Luraco iROBOTICS 5 Manual de usuario
1
2
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic precautions should always be followed, including the following:
Read all instructions before using (this appliance).
WARNING – To reduce the risk of burns, fire, electric shock, or injury to persons:
1. The main power switch is marked with international symbols “O” and “I”. The switch in position “I” means that
system is turned on, and the switch in position “O” means that system is off.
2. An appliance should never be left unattended when plugged in. Unplug from outlet when not in use and before
putting on or taking off parts.
3. Close supervision is necessary when this appliance is used by, on, or near children, invalids, or disabled
persons. Keep children away from extended foot support (or other similar parts).
4. Use this appliance only for its intended use as described in this manual. Do not use attachments not
recommended by the manufacturer.
5. Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped
or damaged, or dropped into water. Return the appliance to a service center for examination and repair.
6. Keep the cord away from heated surfaces.
7. Do not use outdoors.
8. Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
9. To disconnect, turn all controls to the off position, then remove plug from outlet.
10. Connect this appliance to a properly grounded outlet only. See grounding instructions.
11. Do not remove the back cushion and do not play with roller mechanism.
12. Do not remove the bottom seat and do not play with actuators.
13. Keep the cord out of heavy traffic area. To avoid fire hazard NEVER put the cord under rugs or near heat
generating devices.
14. Always unplug the power cord from the electrical outlet immediately after use and before cleaning.
15. Always check the volume before using the headphones.
16. Do not operate any equipment with damaged parts.
17. Any other use not recommended by the manufacturer may cause electrical shock or injury to persons.
18. Do not touch or re-wire the wires connected to the master-box.
19. Do not attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void the
warranty.
After reading this owner’s guide, if you have any questions or comments, please call +1-817-633-1080 or
contact our technical support department at sup[email protected] or visit our website at www.luraco.com
for more information
GROUNDING INSTRUCTIONS
This product must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for
electric current to flow, thus reducing the risk of electric shock. This product is equipped with a cord having an
equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is
properly grounded in accordance with all local codes and ordinances.
DANGER - Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with
a qualified electrician or serviceman if you are in doubt as to whether the product is properly grounded. Do not modify
the plug provided with the product - if it does not fit the outlet; have a proper outlet installed by a qualified electrician.
Followed by either instruction 1) or 2) below:
1. This product is for use on a nominal 120V circuit, and has a grounding plug that looks like the plug illustrated in sketch
A in the Figure pictured. A temporary adapter that looks like the adapter illustrated in sketches B and C may
be used to connect this plug to a 2-pole receptacle as shown in sketch B if a properly grounded outlet is not
available. The temporary adapter should be used only until a properly grounded outlet (sketch A) can be installed
by a qualified electrician. The green colored rigid ear, lug, or the like extending from the adapter must be connected
to a permanent ground such as a properly grounded outlet box cover. Whenever the adapter is used, it must be
held in place by a metal screw.
3
2. This product is for use on a nominal 120V circuit, and has a grounding plug that looks like the plug illustrated
in sketch A in the Figure below. Make sure that the product is connected to an outlet having the same
configuration as the plug. No adapter should be used with this product.
Figure Illustration: Grounding
MEDICAL WARNINGS
Not recommended for the following people
•Pregnant Women
•People with distorted joints, broken bones, skin infection or injury
•Children under 12
If you have a medical issue or concern, please consult your doctor before using the massage chair
Do Not
•Do not allow children to play near the chair especially during operation
•Do not leave mobility impaired or speech impaired people alone in chair
Additional Safety Precautions
•Do not use more than 20 minutes per session
•Do not place or stock this machine near damp places such as swimming pools or bathrooms
•Do not press by force on the massage rollers
•Do not stand on the chair or store heavy items on the chair
•Do not use in the environment which is dusty, greasy or lacking oxygen
•Do not place near steam oven, open fire, or heat
•Wear suitable clothing, do not massage with bare skin
•Do not place directly in the sun
•Do not use electric blanket while using the massage chair
•Do not use outdoors
•Do not use while smoking
•Place this machine horizontally with space over 80cm, enough for full recline mode. Place on level floor.
EMERGENCY STOP
In case of emergency, press the power button to stop the system.
4
DO NOT operate near young children DO NOT move the machine during operation
Space requirement
iRobotics 5 Overall Dimensions
5
NOTE: Do not use this apparatus as a bed or fall asleep in the course of massage. Do not use more than 20 minutes,
the recommended time of use is 20 minutes. Prolonged massaging may cause aches, muscle or nerve issues.
(The preferred total duration of massaging within the day should be 30 minutes total or less).
Caution for User
•This device should not be used until grounded
•For a softer massage, a dry towel can be placed on the chair (never use an electric blanket) (note that a gentle
massage pad is included)
•In the course of normal use, lift the back cushion regularly to check if there is any damage or cracks in the fabric of
cushion part. Please stop using immediately even if there is minor damages, turn off the power cable. Send the
cushion in for repair to avoid possible electric shock.
•Do not move the chair while in use
•Do not place heavy objects on the armrest, foot cushion or back of the chair to avoid turning over the chair or
damage to the chair.
