Linksys PAP2 Guía
Model No.
PAP2 Ver. 2
with 2 Ports for Voice-over-IP
Phone Adapter
Installation and Troubleshooting Guide
Voice
Phone Adapter with 2 Ports for Voice-over-IP
Copyright and Trademarks
Specifications are subject to change without notice. Linksys is a registered trademark or trademark of Cisco Systems,
Inc. and/or its affiliates in the U.S. and certain other countries. Copyright © 2006 Cisco Systems, Inc. All rights
reserved. Other brands and product names are trademarks or registered trademarks of their respective holders.
How to Use this Guide
Your guide to the Phone Adapter has been designed to make understanding networking with the Phone Adapter
easier than ever. Look for the following items when reading this User Guide:
In addition to these symbols, there are definitions for technical terms that are presented like this:
Also, each figure (diagram, screenshot, or other image) is provided with a figure number and description, like
this:
Figure numbers and descriptions can also be found in the “List of Figures” section.
This exclamation point means there is a caution or warning and is
something that could damage your property or Phone Adapter.
This question mark provides you with a reminder about something you
might need to do while using the Phone Adapter.
This checkmark means there is a note of interest and is something you
should pay special attention to while using the Phone Adapter.
word: definition.
Figure 0-1: Sample Figure Description
PAP2_V2-UG-60421NC JL
WARNING: This product contains chemicals, including lead, known to the State of California to cause
cancer, and birth defects or other reproductive harm. Wash hands after handling.
Phone Adapter with 2 Ports for Voice-over-IP
Phone Adapter with 2 Ports for Voice-over-IP
Table of Contents
Chapter 1: Introduction 1
Welcome 1
What’s in this Guide? 1
Chapter 2: Getting to Know the Phone Adapter 3
Back Panel Ports 3
The Front Panel 4
Chapter 3: Connecting the Phone Adapter 5
Overview 5
Instructions for Connecting the Phone Adapter 5
Placement Options 7
Chapter 4: Using the Phone Adapter’s Interactive Voice Response Menu 9
Overview 9
Accessing the Interactive Voice Response Menu 9
Using the Interactive Voice Response Menu 9
Configuring the Settings for Your Vonage Phone Service 14
Chapter 5: Using the Phone Adapter’s Web-based Utility 15
Overview 15
How to Access the Web-based Utility 16
The Setup Tab 17
The Administration Tab - Management 19
The Administration Tab - Log 21
The Administration Tab - Factory Defaults 22
The Status Tab 23
The Voice Tab 25
Appendix A: Troubleshooting 27
Common Problems and Solutions 27
Frequently Asked Questions 37
Phone Adapter with 2 Ports for Voice-over-IP
Appendix B: Windows Help 39
Appendix C: Glossary 41
Appendix D: Specifications 45
Appendix E: Warranty Information 47
Appendix F: Regulatory Information 49
Appendix G: Contact Information 65
Vonage 65
Linksys 65
Phone Adapter with 2 Ports for Voice-over-IP
List of Figures
Figure 2-1: Back Panel 3
Figure 2-2: Front Panel 4
Figure 3-1: Connect the Phone Adapter to Your Network and Telephone 5
Figure 3-2: Connect the Ethernet Network Cable 6
Figure 3-3: Connect the Power 6
Figure 3-4: Connect the Telephone Cable 6
Figure 3-5: Attaching the Phone Adapter’s Base 7
Figure 3-6: Phone Adapter Standing on Base 7
Figure 3-7: Measurement between Wall-Mount Slots 8
Figure 5-1: Login 16
Figure 5-2: Setup Tab - Obtain an IP automatically 17
Figure 5-3: Setup Tab - Static IP 17
Figure 5-4: Administration Tab - Management 19
Figure 5-5: Administration Tab - Log 21
Figure 5-6: Administration Tab - Factory Defaults 22
Figure 5-7: Status Tab 23
Figure 5-8: Voice Tab 25
Phone Adapter with 2 Ports for Voice-over-IP
Phone Adapter with 2 Ports for Voice-over-IP
1
Chapter 1: Introduction
Welcome
Chapter 1: Introduction
Welcome
Thank you for choosing the Linksys Phone Adapter with 2 Ports for Voice-over-IP. This Phone Adapter will allow
you to make phone or fax calls using the your broadband connection.
