LIBERTY AV SOLUTIONS DIGITALINX DL-ILFO-H2 Manual de usuario
11675 Ridgeline Drive
Colorado Springs, CO
80921
Rev 200921 Phone: 719-260-0061
Toll-Free: 800-530-8998
Fax: 719-260-0075
DL-ILFO-H2 Install Guide
DL-ILFO-H2 Owners Manual
3
The DigitaLinx DL-ILFO-H2 HDMI 2.0 extender set extends uncompressed HDMI audio and video up to 200m
/ 660’ using a duplex mul-mode OM3 ber cable. The DL-ILFO-H2 Supports HDMI 2.0b up to 18Gbps, CEC,
HDR10, HDR10+ Dolby Vision and HDCP 2.2 as well as High Denion Dolby and DTS audio formats.
The DL-ILFO-H2 is sold only as a set. The individual transmier and receiver are not compable with other ber
extender oerings unless specically noted otherwise.
Product Overview
Package Contents
• (1) Transmier (Tx) and One (1) Receiver (Rx)
• (2) Micro USB to USB power cables
• (1) Installaon Guide
• (2) 5V 1A power supply with US, AU, EU and UK adapters
DL-ILFO-H2 Owners Manual
4
Installaon Instrucons
Connect the DL-ILFO-H2 transmier and receivers USB port to the supplied power supplies and connect to
a local power source. The DL-ILFO-H2 transmier can be powered by 5V from pin #18 of the HDMI interface
however the receiver must receive a constant power supply @ 5V/1A, some TV’s and projectors may be able
to supply this power via a USB A port but if the power supplied by the TV is not stable or sucient enough, it
is recommended to use the provided power supplies on each extender device. Always the check the available
USB power on a TV to be sure the receiver will receive the correct amount of voltage and amperage if using this
method.
NOTE: Digitalinx recommends using both USB power supplies connected to both transmier and receiver for a
stable power connecon and supply.
When power is supplied the power LED will turn ON.
Connect Power
Connect Fiber Cables to Extenders
Connect a duplex LC OM3 opcal ber cable between the transmier and the receiver, note that each ber
channel should be connected as (A) to (A) and (B) to (B) respecvely.
The maximum length for the OM3 ber cable is 200m / 660’. This extender will not work with single mode ber
cable for longer distances.
NOTE: Digitalinx does not recommend or support cable interrupts or pass-throughs in the ber cable such as
keystone plates or patch panels, this may cause undesired interrupons in system performance.
DL-ILFO-H2 Owners Manual
5
Connect the DL-ILFO-H2 transmier to the HDMI source, connect the receiver to the TV display.
NOTE: Be sure the extender device labeled TRANSMITTER is connected to the HDMI source, and the device
labeled RECEIVER is connected to the TV display.
When a successful audio and video link has been established between the HDMI source / transmier and TV
display / receiver the STATUS light on the extender devices will blink.
Connect Fiber Extender to Devices
HDMI SOURCE DISPLAY
DL-ILFO-H2
TRANSMITTER
OM3 Fiber up to
200m / 660’
USB Power
USB Power
DL-ILFO-H2
RECEIVER
DL-ILFO-H2 Owners Manual
6
Technical Specicaons
Supported Audio and Video
Video Compliance HDMI 2.0b, HDCP 2.2, and CEC (Consumer Electronics Control)
Input / Output Resoluon Support All resoluons are supported up to 4096x2160 / 60Hz; 4:4:4; 8 bit deep color
Maximum Pixel Clock 600MHz
Embedded Audio LPCM, Dolby Digital/Plus/EX, Dolby True HD, DTS, DTS-EX, DTS-96/24,
DTS High Res, DTS-HD Master Audio, DSD
Fiber Opc Signal Characteriscs
Maximum Distance 200 meters / 660’ feet
Required Cable Type Duplex LC-LC OM3
Bandwidth 18Gbps
Chassis and Environmental
Dimensions (W*H*D) 26 mm (1 in) x 15 mm (0.6 in) x 72 mm (2.8 in)
Operang Temperature (Environment) 0 to + 50°C (32 to + 122 °F)
Operang Temperature (Storage) -30 to +70°C (-22 to + 158 °F)
Operang Humidity (Environment) 10% to 85%, Non-condensing
Product Weight 175g / .4 lbs
Power
Maximum Power Consumpon 5 was
Power Supply Input Voltage AC 100-240V, 50/60Hz.
Power Supply Output Voltage DC +5 V, 1A
Regulatory CE, FCC, RoHS
Other
Standard Warranty 5 Years
Included Items (1) Transmier, (1) Receiver, (1) Install Guide, (2) DC 5V Power Supply with
US, UK, EU and AU power adapters (2) USB Micro to A power cables
Thank you for your purchase.
For Technical Support please call our toll free number at
800-530-8998 or email us at supportlibav@libav.com
www.libav.com
Digitalinx is a brand of:
11675 Ridgeline Drive
Colorado Springs, Colorado
80921 USA
Phone: 719-260-0061
Fax: 719-260-0075
Toll-Free: 800-530-8998
Tabla de contenidos
Otros manuales de Extensor de LIBERTY AV SOLUTIONS
LIBERTY AV SOLUTIONS
LIBERTY AV SOLUTIONS DigitaLinx DL-HD70 Manual de usuario
LIBERTY AV SOLUTIONS
LIBERTY AV SOLUTIONS DigitaLinx DL-1H1A1U-B Manual de usuario
LIBERTY AV SOLUTIONS
LIBERTY AV SOLUTIONS DigitaLinx DL-HD50C-WPKT-W Manual de usuario
LIBERTY AV SOLUTIONS
LIBERTY AV SOLUTIONS DL-1H1V-WPKT-H2 Manual de usuario
LIBERTY AV SOLUTIONS
LIBERTY AV SOLUTIONS INT-USB2-50H Manual de usuario
LIBERTY AV SOLUTIONS
LIBERTY AV SOLUTIONS Intelix DIGI-HD70 Manual de usuario
