Lelit PRO Line MaraX PL62X Manual de servicio
Extended guide
EXTRA
content
*PL62X PL62X-EU PL62X-AUS PL62X-AS PL62X-100 PL62X-120
230 V
50 Hz
230 V
50 Hz
240 V
50 Hz
220 V
50/60 Hz
100 V
50/60 Hz
120 V
60 Hz
E+F E+F I G B B
2
MaraX - PL62X*
THANK YOU FOR CHOOSING
A LELIT PRODUCT
Register your product on
care.lelit.com
Download the complete guide
to get the most of your coffee machine PL62X*
and visit our LELIT YouTube channel.
Save the box and all
the packing material!
LELIT has studied the external and internal packing
of your coffee machine to help you re-use it in case
of maintenance or repair need.
3
Extended guide
Index
1. Mainspecications EXTRA 4
2. Productoverview 6
3. Factorysettings 6
4. Equipmentbox 7
5. Packing 8
6. Firststart-up 8
7. Howtoinstallthewatersoftenerlter 9
8. Espressoandcoffee 10
9. Steamandhotwater 11
10. Stand-bymode EXTRA 12
11. Functioningmodes EXTRA 13
12. Theartofespressocoffee EXTRA 16
13. Limescaleprevention 19
14. Dailycleaning 19
15. Weeklycleaning 20
16. Annualcleaning 21
17. Pilotlightsandstates 22
18. Mostcommonproblems EXTRA 23
19. Warrantyterms 26
4
MaraX - PL62X*
1. Main specifications EXTRA
UserFriendly
This machine allows anyone to
make an espresso as good as
it tastes at a café.
Brushed
stainlesssteel
Its brushed stainless steel
appliance body and its details
make it a wonderful piece of
design even when the machine
is switched off. Thanks to the
brewing group, this machine
is the perfect union between
coffee culture and innovation.
Stainlesssteelboiler
The new stainless-steel boiler
AISI316L is a detail aimed at
improving the nal result: an
espresso that keeps its taste
and aroma intact through each
single bean from the start to
the very end.
CoffeeSlide
A dispensing spout that can be
used for both one or two cups
and that allows the user to see
the coffee cream on its way
towards the cup.
Energysaving
When the machine is not used
for more than 30 minutes, it
automatically enters the stand-
by mode. This saves money for
you and valuable resources for
the planet.
ATTENTION:
Read the safety notes carefully before using
this product.
5
Extended guide
in the
equipment box
PIC. 2
1
1 11 17
11
17
2
10
12
13
14
15
16
3
4
5
6
7
8
9
6
MaraX - PL62X*
2. Product overview
3. Factory settings
1. Water tank cover
2. Hot surface with grate for cups
3. Steam dispensing knob
4. Machine ready pilot light
5. Full water tank pilot light
6. Manometer for steam and pump
pressure during extraction
7. Multi-directional, anti-burn
steam wand
8. ON/OFF main switch
9. Temperature mode switch
10. Water tank (2,6 l)
11. Grate for hot surface
12. Hot water dispensing knob
13. Brewing group
14. Brewing group lever
15. Multi-directional, anti-burn
hot water wand
16. Xmode switch
17. Removable drip tray,
complete with grate
Xmode(16)
Steam Xmode (pre-set value)
Temperaturemode(9)
Warm (pre-set value)
Standby:
ON
Watersoftenerlter:
Not inserted
MaraX has two functioning modes: these two switch modes aim to improve the
thermal performance of the product. Each Xmodes can address different coffee
workows. ReadmoreaboutotherfunctioningmodesonChapter11.
7
Extended guide
4. Equipment box
A. 1 dose (9-11 g) coffee lter
B. 2 doses PLUS (18-21 g)
coffee lter
C. Blind lter for backushing
D. Tamper in stainless steel with
red wood handle (PLA481R)
E. Raiser for espresso cups
F. First cleaning kit (with 3
detergent powder single-dose
bags and 1 single-dose bottle)
G. Filterholder complete with
2 doses (14-18 g) coffee lter
H. LELIT 35 l water lter
I. Brush for group head cleaning
J. Plastic spoon for coffee powder
K. Power cord
E
D
G
H
I
K
J
A
B
CF
8
MaraX - PL62X*
5. Packing
The packaging of your coffee machine has been studied and produced to be re-
used. Save the box and all the packaging material for the entire warranty period
and, if possible, even after.
Use the original box and all the packaging elements in case you need to send
the machine back to your reseller or to an authorized service centre, for ordinary
or extraordinary maintenance.
On our YouTube channel you will nd a video on how to pack the machine
properly, using the original box and packaging material.
Please also consult your LELIT reseller before shipping the machine away and
follow his eventual specic instructions.
6. First start-up
6.1 6.2 6.3
FRONT
30
sec
Attention. Remove the machine from its packing and follow the instructions
printed on the box.
Place the machine on a solid, at and dry surface and make sure the appliance
is stable.
