Leonton EG5-0501-SFP Series Manual de usuario

Leonton

EG5-0501-SFP Series

(EG5-0501-SFP / EG5-0501-SFP-T)

User Manual

This document contains information, which is protected by copyright. Reproduction, adaptation or

translation without prior permission is prohibited, except as allowed under the copyright laws.

Disclaimer

Leonton Technologies, Co. Ltd. provides this manual without warranty of any kind, expressed or

implied, including but not limited to the implied warranties of merchantability and fitness for a

particular purpose. Leonton Technologies, Co. Ltd. may make improvements and/or changes to

the product and/or specifications of the product described in this manual, without prior notice.

Leonton Technologies, Co. Ltd. will not be liable for any technical inaccuracies or typographical

errors found in this guide. Changes are periodically made to the information contained herein and

will be incorporated into later versions of the manual. The information contained is subject to

change without prior notice.

FCC Notice

This equipment has been tested and found to comply with the limits for a Class-A digital device,

pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses, and can

radiate radio frequency energy. It may cause harmful interference to radio communications if the

equipment is not installed and used in accordance with the instructions. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of

the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications not expressly approved by the grantee of this device could

void the user's authority to operate the equipment.

CE Mark Warning

This is a Class-A product. In a domestic environment this product may cause radio interference in

which case the user may be required to take adequate measures.

This document is the current official release manual. Please check our website (www.leonton.com)

for any updated manual or contact us by e-mail (sales@leonton.com).

Contents

Overview......................................................................................................................1

Software Features .................................................................................................1

Hardware Features................................................................................................2

Package Contents ..................................................................................................2

Safety Precaution ..................................................................................................3

Hardware Description ..................................................................................................4

Physical Dimensions..............................................................................................4

Front Panel............................................................................................................5

Top View ...............................................................................................................5

LED Indicators........................................................................................................6

Ethernet Ports .......................................................................................................7

Cabling ..................................................................................................................8

Wiring the Power Inputs .....................................................................................10

Grounding Note...................................................................................................11

Wiring the Fault Alarm Contact...........................................................................11

Mounting Installation.................................................................................................13

DIN-Rail Mounting...............................................................................................13

Wall Mounting.....................................................................................................15

Hardware Installation.................................................................................................16

Installation Steps.................................................................................................16

Maintenance and Service...........................................................................................17

Trouble Shooting........................................................................................................18

Overview

This series is rated IP30 and installation by DIN Rail. Each unit of this industrial gigabit managed

Ethernet switch series has 4* 10/100/1000TX Gigabit Ethernet ports and 1 dual-rate (100/1000)

SFP slots, suitable for applications that require high bandwidth and long distance communication.

In order to prevent unregulated voltage, this series provides high EFT and ESD protection. This

also allows it to function in harsh environments, as well as support power redundancy with a dual

power input design with reverse polarity protection. The built-in relay warning function alerts

users about occurring power failures.

With one model having an operating temperature of -10 to 65°C, and another with a wide

operating temperature of -40 to 75°C, this series is designed to meet any needs for industrial

automation, outdoor application and harsh environments.

Software Features

Network Redundancy

STP, RSTP, MSTP, ITU-T G.8032 Ethernet Ring Protection Switch (ERPS) for network redundancy

Configuration

Web GUI based management, Telnet, Serial Console (CLI), TFTP, SSH, SSL, SNMP v3, USB

Network Management

QoS (CoS/ToS), storm protection

IEEE802.1Q VLAN, Q-in-Q, management VLAN supported

IGMP v1/v2, IGMP snooping/querier, IGMP query up to 256 group

DHCP Client/Server/Relay/Binding

Internet Protocol Version 6 (IPv6)

NTP, UPnP, Modbus TCP

Security Features

Three level configuration access account (Admin/Manager/User)

MAC based port security, static MAC address

Access Control List(ACL), 802.1X authentication, RADIUS Server

SNMP v3 encrypted authentication and access

Port Configuration

Port Status, Statistics, Monitoring, Mirroring, Security, and Rate Limiting

Event Handling

Event notification by Email/Syslog: system cold start, port link-up/down

Fault Alarm Relay Output for power failure, port link-down/broken

Software Upgrade

TFTP, Web GUI, CLI

USB Port

Configuration Backup/Restore

Hardware Features

Interface & Performance

All Copper ports support auto MDI/MDI-X function

Embedded 4*10/100/1000Tx and 1*100/1000 SFP Slot

Store-and-forward switching architecture

8K MAC Address Table

Supports 9.6Kbytes Jumbo Frame

4Mbits memory buffer

Power Input

Redundant power DC 12~48V with connective 1*6-pin removable terminal block

Max. current 3.5A

Relay Contact: 24 VDC, 1A resistive

The power input specification is complied with the requirements of SELV (Safety Extra Low

Voltage), and the power supply should be complied with UL 61010-1 & UL 61010-2-201.

Certification

CE/FCC

UL 61010-1

UL 61010-2-201

Operating Temperature

Standard operating temperature model: -10°C ~ 65°C

Extended operating temperature model (–T): -40°C ~ 75°C

Case/Installation

IP-30 protection

Installation in a Pollution Degree 2 industrial environment

DIN-Rail and wall mount design

Package Contents

1 - EG5-0501-SFP(-T) product

1 - User manual CD

2 - Wall mounting brackets and screws

1 - RJ45 to DB9 Serial Console cable

Safety Precaution

Attention

If the DC voltage is supplied by an external circuit, please use a protection device on the power

supply input. The industrial Ethernet switch’s hardware specs, ports, cabling information, and

wiring installation will be described within this user manual.

