Lutron Electronics DW-6095 Manual de usuario
SD card real time data recorder
with harmonic measurement
3 PHASE
POWER ANALYZER
Model : DW-6095
Y
our purchase o
f
this 3 PHASE
POWER ANALYZE
R
marks a step
forward for you into
the field o
f
precision
measurement.
A
lthough this
POWER ANALYZE
R
is a complex and
delicate instrument,
its durable structure
will allow many
years of use i
f
proper operating
techniques are
developed. Please
read the following
instructions
carefully and always
keep this manual
within easy reach.
OPERATION MANUAL
Caution Symbol
Caution :
* Risk of electric shock !
* During the measurement,
do not open the cabinet.
Caution :
* Do not apply the overload
voltage, current to the input
terminal !
* Remove test leads before open
the battery cover !
* Cleaning - Only use the dry
cloth to clean the plastic case !
Environment Conditions
* Installation Categories III 600V.
* Pollution Degree 2.
* Altitude up to 2000 meters.
* Indoor use.
* Relative humidity 80% max.
TABLE OF CONTENTS
1. FEATURES................................................................1
2. SPECIFICATIONS.....................................................
.
2
2-1 General Specifications........................................
.
2
2-2 Electrical Specifications.......................................5
3. FRONT PANEL DESCRIPTION.....................................10
4. MEASURING PREPARATION ......................................13
4-1 The original screen.............................................
.
13
4-2 Entry the measurement Screen............................ 13
4-3 The summary description of keyboard.................. 15
4-4 SETUP KEY description........................................ 16
4-5 Setting function description before measuring....... 17
5. MEASURING PROCEDURES .......................................46
5-1 1Φ2W ( one phase by two wires )
measurement..................................................... 46
5-2 1Φ3W ( one phase by three wires )
measurement..................................................... 47
5-3 3Φ3W ( three phase by three wires )
measurement..................................................... 49
5-4 3Φ4W ( three phase by four wires )
measurement..................................................... 50
5-5 The CT and PT measurement...............................52
5-6 ZERO adjustment for Watt Hour...........................53
5-7 Harmonic Function Measurement ........................
.
54
5-8 Graphic Phasor Diagram...................................... 56
5-9 Voltage/Current Waveform..................................
.
58
5-10 Transient Capture ( Dips, Swells, Outage ).......... 60
5-11 Data Logger function.........................................63
5-12 Data Hold function............................................ 65
5-13 Backlight key....................................................
.
66
5-14 A ( Current ) Range key.....................................66
5-15 LOWBAT screen................................................ 67
5-16 Appendix 1.......................................................
.
68
6. MAINTENANCE......................................................... 69
6-1 Cleaning.............................................................69
6-2 Replacement of batteries .................................... 69
7. RS232 PC SERIAL INTERFACE...................................
.
70
8. Download the saving data from the SD card to
the computer ( EXCEL software ) .............................. 72
9. PATENT...................................................................
.
76
10. THE ADDRESS OF AFTER SERVICE CENTER ............
.
77
1. FEATURES
* Analysis for 3 phase multi-power system, 1P/2W, 1P/3W,
3P/3W, 3P/4W.
* 3 current probes ( CP-1201 ) are included, if change the
current probes, the calibration procedures are not
necessary.
* Current probe input signal/ranges with selection :
Input signal (ACV) :
200 mV/300 mV/500 mV/1 V/2 V/3 V.
Ranges (ACA) :
20 A/200 A/2000 A/30 A/300 A/ 3000 A.
* Meter can cooperate the universal current probes.
* Complete set with 4 PCs Test Leads, 4 PCs Alligator clips,
3 PCs Clamp Probe ( CP 1201 ), AC to DC 9V adapter, 2
G SD memory card and Carrying bag.
*Measurement:
V (phase-to-phase), V (phase-to-ground)
A (phase-to-ground)
KW / KVA / KVAR / PF (phase)
KW / KVA / KVAR / PF (system)
KWH / KVAH / KVARH / PFH (system)
Phase angle
* Harmonics display (1-50th order).
* Simultaneous display of Harmonics and Wave form.
* Display of Waveform with Peak Values.
* Analysis of Total Harmonic Distortion ( THD ).
* Graphic Phase diagram with 3-Phase system parameters.
