5. Basic Operation
5.1 Matching of the Input Impedance
Before mounting the modul 5 into your Eurorack you have to match the
modul 5 to the pickup of your turntable.
If your pickup is a MM pickup place the
Jumper (B) to the position marked MM
if your pickup is an MC pickup place
the Jumper to the position marked MC
(as shown).
In the second step you have to set the
applicable impedance of your pickup.
Therefore you have to place two Jumper
(A). Please refer to the technical data
sheet of your pickup concerning the
impedance of your pickup.
All necessary information can also be
found in the chart (C) printed on the rear
side of the modul 5
In most cases your pickup will be a MC pickup that will match the pre-
selected input type (MC) and impedance (47KOhm).
5.2 How to connect your Turntable
Connect your turntable to the RCA Jacks (2). Most turntables also offer an
separate ground cable in addition to the pair of signal cables. The ground
cable is used to ground your turntable correctly to prevent disruptive noises
like 50Hz / 60Hz hum. Please connect the ground cable of your turntable
with the grounding screw (1)
5 modul 5 User Manual
