Larson Electronics HML-5M-RC Manual de usuario

Larson Electronics LLC www.LarsonElectronics.com sales@larsonelectronics.com

9419 E US HWY 175, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364

HML-5M-RC

FEATURES

Heavy duty motorized remote controlled light rotates with use of wired remote control. Remote

controlled search light contains a 35 watt HID lamp that projects a beam more than 5000 feet. Using

current formulas for adjusted retail candlepower, this light generates 15 million candlepower. Using

more traditional, industrial formula for calculating candlepower, this remote controlled searchlight

generates 600,000 candlepower.

Complete drive unit enclosed in light housing

Designed to be weather and salt water resistant with chrome plated brass housing and base

Control is water resistant with plug-in connections

Sealed beam lamp eliminates destructive corrosion within lamp and reflector

High Intensity discharge (HID) lamp uses electrodes to ignite gas, and contains no filament to

break. Average lamp exceeds 4,000 + hours.

Single control lever and touch pad for vertical and horizontal light movement

Two station operation optional with use of optional dual station kit accessory

LIGHT MOUNTING

Light should be mounted forward for the operator’s position on the boat.

Use the mounting gasket as a template to drill mounting holes. A 7/8" (20 mm) hole is required

to pass the cable plug.

The short base has a line on the mounting flange to indicate the forward positioning of the light.

The cable plug can be pushed below the mounting into the hole or pushed into the base of the

tall base model lights.

The cable is routed through the boat to the control location.

CONTROL MOUNTING

1. Select a location near the helm position to mount the control. Check under the mounting area

to assure there is adequate clearance for the control.

2. Cut 2-3/4" (70 mm) diameter hole for the control and drill two holes for the mounting screws.

3. Power to control must be controlled by the boat running light switch. The searchlight control

has LED illumination that will power on with the boat running lights. The searchlight can only be

used with the running lights on. The running light circuit must be capable of carrying the

following amperage load in addition to the running lights and have a fuse or circuit breaker of

appropriate size.

4. Connect the RED control power lead to the switched side of the running light circuit.

Larson Electronics LLC www.LarsonElectronics.com sales@larsonelectronics.com

9419 E US HWY 175, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364

5. Connect the BLACK control power lead to a battery negative source. DO NOT connect in reverse

polarity, as control damage will result. Use 12-14 gauge wire to extend power leads if necessary.

6. Bring power leads and light cable through hole and plug into back of control.

NOTE: To eliminate electrical interference produced by other electronic components on the

boat that might affect the searchlight control, route the searchlight control cable to the light

away from other components such as radios, GPS receivers and other navigation units.

7. Insert control with attached cables into hole and fasten with screws. A non-adhesive sealing

compound should be used under the control mounting flange.

8. For joy-stick type of control, thread black lever into center hole. For touch-pad operation, insert

black cap into threaded hole.

LIGHT OPERATION

IMPORTANT –Do not shine the searchlight in any manner that will impair the vision of other boat

operators.

The running light switch for the boat must be “ON” for searchlight to operate. With the running

light switch “ON”, the searchlight will be illuminated.

SPOT/SLOW –Press once to select slow light movement and, on spot/flood type lights, to select

flood beam. On lights with spot beam only, this button selects the fast speed only. Press again to

turn light off.

DIRECTIONAL MOVEMENT –The center lever is moved left, right, forward, and back to move

light head. If desired, the center lever can be unscrewed (counter-clockwise) and the black cap

(supplied) can be pressed into the center hole. The light movement is then controlled by

touching one of the four arrows.

AUTO SWEEP –With the light on, pushing this button will sweep the light in about a 90° arc

automatically. This is useful in narrow canals and channels, freeing both hands for boat control.

Press again to stop auto sweep.

SOS/DISTRESS –Press and hold for about 5 seconds to automatically flash SOS signal. The SOS

signal will not be transmitted with the boats running lights “OFF”.

CIRCUIT PROTECTION

The searchlight control has a built-in circuit breaker protection for the searchlight. The breaker

can be reset by turning the light on then off with the running lights on.

On 24 VDC lights, do not operate the light at less than 18 volts. Turn off the light before

recharging battery.

Tabla de contenidos

Otros manuales de Destacar de Larson Electronics

Larson Electronics

Larson Electronics GL-4600-XD Manual

Larson Electronics

Larson Electronics GL-8130 Manual de usuario

Larson Electronics

Larson Electronics HL-85-HID-CPR Manual de usuario

Larson Electronics

Larson Electronics GL-30004-S-E Manual

Larson Electronics

Larson Electronics HID-A1830-WA Manual de usuario

Larson Electronics

Larson Electronics Golight Stryker GL-3049-P Manual

Larson Electronics

Larson Electronics RML-8 Manual de usuario

Larson Electronics

Larson Electronics Golight Radioray 2000 Manual

Larson Electronics

Larson Electronics RL-20 Manual de usuario

Larson Electronics

Larson Electronics HL-85-CPR-MS Manual de usuario

Larson Electronics

Larson Electronics GL-9950 Manual

Larson Electronics

Larson Electronics LE-217 Manual de usuario

Larson Electronics

Larson Electronics RCL700 Manual de operación y mantenimiento

Larson Electronics

Larson Electronics LE Series Manual de usuario

Larson Electronics

Larson Electronics WALTP-Q500 Manual de usuario

Larson Electronics

Larson Electronics HL-85-HID Manual de usuario

Larson Electronics

Larson Electronics Golight 51494 Manual

Larson Electronics

Larson Electronics PTB-1-M Manual de usuario

Larson Electronics

Larson Electronics HUL-LED25WRE-12.3-50GCR-24I Manual de usuario

Larson Electronics

Larson Electronics GL-2000-24 Manual

Larson Electronics

Larson Electronics Golight Radioray GL-2051GT Manual de usuario

Larson Electronics

Larson Electronics HUL-LED25WRE-CPR-TRP Manual de usuario

Larson Electronics

Larson Electronics GL5150-12IR Manual

Larson Electronics

Larson Electronics 2000-M Manual

Manuales populares de Destacar de otras marcas

Guangzhou Yinhe Lighting&Sound Equipment Factory

Guangzhou Yinhe Lighting&Sound Equipment Factory NE-204 Manual de usuario

LIVARNO home

LIVARNO home 375304 2101 Instrucciones originales

Cameo

Cameo CLQS40WW Manual de usuario

Leviton

Leviton Ellipsoid 5/50 Manual de usuario

Monacor

Monacor img Stage Line PARL-56PDX/CR Manual de usuario

Vector

Vector SL3AKV Manual de usuario

Quantum

Quantum Q262 Manual operacional

Philips

Philips Vari-lite VL3015LT Manual de usuario

EUROSPOT

EUROSPOT C51 Manual de usuario

DTS

DTS MINI BRICK ARC Manual de usuario

Federal Signal Corporation

Federal Signal Corporation VISIBEAM II Manual

ACME

ACME LED-MS350B Manual de usuario

EuroLite

EuroLite Akku flat light 1 Manual de usuario

Commercial Electric

Commercial Electric SPTM-1401 Manual de usuario

Vision & Control

Vision & Control SLB-500-W5K7-P-SL Manual de usuario

Teknik

Teknik FLEXI Manual de usuario

Craftsman

Craftsman CMXLSB10 Manual de usuario

EuroLite

EuroLite LED SLS-144 UV Floor Spot Manual de usuario