Lightolier C4X4MR Instrucciones de uso

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To

assure full compliance with local codes and regulations, check with your local electrical inspector before

installation. To prevent electric shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

INSTALLATION INSTRUCTIONS FOR 4” MATRIX RECESSED MR-16

DOWNLIGHT

ADJUSTABLE ACCENT and LENSED WALLWASH TRIMS.

INSTRUCTION SHEET NO.

IS:C4

4MR

B0707 Page 1 of 2

A GENLYTE COMPANY

631 Airport Road, Fall River, MA 02720

CAUTION: (RISK OF FIRE) DO NOT INSTALL INSULATION ABOVE NOR WITHIN 3 INCHES (76mm) OF ANY

PART OF THE LUMINAIRE (LIGHTING FIXTURE)

CAUTION: USE ONLY ROUGH-IN SECTIONS PROVIDED BY LIGHTOLIER. USE OF OTHER MANUFACTURERS’ ROUGH-IN KITS

WILL VOID THE UNDERWRITERS LABRATORIES LISTING AND COULD CONSTITUTE A FIRE HAZARD.

SUB-

SSEMBL

SUB-

SSEMBL

LAMP

OPENING

LOWER

REFLECTOR

Downlight Trim:

This trim is provided with a downlight sub-assembly, lampholder assembly,

and a lower reflector unit.

1. Separate LOWER REFLECTOR from SUB-ASSEMBLY. Set LOWER

REFLECTOR aside.

2. Feed SOCKET through lamp opening as shown above. Install SUB-

ASSEMBLY into F.I.K. (in ceiling) by pushing through ceiling opening

until flush with ceiling.

3. ** To install MR16 Incandescent lamp, see LAMPING

INSTRUCTIONS FOR MR16 INCANDESCENT instructions on page 2.

** To install HID MR16 please refer to the lamping

instructions that ship with the lampholder in the HID frame.

4. Install LOWER REFLECTOR into SUB-ASSEMBLY until flange is flush

with ceiling.

FINISHED INSTALLATION

CEILING

SPRING

CLIPS

ADJUSTMENT

MECHANISM

SOCKET

Adjustable Accent Trim:

This trim is provided with a lampholder assembly, lamp

adjustment mechanism/sub-assembly and a lower reflector unit.

1. Separate LOWER REFLECTOR from SUB-ASSEMBLY. Set

LOWER REFLECTOR aside.

2. Feed SOCKET through lamp opening as shown. Install

SUB-ASSEMBLY into F.I.K. (in ceiling) by pushing through

ceiling opening until flush with ceiling.

3. ** To install MR16 Incandescent lamp, see LAMPING

INSTRUCTIONS FOR MR16 INCANDESCENT instructions

on page 2.

** To install HID MR16 please refer to the lamping

instructions that ship with the lampholder in the HID frame.

4. Lamp tilt angle is adjusted via screw marked “TILT”.

5. To adjust rotational position of lamp, loosen screw marked

“ROTATION”, and manually rotate lamp assembly until

desired position is reached. Tighten screw to lock.

6. Install LOWER REFLECTOR into SUB-ASSEMBLY until

flange is flush with ceiling.

LOWER

REFLECTOR

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To

assure full compliance with local codes and regulations, check with your local electrical inspector before

installation. To prevent electric shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

INSTALLATION INSTRUCTIONS FOR 4” MATRIX RECESSED MR-16

DOWNLIGHT

ADJUSTABLE ACCENT and LENSED WALLWASH TRIMS.

INSTRUCTION SHEET NO.

IS:C4X4MR

B0707 Page 2 of 2

A GENLYTE COMPANY

631 Airport Road, Fall River, MA 02720

CAUTION: (RISK OF FIRE) DO NOT INSTALL INSULATION ABOVE NOR WITHIN 3 INCHES (76mm) OF ANY

PART OF THE LUMINAIRE (LIGHTING FIXTURE)

CAUTION: USE ONLY ROUGH-IN SECTIONS PROVIDED BY LIGHTOLIER. USE OF OTHER MANUFACTURERS’ ROUGH-IN KITS

WILL VOID THE UNDERWRITERS LABRATORIES LISTING AND COULD CONSTITUTE A FIRE HAZARD.

Typical Lampholder Assembly

(Supplied with Downlight and Adjustable Accent finishing

sections, along with (1) product-specific glass lens)

* To install HID MR16 please refer to the lamping instructions

that ship with the lampholder in the HID frame.

1. Install lamp into (3) springs as shown.

2. Up to (2) optional 2” accessories may be installed into this

type of lampholder. Refer to appropriate product

specification sheets for any accessory limitations, if any.