•Do not pull the fabric forcefully or stab it with sharp objects which can result in injury or damage to the chair
•Do not move the chair on wooden floor, carpet or other easily damaged flooring
•Children and pets should not be allowed to play around chair
•Please be sure that no people, pets, or other objects are behind the chair or under the legs before reclining or
lowering the leg massager
•Do not put your hands or head under the chair
•When using the massage chair, ascertain that the footrest is in the lowest position
•Do not use immediately after meals
•Do not sit on the back cushions, armrest, or legs
•Don’t use the massage chair when your body is wet or moist as it can result in electrical shock
•Do not operate with more than one person
•Don’t use when using head ornamentation as it can result in injury
•Do not stumble over electrical wires or connections
Do Not Use the Chair under the Following Conditions
•When the apparatus has been rinsed with water or fails to operate
•Power cable is damaged
•If you feel abnormal or extremely achy during the course of the massage, please stop using the massage chair
immediately and consult a doctor
•Power failure occurs
•When the massage chair malfunctions during the course of operation
•Do not touch the inner parts of the chair as this can cause damage and electrical shock
•Do not dismantle and remove inner parts, or repair the massage chair
•Do not operate during a thunderstorm
Methods of Storage
•Do not dismount the back of the chair
•Keep the massage chair free of dust
•Cover the chair with dust-free cloth to prevent dust from collecting
•Do not store in a hot, humid, damp place or in direct sunlight or heat
•Do not store in an overly cold place
Cleaning Methods
•Before cleaning unplug from electrical source to avoid shock
•Clean the cloth surface with neutral detergent or special mild detergent for cloth
•Dust can be cleaned off with a damp cloth of mild detergent and air dry
•Do not spray pesticide on device
•Specified cleaner can be used on the leather, plastic, and dried with a cloth
•DO NOT use a damp cloth on the electronic components which can cause shock and damage
•The leather covers (headrest, seat cushion, foot cushion) can be removed for cleaning
6
iRoboticsTM 5 Parts
INSTALLATION INSTRUCTION
1. Unpack the chair completely
2. Carefully take out wood brace and then raise the back gently. Fix the back to the locked upright position
Controller
Pillow
Foot Massa
g
er
Mini Tra
y
A
rm Massa
g
e
Casin
g
of Seat Frame
Seat Cushion
Controller Holder
Back Rest
Wood brace
7
3. Under the chair near control box, connect both wire 1 and wire 2 to the male/female connections (Note: They
can only fit in one way) (Fig. 2)
4. Zip up and affix the back pad to the backrest and match the Velcro of leg massager windshield leather and seat
leather Velcro and affix in correct position (Fig. 3 and Fig. 4)
Fig. 2 Fig. 3
5. Connect the air tubes: Assemble by color coded connections, green to green, white to white, red to red.etc.
Be sure that connections are secure using clamps provided, two per connection. (Fig. 5)
Fig. 4 Fig. 5
6. Connect vibration wire. Be sure that it is firmly connected (Fig. 6)
Fig.6
8
7. Place seat cushion in correct position.
8. Installation of arm massage
Restrictions:
a. DO NOT use lubricating grease on shaft when connecting arm airbag assembly to arm rest.
b. DO NOT pierce or touch airbag with needle or sharp object.
c. DO NOT shake arm airbag forcibly or damage may occur.
Assembly:
a. Insert half of the arm massage assembly shaft into slider hole and begin to tighten (Fig. 7)
b. Repeat the same steps on the other side. Both should easily slide for adjustment (Fig. 8)
c. Loosen the hand wheel by turning left; tighten the hand wheel by turning right. The hand wheel can be
removed from the assembly when it is turned left continuously.
Fig. 7 Fig. 8
9. Installation of remote holder and mini-cup tray
a. Remote can be placed on either right or left side. Please take out the three screws for mounting.
Pull back the rubber cap and proceed to screw in remote holder on desired side. Place rubber cap flush
with the chair wall (Fig.9)
b. Insert Remote to remote holder. Note insert from top (Fig.10)
9
Fig. 9 Fig.10
c. Install mini-cup tray on to massage chair using three screws already inserted into support (Fig.11)
Fig. 11
OPERATION AFTER ASSEMBLY
1. Plug the power cord to the machine (Fig.12)
2. Connect the remote to the DB9 port on the back of chair as indicated by back label (Fig. 12)
10
Fig. 12 Fig. 13
3. Turn on the power switch on the back (Switch to I position)
4. Use the remote to choose the massage functions and enjoy the comfortable massage
5. For MP3 music player function, please insert an SD card with MP3 music files to the back of the remote (Fig.13).
SD card is not included.
6. For headphones, please insert the headphones to the audio socket as indicated on the back panel of chair
Placement
There must be enough space around the chair. There is a clearance of 80cm or 31.5 inches from the front of the chair to
the wall, and 60cm or 26.5 inches for the chair backrest
ATTENTION!
Be sure no object is behind chair for reclining.
For a more gentle massage, a gentle massage pad is included. Place the pad as shown in
photo to the massage chair back cushion (Fig.14)
Fig. 14
Gentle Massage Pad
SD Card
Tabla de contenidos
Otros manuales de Masajeador de Luraco
Luraco
Luraco iRobotics 6 Manual de usuario
Luraco
Luraco iROBOTICS 7 PLUS Manual de usuario
Luraco
Luraco LEGEND Series Manual de usuario
Luraco
Luraco iRobotics 7 series Manual de usuario
Luraco
Luraco iRobotics 6 Manual de usuario
Luraco
Luraco iRobotics Manual de usuario
Luraco
Luraco iROBOTICS 9 MAX Series Manual de usuario
Luraco
Luraco SOFY series Manual de usuario
Luraco
Luraco iROBOTICS 9 Series Manual de usuario
Luraco
Luraco iRobotics 7 series Manual de usuario
