Magnetek RVS-DN Manual de usuario
RVS-DN Digital Soft Starter
Instruction Manual
Power Control Systems
April 1, 2004
Part Number: 188-10036
© Copyright 2004 Magnetek
RVS-DN, Digital Soft Starter Instruction Manual— 04/01/04
Contents:
Disclaimer of Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ii-iii
Chapter1: Introduction
Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3
Starter Selection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3
Starter Selection When Operating "Inside the Delta". . . . . . . . . . . . . . . . . . . . . . . . . . . 1-5
Maximum Starts Per Hour . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-6
Chapter 2: Installation
Physical Installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3
Enclosures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3
Bypass After Acceleration Option. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3
230/460 Volt Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-4
Chapter 3:Terminals
Terminals . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-3
Chapter 4: Wiring
Control Terminals . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-3
Typical Control Wiring . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-5
Inside the Delta Wiring. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-7
Fan Control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-8
Chapter 5 : Internal Control Layout
Control Module Layout . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-3
Digital Operator Layout . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-4
Dip Switch Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-7
Memory System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-9
RVS-DN, Digital Soft Starter Instruction Manual— 04/01/04
Chapter 6: Features
Start/Stop Features. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-3
Optional Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-7
Motor Protection Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-9
Chapter 7: Parameters
Parameter Flowchart . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-3
Parameters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-6
Chapter 8: Start-Up Procedure
Start-Up Procedure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-3
Start-Up Procedure with Pump Control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-5
Chapter 9: Troubleshooting
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-3
Appendix A: Technical Data/Specifications
Technical Data/Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A-3
Appendix B: Application Drawings
Typical Configuration. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . B-3
Bypass After Acceleration. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . B-4
Reversing with Contactors. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . B-5
Operation from a Generator. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . B-6
Brake Motor. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . B-7
Insulation Test. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . B-8
Appendix C: Dimensional Drawings
Dimensional Drawings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . C-3
RVS-DN, Digital Soft Starter Instruction Manual— 04/01/04
Appendix D: UL/cUL Installation Instructions
Ul/cUL Installation Instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . D-3
Appendix E: Fuse Selection
Fuse Selection Table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . E-3
Appendix F: Overload Trip Time Calculation
Overload Trip Time Calculation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . F-3
RVS-DN, Digital Soft Starter Instruction Manual—4/01/04
i
©2004 MAGNETEK
All rights reserved. This notice applies to all copyrighted materials included with this product,
including, but not limited to, this manual and software embodied within the product. This manual is
intended for the sole use of the persons to whom it was provided, and any unauthorized distribution
of the manual or dispersal of its contents is strictly forbidden. This manual may not be reproduced in
whole or in part by any means whatsoever without the expressed written permission of Magnetek.
DANGER, WARNING, CAUTION and NOTE Statements
DANGER, WARNING, CAUTION, and Note statements are used throughout this manual to
emphasize important and critical information. You must read these statements to help ensure safety
and to prevent product damage. The statements are defined below.
DANGER
DANGER indicates an imminently hazardous situation which, if not avoided, will result in
death or serious injury. This signal word is to be limited to the most extreme situations.
WARNING
WARNING indicates a potentially hazardous situation which, if not avoided, could result in
death or serious injury.
CAUTION
CAUTION indicates a potentially hazardous situation which, if not avoided, could result in
minor or moderate injury. It may also be used to alert against unsafe practices.
NOTE: A NOTE statement is used to notify people of installation, operation, programming,
or maintenance information that is important, but not hazard-related.
RVS-DN, Digital Soft Starter Instruction Manual—4/01/04
ii
Disclaimer of Warranty
Magnetek hereafter referred to as Company, assumes no responsibility for improper installation of a
soft starter by untrained personnel. A soft starter should only be installed by a trained technician who
has read and understand the contents of this manual. Improper programming of a soft starter can lead
to unexpected, undesirable, or unsafe operation or performance of the soft starter. This may result in
damage to equipment or personal injury. Company shall not be liable for economic loss, property
damage, or other consequential damages or physical injury sustained by the purchaser or by any
third party as a result of such programming. Company neither assumes nor authorizes any other
person to assume for Company any other liability in connection with the sale or use of this product.
IMPORTANT
1. Read this manual carefully and follow its instructions before operating equipment.
2. Installation, operation, and maintenance should be in strict accordance with this manual,
national codes and good practice. Installation or operation not performed in strict accordance
with these instructions will void manufacturer’s warranty.
3. Disconnect all power inputs before wiring or servicing the equipment.
4. After installation, verify that no hardware (bolts, washer, etc.) have fallen into the power
section.
WARNING
1. Internal components and printed circuit boards are at main potential when the RVS-DN is
connected to main power. This voltage is extremely dangerous, and may cause death or severe
injury if contacted.
2. The control PCB employs CMOS ICs that are easily damaged by static electricity. Use proper
electrostatic discharge (ESD) procedures when handling the control PCB.
3. When the RVS-DN is connected to main power, even if control power is not connected and the
motor is stopped, full voltage may appear on the RVS-DN’s output terminals.
4. RVS-DN must be grounded to ensure correct operation, safety, and to prevent damage.
5. Power factor capacitors must NOT be connected to the output side of the RVS-DN.
WARNING
Improper installation of a soft starter can lead to unexpected, undesirable, or unsafe operation
or performance of the soft starter.
RVS-DN, Digital Soft Starter Instruction Manual—4/01/04
iii
ATTENTION
1. This product was designed for compliance with IEC 947-4-2 for class A equipment.
2. RVS-DN units rated 8 to 1800 amps are listed under UL508C.
3. RVS-DN units rated 8 to 1400 amps are LR approved. RVS-DN units rated 1800 amps and
larger are designed to meet LR requirements.
RVS-DN, Digital Soft Starter Instruction Manual—4/01/04
iv
chapter1
Introduction
This page intentionally left blank.
Tabla de contenidos
Otros manuales de Controladores de Magnetek
Magnetek
Magnetek IMPULSE G+ Series 3 Manual de usuario
Magnetek
Magnetek HPV 900 Series 2 Manual de usuario
Magnetek
Magnetek IMPULSE G+ Manual de usuario
Magnetek
Magnetek SBN Series Manual de usuario
Magnetek
Magnetek Impulse G+ series 4 Manual de usuario
Magnetek
Magnetek HPV 600 Manual de usuario
Magnetek
Magnetek FLEX EX2 Manual de servicio
Magnetek
Magnetek Impulse G+ series 4 Manual de usuario
Magnetek
Magnetek IMPULSE G Plus Series 4 Manual de usuario
Magnetek
Magnetek GPD 333 Manual de usuario
