Lighthouse Worldwide Solutions REMOTE ActiveCount Manual de usuario
00
Lighthouse Worldwide Solutions
REMOTE ActiveCount Biological Air Sampler
Controller & Remote Switch System
Installation Guide
Copyright © 2012- 2017 by Lighthouse Worldwide Solutions. All rights reserved. No part of this
document may be reproduced by any means except as permitted in writing by Lighthouse
Worldwide Solutions.
The information contained herein constitutes valuable trade secrets of Lighthouse Worldwide
Solutions. You are not permitted to disclose or allow to be disclosed such information except as
permitted in writing by Lighthouse Worldwide Solutions.
The information contained herein is subject to change without notice. Lighthouse Worldwide
Solutions is not responsible for any damages arising out of your use of the LMS program.
REMOTE ActiveCount™ and LMS™ are trademarks of Lighthouse Worldwide Solutions.
Microsoft®, Microsoft Windows™, and Excel™ are trademarks of Microsoft Corporation.
Manufactured by:
Lighthouse Worldwide Solutions
1221 Disk Drive
Medford, Oregon 97501
LWS Part Number: 248083413-1 Rev 4
EU DECLARATION OF CONFORMITY
Manufacturer’s Name: Lighthouse Worldwide Solutions, Inc.
Manufacturer’s Address: Lighthouse Worldwide Solutions, Inc.
1221 Disk Drive
Medford, OR 97501 USA
Declares that the product:
Product Name: Biological Air Sampler
Model Number(s): REMOTE ActiveCount System
Conforms to the following Product Specifications:
SAFETY EN61010-1:2001 Safety Requirements for Electrical Equipment for
Measurement, Control, and Laboratory Use Part 1:
General Requirements IEC 61010-1:2000
Safety Requirements for Electrical Equipment for
Measurement, Control and Laboratory Use, Part 1:
General Requirements
EMC EN61326 Electrical Equipment for Measurement, Control and
Laboratory Use EMC Requirements Part 1: General
Requirements Includes Amendment A1:1998; IEC
61326:1997 + A1:1998
UL 61010A-1 - UL Standard for Safety Electrical Equipment for Laboratory Use; Part 1: General Requirements
Replaces UL 3101-1
Supplementary information
The product herewith complies with the requirements of the Low Voltage Directive 73/23/EEC amended by
Directive 93/68/EEC and the EMC Directive 89/336/EEC amended by Directive 93/68/EEC and carries the
CE marking accordingly.
William Shade - V.P. Engineering
Fremont, CA. November7, 2011
CAN/CSA C22.2
No. 1010.1-1992
IEC 60825-1 Am. 2
00
248083413-1 Rev 4 t-i
Table of Contents
About this Manual
Text Conventions ................................................................................................................ i
Additional Help ................................................................................................................... i
Chapter 1 General Safety
Safety Considerations .................................................................................................... 1-1
Chapter 2 Introduction
Overview ........................................................................................................................ 2-1
Interchangeable Terms ....................................................................................... 2-1
Description ..................................................................................................................... 2-1
REMOTE ActiveCount Specifications .......................................................................... 2-2
Chapter 3 Getting Started
Initial Inspection ............................................................................................................ 3-1
Unpacking ...................................................................................................................... 3-1
Shipping Instructions ..................................................................................................... 3-2
Installation ..................................................................................................................... 3-3
DIP Switch Settings ....................................................................................................... 3-5
DIP Switch General Definitions ........................................................................ 3-5
DIP Switch Addressing ...................................................................................... 3-5
RAC Controller RJ-45 Pinouts .......................................................................... 3-7
Remote Switch RJ-45 Pinouts ........................................................................... 3-8
Configuring the RAC in LMS Express RT ........................................................ 3-9
Remote Switch Operation ................................................................................ 3-12
Configure Flow Settings .................................................................................. 3-13
Chapter 4 Communications
Configuring with the MODBUS Protocol ..................................................................... 4-1
Configure the RAC System ........................................................................................... 4-1
Operating the RAC System ............................................................................................ 4-2
Lighthouse REMOTE ActiveCount Installation Guide
t-ii 248083413-1 Rev 4
Access RAC Information ............................................................................................... 4-2
Appendix A Limited Warranty
Limitation Of Warranties: ..................................................................... A-1
Warranty Of Repairs After Initial Two (2) Year Warranty: ................. A-1
Appendix B Remote ActiveCount MODBUS Register Map
v1.49
COMM Settings ............................................................................................................. B-1
Supported MODBUS Commands .................................................................................. B-1
Sensor Settings Registers ................................................................................... B-2
Device Status ..................................................................................................... B-6
Data Registers ................................................................................................................ B-8
Data Status Byte (30007 - 30008) .................................................................... B-10
Alarm Flags in Channels (30076) .................................................................... B-11
Data Type Registers ......................................................................................... B-11
Data Units Registers ........................................................................................ B-12
Data and Alarm Registers ............................................................................................ B-13
Data and Alarm Enable Registers .................................................................... B-13
Enable Alarming for a Channel ....................................................................... B-15
Threshold Setup Registers ............................................................................... B-16
Setting the Alarm Threshold Value ..................................................... B-17
Index
00
248083413-1 Rev 4 i
About this Manual
This manual describes the installation and operation of the Lighthouse
REMOTE ActiveCount System.
Text
Conventions The following typefaces have the following meanings:
Note: A note appears in
the sidebar to give extra
information regarding a
feature or suggestion.
italics Represents information not to be typed
or interpreted literally. For example, file
represents a file name. Manual titles are
also displayed in italics.
WARNING: A
warning appears in a
paragraph like this and
warns that doing
something incorrectly
could result in personal
injury, damage to the
instrument or loss of
data.
boldface Introduces or emphasizes a term.
Courier font Indicates command syntax or text
displayed by the diagnostic terminal.
Bold Courier Indicatescommandsand information that
you type.
Helvetica Italics Indicates a comment on a command or
text output.
Hexadecimal numbers are shown with the word "hex"or with a small
"h" following the digits. For example:
hex 0D
0Dh
Additional
Help For more information about the Lighthouse REMOTE ActiveCount
System, contact Lighthouse Worldwide Solutions.
Service and Support
Tel: 1-800-945-5905 (USA Toll Free)
Tel: 1-541-770-5905 (Outside of USA)
Lighthouse REMOTE ActiveCount Installation Guide
ii 248083413-1 Rev 4
Tabla de contenidos
