Magellan GPS PROMARK X Manual de usuario

630237 B

USER GUIDE

for the

MAGELLAN GPS PROMARK X

and the

MAGELLAN GPS PROMARK X-CM

Magellan Systems Corporation

471 El Camino Real

Santa Clara, California 95050

(408) 615-5100

FAX (408) 615-5200

Rev. B

No part of this User Guide may be reproduced or transmitted in any form

or by any means, electronic or mechanical, including photocopying and

recording, for any purpose other than the purchaser's personal use

without the written permission of Magellan Systems Corporation.

Magellan™, GPS ProMARK X™, and GPS ProMARK X-CM™ are the

trademarks of Magellan Corporation.

630237 B

WARNINGS

A measure of knowledge by the user is required for proper and safe use of the

Magellan GPS ProMARK X™ and GPS ProMARK X-CM™. READ THE

USER GUIDE AND WARRANTY COMPLETELY.

Assess the Accuracy Required

The ProMARK X is generally capable of better than 12 meters (RMS) horizon-

tal accuracy in autonomous operation and better than 3 meters (RMS) horizon-

tal in differential operation — with a little averaging. While this makes it a

remarkable tool for some third-order surveys and for marking and relocating

geographical sites, the product is not intended as a replacement for the

intstrumentation needed for first-order surveys.

Use Good Judgement

This product is an excellent navigation aid, but it does not replace the need for

careful orienteering and good judgement. Never rely solely on one device for

navigating.

Use Care to Avoid Inaccuracies

The Global Position System (GPS) is operated by the U.S. Government, which

is solely responsible for the accuracy and the maintenance of GPS. Certain

conditions can make the system less accurate.

Accuracy can also be affected by poor satellite geometry. WHEN THE ACCU-

RACY WARNING APPEARS ON THE SCREEN, USE THIS DATA WITH

EXTREME CAUTION.

THE GLOBAL POSITION SYSTEM IS A DoD SYSTEM. The government can

make changes to the system that could affect the performance of GPS receiv-

ers.

WARNING

The accuracy of position fixes can be affected by the periodic adjust-

ments to GPS satellites by the U.S. Government and is subject to

changes in accordance with the Department of Defense Civil GPS user

policy and the Federal Radionavigation Plan.

Use Differential Judiciously

While differential and carrier phase can completely remove the effects of

government degradation of the GPS signal (selective availability), this process

assumes identically matched data sets. Prior to using differential or carrier

phase, the user must have a thorough understanding of datums and the theory

behind the differential process.

CONTENTS

Chapter 1 — Introduction

The ProMARK X ......................................................... 1-1

About This Manual .................................................... 1-2

Sample Displays ......................................................... 1-2

Key Representation .................................................... 1-3

Chapter 2 — Getting Started

Introduction .............................................................. 2-1

Batteries .................................................................... 2-1

Loading the Alkaline Batteries ................................. 2-2

Loading the NiCad Battery Pack .............................. 2-3

Battery Operation ................................................... 2-3

Battery Warnings .................................................... 2-3

External Power Operation .......................................... 2-4

The Keys .................................................................... 2-5

Light .......................................................................... 2-6

Entering Data ............................................................ 2-6

ON/OFF ..................................................................... 2-7

Power-On ............................................................... 2-7

Power-Off............................................................... 2-8

Initialization ............................................................... 2-8

