Lightolier Lytespan ATTACHMENT Manual de usuario

(

INSTRUCTIONS FOR LYTESPAN ATTACHMENT FITTING

INSTRUCTION SHEET NO

lS:7589AZ

ROW

/- SILVERED CONTACT

CORD PENDANT MOUNTING

(supports up to 10 Ibs.)

I. Unscrew LEVER. Remove PLUG ASSEMBLY, HOUSING

INSERT from attachment HOUSING. See Fig. 1.

2. See “WIRING PROCEDURE” below.

STEM MOUNTING USING 1/2” O.D. TUBING

(supports up to 25 Ibs.)

I. Unscrew LEVER, STRAIN RELIEF CAP and KNURLED

RING Remove PLUG ASSEMBLY, HOUSING INSERT

from attachment HOUSING.

2. Use STEM TUBING with M-18 pipe thread

3A” long (not supplied). Screw KNURLED RING onto

STEM TUBING. See Fig. 1A.

3. Insert STEM TUBING into attachment

HOUSING and screw on LOCKNUT until secure.

Tighten KNURLED RING to lock in place.

4. See “WIRING PROCEDURE’’ below.

CHAIN MOUNTING

(supports up to 25 Ibs..)

1. Unscrew LEVER and STRAIN RELIEF CAP.

Remove PLUG ASSEMBLY, HOUSING INSERT from

attachment HOUSING.

2. Replace STRAIN RELIEF CAP with %-18 CHAIN LOOP

(not supplied). See Fig. lB.

3. See “WIRING PROCEDURE” below.

WIRING PROCEDURE

Remove 2“ of outer insulation from FIXTURE CORD

(when required) and strip conductor ends 3A”. See Fig. 1.

Insert FIXTURE CORD through attachment housing.

Fasten BLACK WIRE to LONGER (BRASS) CONTACT and

WHITE WIRE to SHORTER (SILVERED) contact. For

3conductor cord, splice GROUND LEADS with wire

connector. (If the GROUND LEAD from the attachment

HOUSING is not used, leave wire connector on.) See Fig. t

CAUTION: OBSERVE POLARITY WHEN

FASTENING WIRES. BEND WIRES AROUND

SCREW IN CLOCKWISE DIRECTION.

Pull FIXTURE CORD back through attachment HOUSING and

push HOUSING INSERT and PLUG ASSEMBLY into

HOUSING (silvered contact in PLUG ASSEMBLY facing

grooved side of attachment HOUSING). Push ground leads

into area between SPRING section. Fig. 2.

Allow fixture cord to extend into attachment HOUSING by

1/6” and tighten PLASTIC SET SCREW, Fig. 2.

CAUTION: TIGHTEN ENOUGH TO SUPPORT

ASSEMBLY.

Screw LEVER into PLUG ASSEMBLY.

‘RASSCoNTACT----kc <

‘“~ :::~;

,SJQ/

GREEN GROUND !

“~F’=

LEAD

>;, PLUG ASSEMBLY

$3 “~i

w,,,-’”

CONNECTOR

‘REEN ‘ROuND --=&

LEAD

KNURLED RING

STRAIN RELIEF

CAP

$3W27 /’-LEvER

—

SET SCREW

~~,xTuRE

CORD

FIG. 1

KNURLED

RING

CHAIN s<

LOOP

KNURLED

(by others)

~sT~~

TUBING

STEM

MOUNTING CHAIN

MOUNTING

GROOVE

LEVER

TIC SET

FIXTURE

CORD --’4 l\ SCREW

~ ~ > STRAIN RELIEF

CAP

FIG. 2

‘@ SECAUCUS, NEW JERSEY, 07096 ”0508

[m[<>[=[~<>[ml[~l~ MONTREAL, QUEBEC, CANAD~

~$js~RucT[~Ns FOR ATTACHING LyTEspA/IJ

ATTACHMENT FITTING

1. Align BEAD on LYTESPAN TRACK and GROOVE

in attachment FITTING before inserting into

LYTESPAN TRACK. See Fig.1 (If BEAD is NOT

aligned, apotential hazard may result.)

2. Unscrew the TURN KNOB partially and

position LEVER as shown in Fig. 1.

3. To attach attachment FITTING:

squeeze BUTTON and TURN KNOB,

insert into LYTESPAN TRACK, and

release. Tighten TURN KNOB. This

holds attachment FITTING to LYTESPAN

TRACK mechanically. Turn LEVER to make

electrical connection. See Fig. 2.