Warning Labels

The caution label means that you should check the certain information on user manual when

working with the device. (Shown in Figure 1.1)

Figure 1.1: Caution Label

This warning label is on the device, and means that the surface of the device is hot. (Shown

in Figure 1.2)

Figure 1.2: Hot Surface Warning Label

Hardware Description

Physical Dimensions

Figure 2.1, below, shows the physical dimensions of EG5-0501-SFP series.

(W x D x H) is 54mm x 99mm x 142mm

Figure 2.1: EG5-0501-SFP Series Physical Dimensions

Front Panel

The front panel of the EG5-0501-SFP series industrial Gigabit managed Ethernet switch is

shown below in Figure 2.2.

Figure 2.2: The Front Panel of EG5-0501-SFP Series

Top View

Figure 2.3, below, shows the top panel of the EG5-0501-SFP series switch that is equipped with

one 6-pin removal terminal block connector for dual DC power inputs (12~48VDC).

Figure 2.3: Top Panel View of EG5-0501-SFP Series

LED Indicators

There are LED light indicators located on the front panel of the industrial Ethernet switch that

display the power status and network status. Each LED indicator has a different color and has

its own specific meaning, see below in Table 2.4.

LED

Color

Description

Green

Power input 1 is active

Off

Power input 1 is inactive

Green

Power input 2 is active

Off

Power input 2 is inactive

FAULT

Green

No event happened

Red

1. Power input 1 or 2 is inactive

2. Port link-down/Broken

MASTER

Green

ERPS Owner Mode (Ring Master) is ready

Off

ERPS Owner Mode is not active

RING

Green

ERPS Ring Network is active and works well

Flashing

ERPS Ring works abnormally or misconfigure

Off

ERPS Ring Network is not active

L/A

(SFP Port 5)

Green

Connected to network, 100/1000Mbps

Flashing

Networking is active

Off

Not connected to network

(LAN Port 1-4)

Green

Connected to network, 1000Mbps

Flashing

Networking is active

Off

Not connected to network

10/100

(LAN Port 1-4)

Green

Connected to network, 100Mbps/10Mbps

Flashing

Networking is active

Off

Not connected to network

Table 2.4: LED Indictors for EG5-0501-SFP Series

Caution: "P" is the abbreviation for "Power", "L" is for "Link", and "A" is for "Activity".

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Cambiar de Leonton

Leonton

Leonton BG5-1204-SFP Series Manual de usuario

Leonton

Leonton PG2-0601-SFP Series Manual de usuario

Leonton

Leonton PG5-1802-SFP Series Manual de usuario

Leonton

Leonton EG5-1600 Series Manual de usuario

Leonton

Leonton PT2-0802-2C-24 Series Manual de usuario

Leonton

Leonton ET2-0800 Series Manual de usuario

Leonton

Leonton PG2-0500 Series Manual de usuario

Leonton

Leonton CET2-0800 Series Manual de usuario

Leonton

Leonton EG2-0601-SFP Series Manual de usuario

Leonton

Leonton EG2-1202-SFP Series Manual de usuario

Leonton

Leonton PT5-0600 Series Manual de usuario

Leonton

Leonton PG5-1600-M12XB-110-67 Instrucciones de uso

Leonton

Leonton PT2-0501-M-24 Series Manual de usuario

Leonton

Leonton ET2-1002-2C Series Manual de usuario

Leonton

Leonton PT2-0800 Series Manual de usuario

Leonton

Leonton PT2-0802-2C Series Manual de usuario

Leonton

Leonton EG5-2004-SFP Series Manual de usuario

Leonton

Leonton BG5-1204-SFP-24 Series Manual de usuario

Leonton

Leonton PT2-0702-SFP Series Manual de usuario

Leonton

Leonton PT2-0802-M-24 Series Manual de usuario

Leonton

Leonton PG5-1600-M12XB-24-67 Instrucciones de uso

Leonton

Leonton EG2-1002-SFP Series Manual de usuario

Leonton

Leonton BG5-0702-SFP Series Manual de usuario

Leonton

Leonton EG2-1604-SFP Series Manual de usuario

Manuales populares de Cambiar de otras marcas

URC

URC Total Control MFS-8 Manual de usuario

Azbil

Azbil HPQ-D11 Manual de usuario

Sony

Sony DFS-900M Manual de usuario

SICK

SICK i17S Manual de usuario

F&F

F&F SZR-277 Manual de usuario

Shure

Shure UAMS/BK Manual de usuario

Dräger

Dräger X-zone Switch Off Manual de usuario

Asco

Asco Joucomatic 349 Series Manual de usuario

BT Mini Hub Manual de usuario

D-Link

D-Link DES-1226G Manual de usuario

Johnson Controls

Johnson Controls FS80-C Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manual de usuario

MicroNet

MicroNet SP1200A Manual de usuario

Ruijie

Ruijie RG-PF2920 Series Manual de instalación y funcionamiento

Altinex

Altinex DA1914SX Manual de usuario

MiLAN

MiLAN MIL-SM2401M Manual de usuario

RJM

RJM MASTERMIND PBC/6X Manual de usuario

Atlas

Atlas MMK-KVM8 Manual de usuario