M-Audio REVOLUTION 5.1 Manual de usuario

REVOLUTION 5.1

USER GUIDE

English

Introduction 2

Revolution 5.1 Features 2

System Requirements 2

Windows®PC®:2

Apple Macintosh®:3

Package Contents 3

Software Installation 4

Windows XP Installation 4

Windows 2000 Installation 6

Windows Me Installation 7

Windows 98SE Installation 9

Mac OS 9 11

Mac OS X 12

Hardware Installation 15

Physical Connections 16

Using the Revolution 5.1’s Inputs and Outputs 17

Line Inputs 17

Mic Input 17

CD/Aux Input 17

Headphone Output Jack 18

Speaker Output Jacks 18

Digital Output Jack 19

Explanation of Surround Formats 19

Revolution 5.1 Control Panel 20

Speaker Setup Tab 21

Output Mixer Tab 23

Surround Sound Tab 24

Input/Other Tab 26

About Tab 28

Revolution 5.1 Applications 28

DVD Playback 28

Music Playback 29

Gaming 29

Recording 29

Troubleshooting & Technical Support 31

Warranty Information 31

Appendix A: Technical Specifications 32

Appendix B: WinDVD v5 Installation 33

Table of Contents

Introduction

Thank you for purchasing the Revolution 5.1 by M-Audio. Revolution 5.1 is the ideal

audio upgrade for any PC or Macintosh computer*, delivering the ultimate in surround

sound performance to your computer system. Revolution 5.1 brings you up to

24-bit/192kHz audio and the highest-quality stereo, virtual surround, and

multi-channel surround sound available today.

Please take the time to read this User Guide. It will tell you how to install Revolution 5.1 on

your particular computer and instruct you on how to get the most from your audio interface.

*Must meet minimum system requirements

Revolution 5.1 Features

Professional-quality 24-bit/192kHz playback on six analog outputs,

24-bit/96kHz stereo recording on either mic, line, or internal CD/Aux inputs with L/R

record level control

Award-winning Control Panel lets you customize your stereo or surround sound

settings, with monitor level control for all inputs, line outputs, and headphone

output

Pro audio playback performance—

Dynamic Range: 109dB (A-weighted); Signal-to-Noise Ratio: -109dB (A-weighted);

THD+N:<0.00185% (-95dB)

Supports Dolby Digital 5.1 (AC-3)®, and DTS®

SRS TruSurround XT™ technology delivers 5.1 virtual surround sound over stereo

speakers, Deep Bass Enhancement and Dialogue Enhancement™

Advanced SRS Circle Surround II™ technology creates multi-channel surround

sound from your stereo MP3s, CDs and other audio

Sensaura™ Game Mode takes your EAX-encoded game and creates a superior

spatialized gaming experience

Supports the following playback sampling frequencies with MME drivers (kHz): 32,

44.1, 48, 88.2, 96, 176.4 and 192

Supports the following output formats: 24-bit Linear PCM; 16-bit Linear PCM; Dolby

Digital (AC-3), Dolby Pro Logic, or DTS

Coaxial (RCA) S/PDIF output jack

One-year warranty

System Requirements

Windows®PC®:

Requires available PCI card slot

Minimum Required — for stereo operation:

Intel Celeron 350MHz or AMD K6II 500MHz

128MB RAM

CD-ROM Drive

Windows 98SE, Me, 2000 (SP4) or XP (SP1)

DirectX 9.0b (included)

Minimum Required— for SRS Circle Surround II operation with Windows 98SE:

Intel Pentium 1GHz or AMD Athlon 1GHz

256MB RAM

CD-ROM Drive

DirectX 9.0b (included)

Recommended:

Intel Pentium III 800MHz or AMD 800MHz

256MB RAM

DVD-ROM drive and decoding player application (included)

Windows XP (SP1)

DirectX 9.0b (included)

Apple Macintosh®:

Requires available PCI card slot

Minimum Required— for stereo operation:

Apple Macintosh® G4*

CD-ROM Drive

Mac OS 9.2.2 or later; Mac OS X version 10.2.6 or later

256 MB RAM

Minimum Required — for multi-channel operation:

Apple Macintosh® G4* 733MHz QS

CD-ROM Drive

Mac OS 9.2.2 or later; Mac OS X version 10.2.6 or later

256 MB RAM

Recommended:

Apple Macintosh® G4* 800MHz QS or better

DVD-ROM Drive

Mac OS X version 10.3 or later (Apple DVD Player required or AC-3 or DTS)

512 MB RAM

* CPU Accelerator Cards not supported

Package Contents

Your Revolution 5.1 card was carefully packed at the factory and the shipping carton

was designed to protect the unit during shipping. Please retain this container in the

unlikely event that you need to return your Revolution 5.1 for service.