Initializing Manually ................................................ 2-9

Self-Initializing ...................................................... 2-11

Orienting the Antenna ............................................. 2-12

The Position (POS) Key ............................................. 2-13

Collecting An Almanac ............................................ 2-14

Taking a Position Fix ............................................. 2-15

The Position Display .............................................. 2-17

Position Fix Updates .............................................. 2-18

Message Displays ..................................................... 2-18

Chapter 3 — SETUP

SETUP ........................................................................ 3-2

Entering an Initial Position ..................................... 3-3

Selecting Mode and Entering Altitude ................... 3-4

Setting the Time .................................................... 3-4

Choosing a Mask Angle ........................................ 3-5

Data Sample Rate .................................................. 3-6

Choosing a Coordinate System ............................. 3-8

Selecting a Map Datum ....................................... 3-11

Choosing an Altitude Reference .......................... 3-12

Altitude Units ...................................................... 3-14

Magnetic Variation Display .................................. 3-14

Distance Units ..................................................... 3-15

Choosing Automatic or Manual Leg Switching

Modes ......................................................... 3-15

Velocity Average ................................................. 3-16

Battery Saver ....................................................... 3-16

Beeper Control .................................................... 3-17

Display Control ................................................... 3-17

Date Order .......................................................... 3-17

Chapter 4 — Auxiliary Functions

Receiver Status .......................................................... 4-2

Satellite Schedule....................................................... 4-3

Satellite Status ........................................................... 4-5

View Data Files .......................................................... 4-6

Data Input/Output ..................................................... 4-6

Waypoint Projection .................................................. 4-9

Erase Waypoints ...................................................... 4-10

Almanac Collect ...................................................... 4-11

Reverse Route .......................................................... 4-11

Memory Stats .......................................................... 4-13

File Maintenance ..................................................... 4-14

Deep Storage .......................................................... 4-15

Product Support ...................................................... 4-16

iii

Chapter 5 — Waypoints, Routes, and Navigation

Waypoint .................................................................. 5-1

Saving Positions as Waypoints ............................... 5-1

Entering Waypoints Manually ................................ 5-2

Viewing Stored Waypoints .................................... 5-3

Renaming Waypoints ............................................ 5-4

Clearing a Waypoint ............................................. 5-5

Saving an Averaged Position as a Waypoint ........... 5-5

Route ........................................................................ 5-6

Choosing a Route Mode ....................................... 5-6

Creating a Route ................................................... 5-6

Activating a Route ................................................. 5-8

Viewing and Editing a Route ................................. 5-8

Appending a Leg ................................................. 5-10

Activating a Route ............................................... 5-10

Reversing a Route ............................................... 5-10

Navigation ............................................................... 5-11

Chapter 6 — Attributes

Attribution ................................................................ 6-1

ATTR Key Operation .................................................. 6-1

Suggestions on Using the ATTR Key ...................... 6-5

Chapter 7 — Differential

DIF Functions ............................................................. 7-1

Averaging ............................................................. 7-1

Secondary Differential ........................................... 7-1

Mobile Differential ................................................ 7-2

RTCM ................................................................... 7-2

DIF Functions Operations ........................................... 7-2

Averaging ............................................................. 7-2

Stationary Differential ........................................... 7-5

Mobile Differential .............................................. 7-12

RTCM ................................................................. 7-18

File Structure ........................................................... 7-17

Chapter 8 — Troubleshooting and Operating Tips

Error and Warning Messages ..................................... 8-1

Operating Problems ................................................... 8-5

Operating Tips ......................................................... 8-10

Unsure of Your Position When Initializing ............ 8-11

Search and Acquisition Errors .............................. 8-11

Initialization Errors ............................................... 8-11

The Signal Environment ....................................... 8-11

Insufficient Number of Satellties .......................... 8-12

Unit Searches Constantly ..................................... 8-13

Accuracy Warning Symbol ................................... 8-13

Signal Quality ...................................................... 8-13

Old Data ............................................................. 8-14

Choosing a Datum .................................................. 8-14

Using the Unit Near the Poles .................................. 8-15

Storing the Unit ....................................................... 8-15

When Nothing Else Works ....................................... 8-15

Magellan's Customer Support ................................. 8-16

Appendix

1 — Global Positioning System .................................. A-1

2 — Differential Theory ............................................. A-5

3 — User-Defined Datum Worksheet ......................... A-9

4 — Table of Constants ........................................... A-11

5 — British, Irish, and UPS Grids .............................. A-21

6 — User-Defined Grid Worksheet........................... A-23

7 — State Plane Coordinate Constants .................... A-25

8 — Waypoint Log, Grid .......................................... A-45

9 — Waypoint Log, Lat/Lon ..................................... A-47

10 — Position Dilution of Precision .......................... A-49

11 — Signal Quality ................................................. A-50

12 — Glossary ......................................................... A-51

Welcome to the world of accurate positioning through the Global Position-

ing System (GPS). This manual was created to serve as a reference guide for

the ProMARK X-CM and the ProMARK X GPS receivers, manufactured by

Magellan Systems Corporation.