How does the Phone Adapter do this? The Phone Adapter connects your phones or fax machines to your
network router or gateway, so telephone service is delivered through your cable or DSL Internet connection.
Each of the Phone Adapter’s two telephone jacks operates independently, with separate phone service and
phone numbers, so you can have up to two Vonage phone lines per Adapter. You will be able to make phone
calls using the account you set up with Vonage, even while you’re surfing the Internet.
Use the instructions in the Quick Installation or this Installation and Troubleshooting Guide to help you connect
the Phone Adapter after you have set up an account with Vonage. These instructions should be all you need to
get the most out of the Phone Adapter.
What’s in this Guide?
This guide covers the steps for installing the Phone Adapter.
• Chapter 1: Introduction
This chapter describes the Phone Adapter’s applications and this Installation and Troubleshooting Guide.
• Chapter 2: Getting to Know the Phone Adapter
This chapter describes the physical features of the Phone Adapter.
NOTE: For information about
your Vonage phone service,
refer to the User Guide, which is
included in the welcome kit.
Phone Adapter with 2 Ports for Voice-over-IP
2Chapter 1: Introduction
What’s in this Guide?
• Chapter 3: Connecting the Phone Adapter
This chapter explains how to connect the Phone Adapter to your network and phones (or fax machines).
• Chapter 4: Using the Phone Adapter’s Interactive Voice Response Menu
This chapter explains how to configure the Phone Adapter’s network settings.
• Chapter 5: Using the Phone Adapter’s Web-based Utility
This chapter explains how to configure the Phone Adapter using your web browser and its Web-based Utility.
• Appendix A: Troubleshooting
This appendix describes some potential problems and solutions, as well as frequently asked questions,
regarding use of the Phone Adapter.
• Appendix B: Windows Help
This appendix describes how you can use Windows Help for instructions about networking, such as
installing the TCP/IP protocol.
• Appendix C: Glossary
This appendix gives a brief glossary of terms frequently used in networking.
• Appendix D: Specifications
This appendix provides the technical specifications for the Phone Adapter.
• Appendix E: Warranty Information
This appendix supplies the warranty information for the Phone Adapter.
• Appendix F: Regulatory Information
This appendix supplies the regulatory information regarding the Phone Adapter.
• Appendix G: Contact Information
This appendix provides contact information for a variety of Linksys resources, including Technical Support,
as well as Vonage.
Otros manuales para PAP2
14
Tabla de contenidos
Otros manuales de Adaptador de Linksys
Linksys
Linksys WUSB11 ver. 2.6 Manual de usuario
Linksys
Linksys PAP2 Manual de usuario
Linksys
Linksys WUSB54GC EU Manual de usuario
Linksys
Linksys WPC54G EU Instrucciones de funcionamiento originales
Linksys
Linksys LNE100M Instrucciones de funcionamiento originales
Linksys
Linksys WAPPOE Manual de usuario
Linksys
Linksys Instant Broadband Series Manual de usuario
Linksys
Linksys WUSB600N (EU) Manual de usuario
Linksys
Linksys PAP2-T Manual de usuario
Linksys
Linksys USBBT100 Manual de operación
Linksys
Linksys WUSB54GC EU Instrucciones de funcionamiento originales
Linksys
Linksys WUSB600N (EU) Manual de usuario
Linksys
Linksys WPC54G EU Manual de usuario
Linksys
Linksys WPC4400N Manual de usuario
Linksys
Linksys WUSB54G Manual de usuario
Linksys
Linksys WPC4400N Manual de usuario
Linksys
Linksys WUSB11 ver. 2.6 Instrucciones de funcionamiento originales
Linksys
Linksys G Manual de usuario
Linksys
Linksys WPC54GR (DE) Manual de usuario
Linksys
Linksys SPA2002 Manual de operación