From the equipment box, take out the drip tray (17), the wire grid (11), the cover
(1) and position them as indicated in Pic. 2.
Attention. Do not install the water lter, please run the rst start-up and
proceed with the water lter installation only afterwards.
Fill the water tank (10) with room temperature water up to the indicated maximum
level and insert it in its seating (Pic 6.1). Use the power cord (K) to connect the
machine to the electrical mains and turn ON the machine by pressing the ON/
OFF (8) switch. If the water tank (10) is full of water and properly inserted in
its seating, the pilot light (5) goes ON (Pic 6.2). The hydraulic circuit will need
maximum 4 minutes from the 1st turn on to get lled with water. Once the
9
Extended guide
waiting time is over, the pilot light (4) will start ashing. Lift the group lever (14)
completely (Pic 6.3). The brewing group (13) will start dispensing water (within
30 seconds). Let the water come out for about 30 seconds and then return the
group lever to its initial position.
Note. The lever installed on the group has two functioning positions: either
fully lifted or fully lowered. There are not intermediate positions that guarantee
an optimal performance during coffee brewing.
Attention. Please remember to fully lower the lever to avoid water leaking
from the group.
Now the hydraulic circuit is lled up. The machine will start heating the water to
reach the pre-set values. This operation requires maximum 24 minutes: the pilot
light (5) remains rmly on, while the pilot light (4) ashes.
The machine is ready for use when the 2 pilot lights (4, 5) and the lighted frame
of the ON/OFF (8) switch are rmly on.
Attention. During the heating phase, a small quantity of water will drain in
the drip tray (17). This is normal and conrms the machine correct functioning
(functions check).
Attention. MaraX has the drains into the drip tray. Check the drip tray,
empty, and rinse it periodically!
7. How to install the water softener filter
7.1 7.2 7.3
1
2
min
3
Before installing water softener lter (H) in the water tank (10), immerse the
water softener lter in a jug full of water for about 3 minutes, to eliminate the air
inside the lter that may cause a machine malfunction (Pic 7.1).
10
MaraX - PL62X*
Note. The LELIT water softener lters are composed of sodium-based
cationic resins. These lters placed inside the tank lter the water and capture
the calcium and magnesium salts which would normally precipitate and form
scale deposits in the espresso machine circuit. Once captured, these salts
liberate sodium salts.
The LELIT water lters have a tested autonomy for 35 lt (PLA930S) and 70 lt
(PLA930M): once reached this quantity of water and anyway within 4 months
from the installation, the lter must be changed, because the cationic resin
inside is worn out.
8. Espresso and coffee
8.1 8.2 8.3
1OK
2
Choose your coffee lter, insert it into the lterholder (G) and ll it with the quantity of
ground coffee suggested on the lter. Use the tamper (D) to press the coffee powder
in the lterholder (G). Fix the lterholder (G) into the brewing group (13) and make
sure the handle is aligned with padlock symbol present on the group (Pic 8.1).
Note. With a new machine, it is recommended to moisten the edge of the
lter with some water to help reaching the correct position. After a short use, this
position can be reached without effort.
Place the cup/s under the coffee slide and lift the group lever (14) to start the
coffee extraction (Pic 8.2).
During the extraction phase, the lighted frame of the ON/OFF switch (8) ashes
to indicate that the pump works. Return the group lever (14) to its initial position
to stop the extraction (Pic 8.3).
Attention. Do not take any hot water during coffee brewing (when the lever is lifted).
Take out the lterholder (G) and empty the lter after every coffee extraction.
Otros manuales para PRO Line MaraX PL62X
2
Este manual sirve para los siguientes modelos
5
Tabla de contenidos
Otros manuales de Cafetera de Lelit
Lelit
Lelit PL41QE Manual de usuario
Lelit
Lelit Victoria PL91T Manual de usuario
Lelit
Lelit PL60PLUST Manual de usuario
Lelit
Lelit PL41TEM Manual de usuario
Lelit
Lelit PL042EM Manual de usuario
Lelit
Lelit Pro Line - Mara PL62 Manual de usuario
Lelit
Lelit Elizabeth Manual de usuario
Lelit
Lelit Grace PL81T Manual de usuario
Lelit
Lelit Kate PL82T Manual de usuario
Lelit
Lelit PL042E Manual de usuario
Lelit
Lelit PL042E Manual de usuario
Lelit
Lelit PL41LEM Manual de usuario
Lelit
Lelit PL41TEM Manual de usuario
Lelit
Lelit PL41E Manual de usuario
Lelit
Lelit PL60T Manual de usuario
Lelit
Lelit PL042TEMD Manual de usuario
Lelit
Lelit PL41PLUST Manual de usuario
Lelit
Lelit PL 046 Manual de usuario
Lelit
Lelit PL042EMI Manual de usuario
Lelit
Lelit Pro Line - Mara PL62 Manual de usuario