4. To shift fixture location on the LYTESPAN

TRACK loosen TURN KNOB slightly, release

LEVER and slide to new position.

5. To remove fixture reverse the procedure in (3),

push TURN KNOB in and allow attachment

FITTING to disengage.

6. Fixture can be left on LYTESPAN TRACK

when not in use by turning LEVER to

disconnect electrically.

INSTRUCTIONS FOR CONVERTING LYTESPAN

ATTACHMENT FITTING TO OPERATE ON (2 CIRCUIT)

LYTESPAN TRACK.

NOTE: To insure proper operation of Lytespots on Two Circuit

Lytespan Track, the BLACK SPACER

(supplied) must be used at all times on the PIU9

assembly.

The BLACK SPACER is not used when operating

Lytespots on Single Circuit Track.

LOWER CIRCUIT, FIG. 3:

Illustrates contacts in low position with spacer

in place for lower circuit.

UPPER CIRCUIT, FIG. 4 and 5:

To convert attachment fitting for upper circuit,

raise BRASS CONTACT to high position (as

indicated by dotted line) by pulling CONTACT

as high as stop permits and slipping on BLACK

SPACER as shown in Fig. 4 and 5.

_LYTESPAN TRACK

BEAO ER

BUTTON

GROOVE NG

FIG. 1

(

BUTTON ~

FIG. 2

BLACK SPACER

MOVABLE BRASS

CONTACT

FIG. 3

MOVABLE BRASS

CONTACT

STATIONARY SILVEREO

BLACK CONTACT (COMMGN)

SPACER PLUG

.ASSEMBLY

-5”” \

BLACK

SPACER

FIG. 4FIG. 5

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Accesorios de Lightolier

Lightolier

Lightolier Calculite FA-EM Manual de usuario

Lightolier

Lightolier 40829U Manual de usuario

Lightolier

Lightolier ProSpec 26075 Manual de usuario

Lightolier

Lightolier IS_CD7-STEM Manual de instrucciones

Lightolier

Lightolier Lytespan 83T4AH Manual de usuario

Lightolier

Lightolier Lytecaster 1085 Manual de usuario

Lightolier

Lightolier 1101HCB Manual de usuario

Lightolier

Lightolier Calculite GC Manual de usuario

Lightolier

Lightolier 1005 Manual de usuario

Lightolier

Lightolier SLOITED GRID CEILING CLIPS Manual de usuario

Lightolier

Lightolier Calculite C6P38A Manual de usuario

Lightolier

Lightolier Lytespan 23C39MR Manual de usuario

Lightolier

Lightolier Lytespan 22OR6 Manual de usuario

Lightolier

Lightolier Lytespan 8102 Manual de usuario

Lightolier

Lightolier Lytecaster 1027 Manual de usuario

Lightolier

Lightolier Lytecaster 1104F13ESR Manual de usuario

Lightolier

Lightolier IS-CWL280612 Manual de usuario

Lightolier

Lightolier 1003R Manual de usuario

Lightolier

Lightolier C7CW SERIES Manual de usuario

Lightolier

Lightolier Calculite RM-INC Manual de usuario

Lightolier

Lightolier Lytecaster 1920LV Instrucciones de uso

Lightolier

Lightolier Lytespan 83PC Manual de usuario

Lightolier

Lightolier 1002P1 Manual de usuario

Lightolier

Lightolier Lytecaster 2027 Manual de usuario

Manuales populares de Accesorios de otras marcas

Hillco

Hillco 2810 Manual de usuario

Siemens

Siemens QSA2700D Manual del operador

Contours

Contours ZY024 Manual de usuario

Saivod

Saivod VS621 Manual de usuario

Virtuox

Virtuox VirtuCLEAN 2.0 Manual de usuario

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Manual de usuario

Z-Wave

Z-Wave HSD-200Z Manual de usuario

turck

turck FMX-IM-2UPLI63FX Manual de usuario

Decagon Devices

Decagon Devices 10HS Manual de usuario

UPPAbaby

UPPAbaby Cup Holder Manual de usuario

Elko

Elko SmartSensor Leakage Wireless Manual de usuario

Grizzly

Grizzly H8371 Manual de usuario

Panasonic

Panasonic HG-T Series Manual de usuario

IFM Electronic

IFM Electronic Efector 250 Series Guía de referencia

DigiDesign

DigiDesign 888/24 I/O Manual de usuario

PROZIS

PROZIS QUAY Manual de usuario

patagonia

patagonia PSI Vest Manual de usuario

SFC Energy

SFC Energy EFOY GO! Manual de usuario