The following items are included with your Revolution 5.1:

Revolution 5.1 PCI audio card

M-Audio Software CD-ROM (includes pdf manual, drivers and WinDVD 5)

Quick Start Guide

Software Installation

Your Revolution 5.1 comes with driver software that allows it to communicate with your

computer’s Windows or Macintosh operating system. Please skip to the section on your

computer’s operating system and follow those instructions.

Revolution 5.1’s driver software, which includes SRS Circle Surround II and TruSurround XT,

will load during this installation. You will also want to install the DVD playback software

provided on the included CD-ROM. See Appendix A for WinDVD installation instructions.

Windows XP Installation

1. Power on your computer and place the Revolution 5.1 Drivers CD-ROM in your

computer’s CD-ROM tray. If you’ve not yet installed the Revolution 5.1 PCI card,

you should install the software driver before doing so. If you’ve already installed

the PCI card please skip ahead to step 6. Otherwise, you will see the screen

displayed here. In this case, click “Next” to continue.

2. After you’ve read the license agreement, please click the “I accept...” circle if you

agree to the terms. Then click “Next” to continue.

3. Click Install to Continue.

4. By default, both options for enabling digital CD audio for CD/DVD drive(s) and

DMA mode for CD/DVD drive(s) are checked. We recommend that you leave

these settings enabled as they can improve the performance of capable

devices. You may disable these settings if you know your drives do not support

Digital CD audio or DMA modes. Click “Next” once you have made your

choices, and the installation will continue.

5. Click “Finish” and shut down your computer so you can install your Revolution

5.1 card (don’t forget to unplug the computer before installing the hardware).

6. Once you have finished the hardware installation, restart your system.

Revolution 5.1 and the Windows Sound System (XP)

The Revolution 5.1’s Windows Multimedia drivers will allow you to use the Revolution as

your Windows system sound device. If the Revolution is the only audio device installed

in your computer, then Windows will “select” it automatically. Otherwise, you may need

to tell Windows to use the Revolution. To check your Windows Audio setting and select

the M-Audio Revolution 5.1:

1. Go to the Start menu, and then choose “Control Panel.”

2. Open “Sounds and Audio Devices,” then click the “Audio” tab.

3. Under “Sound Playback,” the default device should say “Revolution.” If it does

not say “Revolution,” then drop down the list of devices and select “Revolution.”

4. Click “Apply,” then click “OK.” Close your Control Panel—you’re done!

Windows 2000 Installation

1. Power on your computer and place the Revolution 5.1 Drivers CD-ROM in your

computer’s CD-ROM tray. If you’ve not yet installed the Revolution 5.1 PCI card,

you should install the software driver before doing so. You will see the screen

displayed here. Click “Next” to continue.

2. Click “Install” to continue.

3. By default, both options for enabling digital CD audio for CD/DVD drive(s) and

DMA mode for CD/DVD drive(s) are checked. We recommend that you leave

these settings enabled as they can improve the performance of capable

devices. You may disable these settings if you know your drives do not support

Digital CD audio or DMA modes. Click “Next” once you have made your

choices, and the installation will continue.”

4. Click “Finish” to complete the driver installation procedure.

Windows Me Installation

1. Power on your computer and place the Revolution 5.1 Drivers CD-ROM in your

computer’s CD-ROM tray. If you’ve not yet installed the Revolution 5.1 PCI card,

you should install the software driver before doing so. You will see the screen

displayed here. Click “Next” to continue.

2. After you’ve read the license agreement, please click the “I accept...” circle if you

agree to the terms. Then click “Next” to continue.

