Our Bluetooth receiver BT-RS232
reads signals from a Bang&Olufsen
BeoRemote One Bluetooth remote control.
The receiver pairs with the BeoRemote One
and sends out the detected Bluetooth signal
as an RS232 command.
The BT-RS232 will work with the TT455-RT-238 HW6.x
and any computer, controller or homeautomation system
capable of communicating RS232C:
19200 bps, no parity, 8 databits, 1 stopbit
This allows our TT455-RT-238 to be triggered by bluetooth
in order to control IR products, relays, tv-stands, etc.
but it also allows home-automation installers to use BT-RS232
to receive Beoremote One Bluetooth commands,
for their optional use, even without having a TT455-RT-238.
LinTronic’s OPEN SOURCE protocol:
http://lintronic.dk/LinTronicProtocol.zip
Simply explained “get started guide” on RS232:
http://lintronic.dk/rs232.pdf
NOTE:
The BT-RS232 works out of the box, no configuration is needed.
Default pairing name is “BT-RS232”. If you buy more than one BT-RS232,
then you can individually rename the BT-RS232 modules, making it easy to swap
between them. If you want to change the pairing name, the BT-RS232 must be
connected to a computer with a terminal program capable of sending a renaming
command on a comport. The LinTronic Configurator is recommended.
The LinTronic Configurator is required for verification of possible firmware updates.
