Operation
Making a Call using a
Parallel Telephone
You can also make a call on a
parallel (extension) telephone
and then transfer the call to the
Summit conference phone.
The call should be dialled on
your telephone in the normal
way.
When you wish to transfer the
call, press the ON / OFF button
on the conference unit and hang
up the telephone by returning the
handset to its cradle.
Caution : If you do not hang up
the telephone, you may
experience a whistling noise
caused by feedback between the
2 products.
Redial
To call the last number you
dialled on the conference unit,
you can use the Redial function.
Turn the unit ON by pressing the
ON / OFF button and press the
Redial Key.
Note : The Redial function may not
operate under all possible conditions of
connection to PABX equipment. Some
PABX equipment may require a pause
between the line access digit and the
telephone number. A pause is not
available on this product.
Recall
The Summit conference phone
generates a recall signal for use
when connected to an office
PABX (transferring or placing
calls on hold etc.) or when
accessing additional network
services such as call waiting.
With the Pulse / Tone switch set
in the Pulse position, the unit will
generate an Earth recall.
With the switch set to the Tone
position, the unit will generate a
Timed Break Recall (TBR) of
approximately 100mS.
Ringer Equivalence
Number (REN)
If you connect too many devices
to your telephone line, they may
not ring correctly. On each
product you have connected to
your telephone line, will be
printed a REN number. Add
these REN numbers together
and ensure that they do not
exceed a total of 4.
The REN of the Summit
conference phone is 1.
Note : Any unmarked BT
instrument may be assumed to
have a REN of 1.