3. Click “Install” to continue.

4. By default, both options for enabling digital CD audio for CD/DVD drive(s) and

DMA mode for CD/DVD drive(s) are checked. We recommend that you leave

these settings enabled as they can improve the performance of capable

devices. You may disable these settings if you know your drives do not support

Digital CD audio or DMA modes. Click “Next” once you have made your

choices, and the installation will continue.

5. Click “Finish” to complete the driver installation procedure.

Note: Upon Restart following hardware installation, you may be prompted

with one or more windows which state that a file being copied is older than

an existing file. We recommend that you choose “No” if asked whether you

want to keep the existing file.

Windows 98SE Installation

1. Power on your computer and place the Revolution 5.1 Drivers CD-ROM in your

computer’s CD-ROM tray. If you’ve not yet installed the Revolution 5.1 PCI card,

you should install the software driver before doing so. You will see the screen

displayed here. Click “Next” to continue.

2. After you’ve read the license agreement, please click the “I accept...” circle if you

agree to the terms. Then click “Next” to continue.

Otros manuales para REVOLUTION 5.1

Tabla de contenidos

Otros manuales de Equipo de grabación de M-Audio

M-Audio

M-Audio Podcast Factory Manual de usuario

M-Audio

M-Audio Code 49 Manual de usuario

M-Audio

M-Audio Pro Tools Manual de usuario

M-Audio

M-Audio USB OMNISTUDIO Manual de usuario

M-Audio

M-Audio Digipatch 12x6 Manual de usuario

M-Audio

M-Audio Podcast Factory Guía del administrador

M-Audio

M-Audio GuitarBox PRO Manual de usuario

M-Audio

M-Audio O2 Manual de usuario

M-Audio

M-Audio OXYGEN 8 Manual de usuario

M-Audio

M-Audio O2 Manual de usuario

M-Audio

M-Audio MicroTrack 24/96 Manual de lista de piezas

M-Audio

M-Audio FireWire 410 Manual de usuario

M-Audio

M-Audio X-Session Pro Manual de usuario

M-Audio

M-Audio MidAir Manual de usuario

M-Audio

M-Audio M-Track Eight Manual de usuario

M-Audio

M-Audio Keystation 88es Manual de usuario

M-Audio

M-Audio Digital Recording Interface Delta 44 Manual de usuario

M-Audio

M-Audio X-Session Pro Manual de usuario

M-Audio

M-Audio MacMan Manual de usuario

M-Audio

M-Audio DELTA 1010-AI Manual de usuario

M-Audio

M-Audio Ozone Manual de usuario

M-Audio

M-Audio USB OMNISTUDIO Manual de usuario

M-Audio

M-Audio MICROTRACK 24 Manual de usuario

M-Audio

M-Audio TDIF-Interface mit 24Bit/96kHz Analog and Digital i/O Delta... Guía de inicio rápido

Manuales populares de Equipo de grabación de otras marcas

KV2 Audio

KV2 Audio 500 Series Manual de usuario

Robotics Technologies

Robotics Technologies microBus-Cam II Manual de usuario

Seca

Seca 460 Manual de usuario

Cognex

Cognex MVS-8000 Series Manual de usuario

Mect

Mect MPNC006 Series Manual de usuario

Bad Caf

Bad Caf THE LEASH Manual de usuario

Strymon

Strymon NIGHTSKY Manual de usuario

Mitsubishi Electric

Mitsubishi Electric 16CH DIGITAL RECORDER DX-TL5000U Manual de usuario

Tews Technologies

Tews Technologies TPMC465 Manual de usuario

Honeywell

Honeywell Excel 50 Manual de usuario

SeaLevel

SeaLevel COMM+8.LPCI Manual de usuario

Arturia

Arturia AUDIOFUSE STUDIO Manual de usuario

Rukra

Rukra RK-1240 Manual de usuario

Samson

Samson SCOM Manual de usuario

Dynacord

Dynacord DPS260 Manual de usuario

Nice

Nice Core Manual de usuario

Pyle Pro

Pyle Pro PSS8 Manual de usuario

RF-System

RF-System TinyGate Manual de uso y cuidado