Linksys WUSB54AGP Manual de usuario

WUSB54AGP

Wireless A/G Portable USB Adapter

User Manual

Rev 0.8

Federal Communication Commission Interference

Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one of the

following measures:

zReorient or relocate the receiving antenna.

zIncrease the separation between the equipment and receiver.

zConnect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

zConsult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate this equipment.

For operation within 5.15 ~ 5.25GHz frequency range, it is restricted to indoor environment, and

the antenna of this device must be integral.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment.

This device complies with FCC RF Exposure limits set forth for an uncontrolled environment,

under 47 CFR 2.1093 paragraph (d)(2).

This transmitter must not be co-located or operating in conjunction with any other

antenna or transmitter.

This equipment has been SAR-evaluated for use in laptops (notebooks) with side slot configuration.

The maximum average SAR (1g) for 802.11b is 0.474W/Kg.

The maximum average SAR (1g) for 802.11g is 0.313W/Kg.

The maximum average SAR (1g) for 802.11a is 0.27W/Kg.

CE Mark Warning

This is a Class B product. In a domestic environment, this product may cause

radio interference, in which case the user may be required to take adequate

measures.

This transmitter must not be co-located or operation in conjunction with any

other antenna or transmitter.

Important

Before using the Product, please carefully read the precautions described below to ensure

proper operation.

zDo not open the case or modify contents of the product. Seek the help of an authorized

professional if some problem occurs with the product.

zThis product and other wireless devices may cause interference on each other and as

result performance of the product may be affected.

zMoving the PC during data transfer may damage the data being transferred.

zMake sure to stop all wireless data transfer prior to removing the product from the PC

in order to avoid damage to transferred data, PC or the product.

zPlease make sure the product will not cause hazards to other local equipment prior to

operating in hospitals, airplanes, etc. or other locations susceptible to interference.

zDo not expose the product to dangerous environment such as fire, chemicals or

explosives, which may damage the product.

zUnplug power and telephone cables from PCs and The product during severe

thunderstorms or lightning.

zAvoid dropping the product or subjecting it to excessive impacts

zAvoid contact of the product with water since this may damage it.

zBecause exposing of the product to high humidity and/or extremely variable

temperatures may deteriorate its performance, avoid as much as possible

operating it under such environments

zTo prevent the risk of losing important data saved in the PC during installation of the

product, it is advisable to backup all important files before installation.

zThis device is limited in CH1 ~ CH11 by specified Firmware controlled in

U.S.A.

Table of Contents

1. Network Implementation Using The product ….......................................................5

2. Before Installation ....................................................................................................6

3. Installing the Wireless A/G Portable USB Adapter ……………….............................7

4. The Client Utility Program ......................................................................................10

1. Network Implementation Using The product

There are two possible types of wireless network configurations using the product:

(1) Infrastructure (wireless network using an Access Point)

Using the Client/Server or Master/Slave concept, an Access Point is used to link a wired

network with wireless clients. Not only can the wireless clients access the wired network

but they can also access each other via the Access Point. Multiple Access Points can

be used in the same infrastructure network in order to extend the wireless network

range or share the workload of handling more wireless clients.

(2) Ad-Hoc (wireless network not using an Access Point)

Since there is no Access Point to act as a link to a wired network, wireless network

nodes can only access each other but cannot access a wired network or the Internet.

2. Before Installation

Package Contents

Unpack and confirm that the following contents (in addition to this User Manual) are

included:

Wireless A/G Portable USB Adapter (1 ea.)

Installation CD (1 ea.)

Quick Installation Guide (1 ea.)

To Prepare Before Installation

Ask your system administrator for the following information, which you may need to input

during installation:

- Your SSID (group name of the wireless network)

- If you are using a fixed IP address: IP address, gateway address, and subnet mask

info.

To use the Wireless A/G Portable USB Adapter, the device must be equipped with an

internal or external USB slot.

You should have the latest drivers and utility software for the product (please visit our

website for the latest drivers and utility software).

3. Installing the Wireless A/G Portable USB Adapter

The following explanation is based on installation of the Wireless A/G Portable USB Adapter

into a PC running the Windows XP operation system. Installation in PCs running Windows

98SE, Me, 2000 or XP may be slightly different than shown here.

