Larson Electronics EPLC2-LED-150W-RT-JB2 Manual de usuario

EPLC2-LED-150W-RT-JB2

Larson Electronics, LLC Phone: Fax: (903) 498-3364 www.larsonelectronics.com

1of 3

•Be certain electrical power is OFF before and during installation and maintenance.

•Luminaire must be connected to a wiring system with an equipment-grounding conductor.

To avoid explosion:

•Make sure the supply voltage is within the luminaires’ voltage rating.

•Ensure the marked T rating is less than the ignition temperature of the Hazardous

Atmosphere.

•Do not operate in ambient temperatures above those indicated on the luminaire nameplate.

•Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.

For supply connections, use wire rated for at least 110°C

Recommended mounting height is 25-40 feet.

MOUNTING

This fixture offers an adjustable surface mounting system that allows this fixture to be mounted to any

flat surface including walls and ceilings. A single ½-13 bolt is used to mount the fixture to the

surface.

1. Using bolts, washers and nuts provided, attach brackets “A” toboth sides of

bracket “B”.

2. The LED fixture has 12 holes for a versatile mount option. Select the holes that you would like

to use for the mount angle.

3. Brackets “A” will then be bolted to the LED fixture with the remaining bolts and washers.

4. The fixture is now ready for installation.

150 Watt Explosion Proof LED Flood Light

Surface Mount - 21,000 Lumens - C1D2 - Wiring Hub

Instruction Manual

This explosion proof lightis designed for illumination of industrial locations. It uses the latest in solid

state lighting technology for long life, low maintenance and high efficiency.

The unique design focuses the light where it is needed, giving improved efficiency over a

conventional HIDluminaire.

An internal, universal input, power-factor-corrected switch-mode supplyallowsit to be used from any

nominal100-277V AC 50/60 Hz or 11-25V AC/DC power supply(depending on model) without

any variation in light output.See product label for correct input voltage.

WARNING

To avoidthe risk of fire,explosion or electric shock, thisproduct should be installed, inspected

and maintained by a qualified electricianonly, in accordancewith all applicableelectrical codes.

To avoidelectric shock:

(877) 348-9680

EPLC2-LED-150W-RT-JB2

Larson Electronics, LLC Phone: Fax: (903) 498-3364 www.larsonelectronics.com

2of 3

See Images Below as a Reference

BRACKETS A

BRACKET B

BRACKETS A

BRACKET B

(877) 348-9680

EPLC2-LED-150W-RT-JB2

Larson Electronics, LLC Phone: Fax: (903) 498-3364 www.larsonelectronics.com

3of 3

WIRING (see attached wiring diagram)

This unit comes preconfigured in the selected voltage, beam configuration, and color temperature.

Wire light to the correct voltage using the applicable diagram below.Follow allapplicable local,

state, and National Electrical Code for thehazardous area!

MAINTENANCE

Caution: To avoid personal injury, disconnect power to the light and allow the unit to cool

down before performing maintenance.

Warning: No user serviceable parts inside of fixture. Risk of electric shock. Removal of the lens

will void the warranty.

1. Perform visual, mechanical and electrical inspections on a regular basis. We recommend

routine checks to be made on a yearly basis. Frequency of use and environment should

determine this. It is recommended to follow an Electrical Preventive Maintenance Program

as described in NFPA 70B: Recommended practice for Electrical Equipment.

2. The lens should be cleaned periodically as needed to ensure continued photometric

performance. Clean the lens with a damp, non-abrasive, lint-free cloth. If not sufficient, use

mild soap or a liquid cleaner.

3. Inspect the cooking fins on the luminaire to ensure that they are free of any obstructions

or contamination (i.e. excessive dust build-up). Clean with a non-abrasive cloth if

needed.

4. Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.

WARRANTY

Should further information not covered by these instructions be required, please contact Larson Electronics at

1- or [email protected] for further assistance.

Please visit LarsonElectronics.com for Warranty and Return information.

WARNING: CHECK NAMEPLATE

FOR PROPER VOLTAGE. DAMAGE

FROM IMPROPER VOLTAGE WILL

VOID WARRANTY.

(877) 348-9680

877-348-9680

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.

SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT

SAL[email protected] OR BY PHONE AT 1-877-348-9680 FOR FURTHER ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.

Tabla de contenidos

Otros manuales de Foco de Larson Electronics

Larson Electronics

Larson Electronics EPLC2-LED-150W-RT-JB2-50C Manual de usuario

Larson Electronics

Larson Electronics EPL-LED-150W-RT-DIMM Manual de usuario

Larson Electronics

Larson Electronics HAL-TRN Series Manual de usuario

Larson Electronics

Larson Electronics RCL200-RF Manual de usuario

Larson Electronics

Larson Electronics WAL-SM-MHFL-1000W-50C Manual de usuario

Larson Electronics

Larson Electronics LEDWP-LP-450-KNL-DCM Manual de usuario

Larson Electronics

Larson Electronics EPLC2-LED-150W-RT-DIMM Manual de usuario

Larson Electronics

Larson Electronics HID-22-SL-480V Manual de usuario

Larson Electronics

Larson Electronics EPLC2-WPLED-50W-RT Manual de usuario

Larson Electronics

Larson Electronics WAL-QP-2X-25 Manual de usuario

Larson Electronics

Larson Electronics HAL-LED-174W Manual de usuario

Larson Electronics

Larson Electronics HAL-PRM-150W-LED Manual de usuario

Larson Electronics

Larson Electronics Stryker Light Manual

Larson Electronics

Larson Electronics WAL-QP-4X500-25 Manual de usuario

Larson Electronics

Larson Electronics EPL-LED-150W-RT-JB2-X24V-75C-24W07 Manual de usuario

Larson Electronics

Larson Electronics GLR-FLK-2 Manual de usuario

Larson Electronics

Larson Electronics EPL-LED-2X150W-RT Manual de usuario

Larson Electronics

Larson Electronics GL-4600-F-M-12I Manual

Larson Electronics

Larson Electronics EPL-LED-150W-RT-20-HDBC Manual de usuario

Larson Electronics

Larson Electronics Golight Stryker ST Series Manual

Larson Electronics

Larson Electronics HID-22-SL-3M-GAP Manual de usuario

Larson Electronics

Larson Electronics RL-16-LED-M Manual de usuario

Larson Electronics

Larson Electronics BL24-LED Manual de usuario

Larson Electronics

Larson Electronics EPL-20W-HID-X12V-25-HR Manual de usuario

Manuales populares de Foco de otras marcas

VIZULO

VIZULO Micro Martin Guía del usuario

EuroLite

EuroLite LED IP FL-100 SMD Manual de usuario

Cooper Wheelock

Cooper Wheelock XB12 Manual de usuario

Allen + Roth

Allen + Roth 17624-000 Manual de usuario

ADJ

ADJ 4 STAGE PAK Manual de usuario

Cooper Lighting

Cooper Lighting EGL91SW233 Manual de usuario

Max

Max 37496 Manual de usuario

BEGA

BEGA 85 143 Manual de usuario

Beamz

Beamz 151.226 Manual de usuario

EuroLite

EuroLite LED IP FL-8 Manual de usuario

Ledj

Ledj PERFORMER 36 RGB Manual de usuario

Perel

Perel ELS3 Manual de usuario

Perel

Perel ELS3WD Manual de usuario

LumX

LumX LM 36130 Manual de usuario

Xtricity

Xtricity 4-80053 Manual de usuario

Stahl

Stahl 6521/4 Series Manual de usuario

Ecosense

Ecosense EcoSpec Manual de usuario

Ayrton

Ayrton minipanel FX Manual de usuario