3. Connect lamp socket (in F.I.K.) to lamp pins.

4. Install into lamp opening in trim housing.

LAMPING INSTRUCTIONS

ALWAYS ADHERE TO MAXIMUM WATTAGE

LIMITATIONS SPECIFIED ON FINISHING

SECTION LABELING

Wallwash Lamp Installation

* HID applications place ring that ships standard with wall wash trim, over lens as

illustrated above. Continue with steps 1-5.

1. Install lamp into (3) springs as shown.

2. Wallwash trims are supplied with (1) linear spread lens. DO NOT REMOVE this lens,

as it is critical for proper lamp seating and photometric performance.

3. (1) optional 2” accessory may be installed on top of this spread lens. HID applications

will NOT accept any accessories. Refer to appropriate product specification sheets

for any accessory limitations, if any.

4. Connect lamp socket (in F.I.K.) to lamp pins.

5. Install trim as shown elsewhere on this sheet.

Low Voltage applicationsHID applications

HOUSING

TOWARDS WALL TO BE

ILLUMINATED

TRIM

Wallwash Finishing Sections:

This Finishing Section is provided with a housing, a custom linear

spread lens, and a wallwasher trim unit

1. Separate TRIM from HOUSING. Set TRIM aside.

2. Install HOUSING into F.I.K. (in ceiling) by pushing through

ceiling opening until SPRING CLIPS are flush with ceiling.

See instructions on other side.

3. Install appropriate lamp as detailed below.

4. Install TRIM into HOUSING until flange is flush with ceiling.

TRIM must be oriented as shown in order to provide

maximum performance.

LINEAR SPREAD

LENS – DO NOT

REMOVE

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Luminaria de Lightolier

Lightolier

Lightolier VRB SERIES 1'x4 Manual de usuario

Lightolier

Lightolier Calculite C7E17VM CCDW Manual de usuario

Lightolier

Lightolier Lytecaster 1128 Manual de usuario

Lightolier

Lightolier SOF-TECH Instrucciones de uso

Lightolier

Lightolier Calculite HID Glasslite Downlight C4MRGD Manual de usuario

Lightolier

Lightolier Decorative Visor 1 40618U Manual de usuario

Lightolier

Lightolier Lytespan 9170 Manual de usuario

Lightolier

Lightolier ProSpec 26038 Manual de usuario

Lightolier

Lightolier LP100 Manual de usuario

Lightolier

Lightolier Lytespan 8248 Manual de usuario

Lightolier

Lightolier Lytespan 6170 Manual de usuario

Lightolier

Lightolier LYTECASTER 1000LVR Manual de usuario

Lightolier

Lightolier Paraplus II PPH2G12FW228 Manual de usuario

Lightolier

Lightolier BOWSHIELD “ADA” WALL BRACKET SERIES Guía

Lightolier

Lightolier B16 series Manual de usuario

Lightolier

Lightolier Lytecel LL4MF8LR254 Manual de usuario

Lightolier

Lightolier Lytecel 6 LIA6GPNXR154 Manual de usuario

Lightolier

Lightolier MJ6 Series Manual de usuario

Lightolier

Lightolier Calculite Matrix 4X9 Manual de usuario

Lightolier

Lightolier Calculite DD Manual de usuario

Lightolier

Lightolier Lytespan 6320 Manual de usuario

Lightolier

Lightolier Calculite Remodeler Kits Manual de usuario

Lightolier

Lightolier Calculite C4P20L Manual de usuario

Lightolier

Lightolier Lytespan 22SS3 Manual de usuario

Manuales populares de Luminaria de otras marcas

Emos

Emos CLASSIC ZY1431T Manual de usuario

Westinghouse

Westinghouse Outdoor Lighting Fixture Manual de usuario

Hedler

Hedler C 12 silent Manual de usuario

Blizzard Lighting

Blizzard Lighting Puck: CSI Manual de usuario

Energetic Lighting

Energetic Lighting ELYSL-5004 Series Manual de usuario

Lightmaxx

Lightmaxx Shaft 5R Manual de usuario

Triarch

Triarch 31083 Manual de usuario

Philips

Philips 32614 Series Manual de usuario

IKEA

IKEA TIVED Manual de usuario

Chauvet Professional

Chauvet Professional ROGUE R1 BEAM WASH Manual de usuario

Martin

Martin MAC 250 Krypton Manual de usuario

Cooper Lighting

Cooper Lighting Halo L3232E Manual de usuario

Stageline

Stageline ODW-2410RGBW Manual de usuario

Light Sky

Light Sky Tornado Series Manual de usuario

ArtFox

ArtFox Beam 15R extreme Manual de usuario

GLG

GLG multispot 330 Manual de usuario

Home Accents Holiday

Home Accents Holiday TY052-1924-1 Manual de usuario

SELF Electronics

SELF Electronics FLEX Manual de usuario