Light-Point Rorhat Manual de usuario
RØRHAT
HANDCRAFTED
LIGHT-POINT.COM
Certicates and approvals
Continued...
Electrical and electronic equipment (WEEE)
contains materials, components and substances
that may be dangerous and hazardous to human
health and to the environment when waste from
electrical and electronic equipment is not disposed
of correctly.
Protected from water spray less than 60 degrees
from vertical.
RØRHAT Wall is available in 3 versions:
- G23 Bulb
- E14 Bulb
- LED 10,5W
Safety precautions
· Dispose of plastic bag from packaging and do not allow
children to play with it.
· Consult a qualied electrician if in any doubt.
Certicates and approvals
LIGHT-POINT declares that this product is in compliance
with essential requirements and relevant provisions:
Declaration of Conformity.
Contact LIGHT-POINT for more information.
The product conforms with Class II or double
insulated electrical appliance, that has been
designed in such a way that it does not require
a safety connection to electrical earth (ground).
General use
· The product is designed for indoor and outdoor use*.
* Please note that copper and brass with Lacquered surface are only for
indoor use.
· The lamp gets hot after prolonged use, therefore,
do not cover the product.
· The surface of raw copper and brass will patinate
over time.
Cleaning instructions
· Wipe surface of lamp shade with a soft cloth.
· Do not use any abrasive cleaning tools such as steel wool,
scouring sponges or stiff brushes.
· Never use strong cleaning agents such as white spirit,
household glass cleaner or cellulose thinners.
· Finish cleaning of stainless steel surface with acid free
oil to prevent rust-like tarnishes.
International warranty
Your product has gone through rigorous testing in order
to live up to the highest quality standards. It therefore carries
a 7-year warranty in Europe from the date of the original
retail purchase receipt, covering defects in materials and
workmanship when used normally in accordance with the
published LIGHT-POINT guid elines.
These guidelines include but are not limited to information
contained in technical speci cations, safety instructions
and quick start guides. LIGHT-POINT is not responsible for
damage arising from failure to follow instructions relating
to the use of the product.
LIGHT-POINT is a registered trademark
of NORDIC LIVING GROUP.
For more information, please visit LIGHT-POINT.COM
IP23
User Instructions
RØRHAT Wall
1
1
2
3
4
5
6
7
8
9
Before installation, make
sure the power supply is
switched off
The lamp comes assembled
and has to be disassembled
before mounting
Use the lamp base as a tem-
plate to mark the position
of the holes on the wall
Remove the acrylic cover
Remove the lamp
shade
Drill the three holes Finished
Mount the lamp base and
connect the power supply
Mount the lamp
shade
Install the light bulb and
acrylic cover
Base measurement drawing
Front
Section Grap for wiring
Otros manuales de Luminaria de Light-Point
Manuales populares de Luminaria de otras marcas
Emos
Emos CLASSIC ZY1431T Manual de usuario
Westinghouse
Westinghouse Outdoor Lighting Fixture Manual de usuario
Hedler
Hedler C 12 silent Manual de usuario
Blizzard Lighting
Blizzard Lighting Puck: CSI Manual de usuario
Energetic Lighting
Energetic Lighting ELYSL-5004 Series Manual de usuario
Lightmaxx
Lightmaxx Shaft 5R Manual de usuario
Cooper Lighting
Cooper Lighting Halo L3232E Manual de usuario
Stageline
Stageline ODW-2410RGBW Manual de usuario
Light Sky
Light Sky Tornado Series Manual de usuario
Lightolier
Lightolier Paralyte 2424 PLA2G9LS26U Manual de usuario
Lightolier
Lightolier Lytespan 83ED17S Manual de usuario
Lightolier
Lightolier Calculite CS8226 Manual de usuario