The ProMARK X-CM receiver is a 10-channel, SPS receiver that can collect

carrier phase data. The ProMARK X receiver does not have carrier phase

capability. Both models were designed for professional applications. Through-

out the guide, references to the "ProMARK X" will be understood to mean

both models; where information is specific to the ProMARK X-CM, the

receiver is referred to as the "ProMARK X-CM."

This guide assumes that the user has a background specific to the application

for which the receiver is being used. The guide therefore does not describe

applications except where they directly affect the operation of the receiver.

The guide was designed to follow the logical order of the receiver's functions

wherever possible.

Feel free to skip the functions that do not pertain to your applications. Users,

for example, who do not use differential need not read Chapters 6 and 7. All

users, however, should read Chapters 1 through 4, which cover the basic

operation of the receiver and the setup and auxiliary functions. The user who

has no navigation experience may benefit from reading Chapter 5. Those

with no previous experience with global positioning may also want to read

the general information about GPS found in Appendices 6, 7, and 8.

The ProMARK X User Guide should be used in conjunction with the post-

processing software guide and, where applicable, the submeter guide.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de GPS de Magellan

Magellan

Magellan TR5 Manual de usuario

Magellan

Magellan GPS Tracker Manual de usuario

Magellan

Magellan eXplorist GC Manual de usuario

Magellan

Magellan Magellan RoadMate 500 Manual de usuario

Magellan

Magellan RoadMate 3000T - Automotive GPS Receiver Manual de usuario

Magellan

Magellan Blazer12 Manual de usuario

Magellan

Magellan ProMark3 Manual de usuario

Magellan

Magellan Maestro 4220 - Automotive GPS Receiver Manual de usuario

Magellan

Magellan Triton 200 - Hiking GPS Receiver Manual de usuario

Magellan

Magellan MobileMapper MobileMapper 6 Manual de usuario

Magellan

Magellan RoadMate 3000T - Automotive GPS Receiver Manual de usuario

Magellan

Magellan Maestro 3220 - Automotive GPS Receiver Guía de configuración

Magellan

Magellan RoadMate 2240 Manual de instrucciones

Magellan

Magellan eXplorist TRX7 Manual de usuario

Magellan

Magellan RoadMate RV9145T Manual de usuario

Magellan

Magellan eXplorist 400 - Wilderness Bundle Manual de usuario

Magellan

Magellan eXplorist 400 - Wilderness Bundle Manual de usuario

Magellan

Magellan RoadMate 1230 Manual de usuario

Magellan

Magellan RoadMate 1700 - Automotive GPS Receiver Manual de instrucciones

Magellan

Magellan Triton 200 - Hiking GPS Receiver Manual de usuario

Magellan

Magellan eXplorist 200 - Hiking GPS Receiver Manual de usuario

Magellan

Magellan RoadMate 1200 - Automotive GPS Receiver Guía de configuración

Magellan

Magellan RoadMate 860T Manual de usuario

Magellan

Magellan N630 Manual de usuario

Manuales populares de GPS de otras marcas

Raven

Raven Cruizer II Manual

Hama

Hama 53118 Manual de usuario

Garmin

Garmin SOUNDER 125 Manual de usuario

Garmin

Garmin DEZL 580 Manual de usuario

Jigabot

Jigabot EX Manual de usuario

Pointer

Pointer Cellocator CelloTrack XT LTE Guía de instalación

Queclink

Queclink GV55LITE Manual de usuario

Voxson

Voxson Voxtrack GPS500 Manual de instrucciones

Garmin

Garmin ECHOMAP PLUS Manual de usuario

Starcom Systems

Starcom Systems Kylos Compact Manual de usuario

Garmin

Garmin 15 H Series Manual de usuario

Cobra

Cobra Marine MC 600Ci Manual de usuario

Cellocator

Cellocator CelloTrack T Manual de usuario

Enfora

Enfora Mini-MT GSM2228UG001 Manual de usuario

LTE

LTE G50B Manual de usuario

Garmin

Garmin DEZL OTR500 Manual de usuario

SkyGolf

SkyGolf SkyCaddie SG1 Manual de usuario

Garmin

Garmin GPSMAP 78 series Manual de usuario