BEFORE THE FIRST USE (Continued)
3. Place an espresso cup on the drip plate. Make sure the steam dial is in the “0” position.
4. Connect the supply plug to a wall socket and press the ON/OFF button “ ”toturnthe
appliance on. The power indicator (red) will be illuminated.
5. Press down the pump on/off control button “”, the pump will activate and water will begin to
flow from the portafilter. Once water flows, push the pump on/off control button again to switch
off. The purpose of this step is to pump the water from the tank into the housing heating
chamber. the coffee temperature indicator light (green) will activate
6. Make sure the coffee/steam on/off button “ ” is in the off position (button not depressed so sits
higher) , the appliance will begin preheating until the coffee temperature indicator (green)
illuminates, indicating that the preheating process has completed (note, this will cycle on / off
during use). The temperature gauge will rise and then stabilise after around 30 seconds.
7. Press down the pump on/off control button“ ” again, and water will flow out.
8. After water has dispensed for approximately 1 minute, press the pump control button“”,
once more. Dispose of the water collected in the espresso cup, clean the cup and you can
now start brewing coffee.
Note: There may be a louder noise when pumping the water for the first time, this is normal, as the
appliance is releasing the air in the appliance. After about 20 seconds, the noise will disappear.
PREHEATING
It is recommended to preheat the appliance before making coffee, includingtheportafilter
and cup, so that the coffee flavour will not be influenced by the cold surfaces.
1. Pull out the water tank of the coffee maker. Pour clean water into the tank, ensuring that the
water level should does not exceed the “MAX” mark and is no less than the “MIN”markonthe
side of the tank. When re-inserting the tank, angle forward slightly to allow the extraction tube to
fit into the tank, try to avoid direct pressure / stress onto the extraction tube from the sides of the
tank.
2. Insert the filter into the Portafilter (see previous section), then position the portafilter under
the holder (see Fig.1) and turn it anticlockwise until it is fixed tightly (see Fig.2 and Fig.3).
3. Make sure the steam dial is set to “0” and place an espresso cup on the drip plate.
4. Connect the supply plug to a wall socket and press the ON/OFF button “ ”toturnthe
appliance on. The power indicator (red) will be illuminated.
5. Make sure the coffee/steam on/off button “ ” is in the off position (button not depressed so sits
higher).
6. Press down the pump on/off control button“, wait for a moment and water will begin flowing
out. When water is flowing out, immediately press the pump on/off control button again to
switch off. The purpose of the step is to pump the water from the tank into the housing heating
chamber.