* 3 phase Voltage or Current Unbalanced Ratio ( VUR, AUR )
and Unbalanced Factor.
* Calculated Unbalanced Current through Neutral Line ( An )
* Capture Transient events (including Dip, Swell and
Outage ) with programmable threshold ( % ).
* Programmable CT ratio ( 1 to 600 ) and PT ratio ( 1 to
1000 ).
1
* ACV input impedance is 10 Mega ohms.
* Safety Standard : IEC 1010, CAT III 600V.
* Built-in clock and Calendar, real time data record with SD
memory card , sampling time set from 2 to 7200
seconds. Just slot in the SD card into the computer, it
can down load the all the measured value with the time
information ( year, month, data, hour, minute, second )
to the Excel directly, then user can make the further data
analysis by themselves.
* Powered by AA ( UM-3 ) DC 1.5 V X 8 batteries ( Alkaline
type ) or DC 9V adapter.
* Computer data output, can cooperate with optional USB
Cable/USB-01, RS232 cable/UPCB-02 and Data
Acquisition software, SW-811.
* Optional current probes : CP-1201, CP-2000, CP-200,
CP-3000, detail specification.
* User can order the meter only ( without the current
probes ) with the special request as intend to cooperate
their own current probes.
*Patented.
2. SPECIFICATIONS
2-1 General Specifications:
Circuit Custom one-chip of microprocessor LSI
circuit
Display * LCD Size :
81.4 X 61 mm ( 3.2 X 2.4 inch )
* Dot Matrix LCD (320 X 240 pixels )
with back light.
2
Measurement * V (phase-to-phase)
* V (phase-to-ground)
* A (phase-to-ground)
* KW / KVA / KVAR / PF (phase)
KW / KVA / KVAR / PF (system)
KWH / KVAH / KVARH / PFH (system)
* Power factor
* Phase angle
* Frequency
* Harmonics display.
Wire 1P/2W, 1P/3W, 3P/3W, 3P/4W.
connections
Voltage ranges 10 ACV to 600 ACV, auto range.
Current probe * Current probe input signal volage ( ACV ) :
input signal
200mV/300mV/500mV/1V/2V/3V.
and range * Current probe input current range ( ACA ) :
20 A/200A/2000A (1200 A)/30A/300A/3000A
* Meter can cooperate the universal current probe.
Safety IEC1010 CAT III 600 V.
standard
ACV input 10 Mega ohms.
impedance
Range select ACV Auto range.
ACA Manual range.
Clamp 40 Hz to 1 KHz.
frequency
response
Spec. tested 45 to 65 Hz.
frequency
Over load ACV 720 ACV rms
protection ACA 1300 ACA with clamp probe
* For the Clamp ,CP-1201
Over Indicator * LCD display show " OL ".
* The data save into the SD card will show
" 9999 " or " 999 "( overleap the decimal point ).
3
Under Indicator * LCD display show " UR ".
* The data save into the SD card will show
" 9999 " or " 999 "( overleap the decimal point ).
Data Hold Freeze the display reading.
Data Record SD Card Record.
Sampling Time Approx. 1 second.
Power ON/OFF Manual OFF by push button.
Real time * Real time data logger, saved the data
data logger into SD memory card and down load
the all the measured value with the
time information ( year/month/data/
hour/minute/second ) down load
to the Excel
* Integration time for data logger :
2 seconds to 7200 seconds, the during
of setting step are 2 seconds.
Data Output RS232 computer serial interface :
USB/RS232 * Connect the optional USB cable
* Computer
USB-01 will get the USB plug.
interface
* Connect the optional RS232 cable
UPCB-02 will get the RS232
plug.
Operating 0 to 50 ( 32 to 122 ).℃℉
Temperature
Operating Less than 80% R.H..
Humidity
Power Supply * DC 1.5V, AA ( UM-3 ) Battery X 8 PCs
(Alkaline or heavy-duty battery).
* AC to DC 9V power adapter.
Power * Meter : 270 DCmA.
Consumption * Clamp : 22 DCmA.
