User Manual: Rack mounting accesory19”ONE-500 ONE-RMA
2 INSTALLATION
Step View Description
1Joint the frontal piece (F) to the sides (L)
(R) using 4 M3 screws (T3).
2Unfold the steel guide, keeping the fold
edge to the rear side of the rack, match
the rear piece (B) hole to the second last
hole of the steel guide.
Attach the back piece to the side pieces
(L and R) using 2 M3 screws (B3).
3
Screw the rear supports (Rs) using 4 M6
screws (B6) into the rear posts of the
rack. The general installation height of
the ONE-RMA support is determined b
the lower screw of the rear supports that
coincides in height with the position of
the lower screw on the front of the
support.
4Introduce the preassembl of points 1
and 2 in the desired rack position.
3