3.1. Connect the Wireless A/G Portable USB Adapter into the PC's USB slot. The PC will

automatically detect the Wireless A/G Portable USB Adapter and display the [Found New

Hardware Wizard] window.

3.2. Click on [Cancel] and exit the [Found New Hardware Wizard] window.

3.3. Insert the Installation CD into the PC's CD-ROM drive and run Windows Explorer to locate

the file named "Setup.exe" (if CD-ROM drive is D, then the file is under the directory

D:\Client). Once found, double-click on "Setup.exe" and the following screen will appear.

3.4. Click on [Next] and the utility program will be automatically installed as shown in the

following screen.

3.5. The following screen will appear when installation is completed. Click on [Finish] to

successfully exit the installation process.

4. The Client Utility Program

The following are explanations on how to configure and use the Client Utility program.

How to Use the Utility Program

After completing the above installation and configuration procedures, a new icon as shown

below will automatically appear in the lower right tray bar.

Double-clicking on the icon will display the following [Client Utility] window.

Each of the pages (Network, Profile, Search, Option, Version) presented in the Client Utility

is explained in the following sections.

Tabla de contenidos

Otros manuales de Adaptador de Linksys

Linksys

Linksys WPC55AG Manual de usuario

Linksys

Linksys WUSBF54G Manual de usuario

Linksys

Linksys PAP2-VU Guía

Linksys

Linksys WUSB6300 Manual de usuario

Linksys

Linksys WPC55AG Manual de usuario

Linksys

Linksys WGA54G Manual de usuario

Linksys

Linksys SPA3102 Manual de usuario

Linksys

Linksys EC1000 Instrucciones de funcionamiento originales

Linksys

Linksys WUSB54GC EU Instrucciones de funcionamiento originales

Linksys

Linksys WUSB54G Manual de operación

Linksys

Linksys WPC54GX4 Manual de usuario

Linksys

Linksys WPC600N - Ultra RangePlus Wireless-N PC Card Manual de usuario

Linksys

Linksys Small Business SPA2102 Instrucciones de funcionamiento originales

Linksys

Linksys USB1000 Instrucciones de funcionamiento originales

Linksys

Linksys PAP2-T Manual de usuario

Linksys

Linksys WPC54G EU Manual de usuario

Linksys

Linksys WUSB54GS EU Manual de usuario

Linksys

Linksys WPC51AB Instrucciones de funcionamiento originales

Linksys

Linksys WUSB54AG Instrucciones de funcionamiento originales

Linksys

Linksys USB1000 Manual de operación

Linksys

Linksys PAP2 Manual de usuario

Linksys

Linksys WUSB11 ver. 2.6 Manual de usuario

Linksys

Linksys USBBT100 Manual de operación

Linksys

Linksys PAP2-NA Manual de usuario

Manuales populares de Adaptador de otras marcas

PCB Piezotronics

PCB Piezotronics 090B274 Manual de usuario

Auvidea

Auvidea J20 Manual del producto

Gossen MetraWatt

Gossen MetraWatt AT3-III E Manual de usuario

Akribis

Akribis ITF-21-BISS-MIT Manual de usuario

Tenda

Tenda W54U Manual de usuario

ROHO

ROHO AGILITY Manual de usuario

PROLiNK

PROLiNK WN2001 Manual de usuario

Hawking

Hawking HUF2 Manual de usuario

Airlink101

Airlink101 AWLC4030 Manual de usuario

NETGEAR

NETGEAR XAV101v1 - Powerline AV Ethernet Adapter Manual de usuario

Philips

Philips SWA4554S/10 Manual de usuario

JVC

JVC TS-C9D2B Manual de instrucciones

NETGEAR

NETGEAR A6100 Manual de usuario

D-Link

D-Link DWA-121 Manual de usuario

Philips

Philips SWA2037 Manual de usuario

Basalte

Basalte 0610-20 Manual de usuario

Yealink

Yealink EHS40 Manual de usuario

Balluff

Balluff BIC 1B0-IT1A7-Q40KFU-SM4A4A Manual de usuario