must be
maintained. Do not obstruct vents or openings.
• Failure to disconnect power at the main power
supply disconnect could result in serious injury or
death. The power switch DOES NOT disconnect all
incoming power.
• All utility connections and fixtures must be
maintained in accordance with the authority having
jurisdiction.
• Turn off and lockout all utilities (gas, electric, water)
according to approved practices during maintenance
or servicing.
• Units with two power cords must be plugged
into individual branch circuits. During movement,
cleaning or repair it is necessary to unplug both
power cords.
.
Table of Contents
Part Number 000015432 4/18 9
General Information
Model Numbers............................... 13
Model/Serial Number Location ............... 13
Manitowoc Cleaner and Sanitizer............. 13
Legs........................................... 14
Touchless Sensing Option .................... 14
Ice Machine Warranty Information............ 14
Installation
Location of Ice Machine....................... 15
Ice Machine Clearance Requirements......... 16
Ice Machine Heat of Rejection ................ 16
Electrical Service.............................. 17
Circuit Ampacity .......................... 17
Ice Machine Head Section Water
SupplyandDrains ............................ 18
Potable Water Supply...................... 18
Potable Water Inlet Lines .................. 18
Drain Connections ........................ 19
Operation ..................................... 21
Ice Making Sequence of Operation ........... 21
CNF201 - CNF202 Nugget Machines........ 21
Touch Pad Sequence of Operation ......... 23
Water Level Check......................... 23
Sequence of Operation Chart ............. 24
10 Part Number 000015432 4/18
Maintenance
Manitowoc’s Cleaning Technology............ 26
Exterior Cleaning .......................... 27
Preventative Maintenance Procedure ........ 28
Heavily Scaled Cleaning Procedure ........... 31
Cleaning Procedure ........................... 33
Sanitizing Procedure.......................... 35
Component Disassembly for Cleaning and
Sanitizing ..................................... 37
General Information ....................... 37
Cleaning the Condenser ................... 51
Removal from Service/Winterization ......... 52
General ................................... 52
Troubleshooting
SafeGuard Feature ............................ 53
SafeGuards ................................... 55
No Water.................................. 55
No Ice Production ......................... 56
Ice Machine Will Not Run Diagnostics......... 58
Refrigeration Diagnostics..................... 64
Before Beginning Service . . . . . . . . . . . . . . . . . . 64
Installation/Visual Inspection Checklist..... 64
Water System Checklist .................... 65
Ice Production/Quality Check .............. 66
Analyzing Discharge Pressure.............. 67
Analyzing Suction Pressure ................ 69
Este manual sirve para los siguientes modelos
3
Tabla de contenidos
Otros manuales de Máquina de hielo de Manitowoc
Manitowoc
Manitowoc IB Series Guía de inicio rápido
Manitowoc
Manitowoc Q-DUAL Manual de usuario
Manitowoc
Manitowoc GR-0800A Manual de usuario
Manitowoc
Manitowoc I1406 Series Instrucciones de funcionamiento y seguridad
Manitowoc
Manitowoc FEMALE COUPLING KIT K00129 Manual de usuario
Manitowoc
Manitowoc Q 1800 Guía
Manitowoc
Manitowoc J Series Manual de usuario
Manitowoc
Manitowoc QM30 Series Guía
Manitowoc
Manitowoc S3000 Manual de usuario
Manitowoc
Manitowoc Welbilt Indigo NXT QuietQube Manual de usuario
Manitowoc
Manitowoc Q130 series Instrucciones de uso
Manitowoc
Manitowoc STH042 4/16 Manual de usuario
Manitowoc
Manitowoc ADAPTER KIT K00365 Manual de usuario
Manitowoc
Manitowoc RF0244A Manual de usuario
Manitowoc
Manitowoc RF0244 Instrucciones de uso
Manitowoc
Manitowoc S1400M Manual de instrucciones y seguridad
Manitowoc
Manitowoc SM Series Manual de usuario
Manitowoc
Manitowoc EC Serie Manual de instrucciones y seguridad
Manitowoc
Manitowoc CNF Series Manual de usuario
Manitowoc
Manitowoc KH0177 - IB-0620 Manual de usuario