Clamp max. 50 mm ( 2.0 inch ) Dia.
conductor Size
* For the Clamp ,CP-1201
4
Weight * Meter : 1010g ( includes batteries )
* Clamp ( includded cable ) : 500g
Dimension
Meter :
225 X 125 X 64 mm
( 8.86 X 4.92 X 2.52 inch )
Clamp :
210 X 64 X 33mm
( 8.3 X 2.5 X 1.3 inch )
Clamp Jaw : 86 mm (3.4 inch)- outside
Accessories * Instruction manual.............. 1 PC
Included *
T
est Leads (TL88-4AT)........ 1 Set (4 PCs)
* Alligator clips (TL88-4AC) 1 Set (4 PCs)
* Clamp Probe ( CP-1201 ).....
.
3 PCs
*
A
C to DC 9V adapter...........
.
1 PC
* SD card ( 2 G )...................
.
1 PC
* Carryin
g
ba
g
....................... 1 PC
Optional * 2000 Amp current probe, CP-2000
Accessories * 200 Amp current probe, CP-200
* Flexible 3000 Amp current probe,
CP-3000
* USB Cable , USB-01
* RS232 cable, UPCB-02
* Data Acquisition software, SW-U811
2-2 Electrical Specifications:
ACV
Range Resolution Accuracy
10.0V to 600.0V 0.1V ± (0.5%+0.5V)
* Phase to neutral line
10.0V to 600.0V
* Phase to phase
5
ACA
Range Resolution Accuracy
20A 0.001A,
< 10 A
± (0.5%+0.1A)
0.01A,
10 A≧
200A 0.01A,
< 100 A
± (0.5%+0.5A)
0.1A,
100 A≧
1200A 0.1A,
< 1000 A
± (0.5%+5A)
1A,
1000 A≧
Power factor
Range Resolution Accuracy
0.00 to 1.00 0.01 ± 0.04
Remark :
* PFH : Long term power factor
* PFΣ:
For 3Φ4W, 3Φ3W
PFΣ= ( PF1 + PF2 + PF3 )/3
For 1Φ3W
PFΣ= ( PF1 + PF2 )/2
Φ( Phase angle )
Range Resolution Accuracy
-180° to 180° 0.1° ± 1°
* ACOS ( PF )
Frequency
Range Resolution Accuracy
45 to 65 Hz 0.1 Hz 0.1 Hz
6
Tabla de contenidos
Otros manuales de Instrumento de medición de Lutron Electronics
Lutron Electronics
Lutron Electronics FORCE GAUGE FG-6005SD Manual de usuario
Lutron Electronics
Lutron Electronics EMF-819 Manual de instalación
Lutron Electronics
Lutron Electronics EM-1910 Manual de usuario
Lutron Electronics
Lutron Electronics AM-4233SD Manual de usuario
Lutron Electronics
Lutron Electronics PCO-350 Manual de usuario
Lutron Electronics
Lutron Electronics DW-6064 Manual de usuario
Lutron Electronics
Lutron Electronics YK-37UVSD Manual de usuario
Lutron Electronics
Lutron Electronics SL-4033SD Manual de usuario
Lutron Electronics
Lutron Electronics DO-5512SD Manual de usuario
Lutron Electronics
Lutron Electronics EM-9300SD Manual de usuario
Lutron Electronics
Lutron Electronics DS-2013SD Manual de usuario
Lutron Electronics
Lutron Electronics DT-2230 Manual de usuario
Lutron Electronics
Lutron Electronics vt-8204 Manual de usuario
Lutron Electronics
Lutron Electronics FR-5105 Manual de usuario
Lutron Electronics
Lutron Electronics PH-321M Manual de usuario
Lutron Electronics
Lutron Electronics SP-8001 Manual de usuario
Lutron Electronics
Lutron Electronics FR-5120 Manual de usuario
Lutron Electronics
Lutron Electronics PWA-301 Manual de usuario
Lutron Electronics
Lutron Electronics HT-305 Manual de usuario
Lutron Electronics
Lutron Electronics MG-3OO2 Manual de usuario
Manuales populares de Instrumento de medición de otras marcas
Endress+Hauser
Endress+Hauser Proline Promag 50 Especificaciones técnicas
Siemens
Siemens SITRANS F Coriolis FCT030 Manual de lista de piezas
KLINGER
KLINGER CMF V Series Manual de usuario
EXFO
EXFO FTB-2 Manual de operación y mantenimiento
Keysight
Keysight M8290A Manual de usuario
ADTEK
ADTEK MW-5 Manual de usuario