La Crosse Technology WS-9117U Manual de usuario

WS-9117U

Wireless 433 MHz

Temperature Station

Instruction Manual

TABLE OF CONTENTS

Topic Page

Inventory of Contents 3

Quick Setup 4-8

Detailed Setup Guide

Battery Installation 9-11

Setting the Time 11-12

Selecting Units of

Measurement 12-13

Features

Minimum and Maximum

Temperatures 13

Resetting Minimum and

Maximum Temperatures 13-14

Additional remote

temperature sensors

(optional)

14-16

Mounting 17-18

Troubleshooting 19-20

Maintenance and Care 21

Specifications 22-23

Warranty Information 24-28

INVENTORY OF CONTENTS

1. The indoor temperature station (Figure

2. The remote temperature sensor (TX6U)

and mounting bracket. (Figure 2)

3. 3 each, 1/2” Philips screws.

4. One strip of double sided adhesive tape.

5. Instruction Manual and Warranty Card.

ADDITIONAL EQUIPMENT

(not included)

1. 1 Philips screwdriver.

2. 2 Fresh AAA 1.5V batteries.

3. 2 Fresh AA 1.5V batteries.

Figure 2

Figure 1

QUICK SETUP

Hint: Use good quality Alkaline

Batteries and avoid rechargeable

batteries.

1. Have the indoor

temperature station and

remote temperature sensor

3 to 5 feet apart.

2. Batteries should be out of

both units for 10 minutes.

3. Place the batteries into the

remote temperature

sensor first then into the

indoor temperature station.

(All remote temperature sensors must be

started before the indoor temperature

station) 4. DO NOT PRESS ANY

BUTTONS FOR 15

MINUTES.

In this time the indoor temperature

station and remote temperature sensor

will start to talk to each other and the

display will show both the indoor

temperature and an outdoor temperature.

If the indoor temperature station does

not display both temperatures after the

10 minutes please retry the set up as

stated above. After both indoor and

outdoor temperatures are displayed for

15 minutes you can place your remote

temperature sensor outdoors and set

your time.

The remote temperature sensor should

be placed in a dry, shaded area. The

remote temperature sensor has a range

of 80 feet. Any walls that the signal

will have to pass through will reduce

distance. An outdoor wall or window

will have up to 20 feet of resistance and

an interior wall will have up to 10 feet

of resistance. Your distance plus

resistance should not exceed 80 ft. in a

straight line.

NOTE: Fog and mist will not harm

your remote temperature sensor but

direct rain must be avoided.

To complete the set up of your indoor

temperature station after the 15 minutes

have passed please follow the steps

below.

1. Press and hold the “SET/CH”

button for 5 seconds.

Note: A “12h” or “24h” will appear

to the left of the time. (“12h” for

AM/PM, “24h” for military time)

a. To change between “12h”

and “24h” press and

release the “MIN/MAX”

button.

b. When you have your

choice shown on the

display press and release

the “SET/CH” button

once.

2. Degree Fahrenheit will now show.

a. To change between

Fahrenheit and Celsius,

press and release the

“MIN/MAX” button.

b. When you have your

choice shown on the

display press and release

the “SET/CH” button

once.

3. An hour will now be flashing.

a. Press and release the

“MIN/MAX” button until

the correct hour is shown.

Note: When in the 12h mode

there is “PM” displayed under

the word TIME when in the

PM hours. During the AM

hours this area will be blank.

b. When the correct hour is

shown, press and release

the “SET/CH” button

once.

4. A minute will now be flashing.

a. Press and release the

“MIN/MAX” button until

the correct minutes are

displayed.

Press and release the “SET/CH”

button once more and you are done.

DETAILED SETUP GUIDE

I. BATTERY INSTALLATION

A. REMOTE TEMPERATURE

SENSOR

1. Remove the mounting bracket.

2. Remove battery cover

3. Observing the correct polarity, install

2 AA batteries—make sure they do not

spring free, or start-up problems may

occur. Replace cover.

B. INDOOR TEMPERATURE

STATION

Note: After the batteries are installed, DO

NOT press any buttons. This may interfere

with the signals, causing temperatures to

1. Remove the battery cover on the

backside.

2. Observing

the correct

polarity,

install 2 AAA

batteries.

3. Replace

battery cover.

4. Wait 15

minutes

before

pressing any buttons.

Tabla de contenidos

Otros manuales de Estación meteorológica de La Crosse Technology

La Crosse Technology

La Crosse Technology 308-1416v2 Guía de instalación

La Crosse Technology

La Crosse Technology Wireless Weather Station Manual de usuario

La Crosse Technology

La Crosse Technology WS-3512 Manual de usuario

La Crosse Technology

La Crosse Technology WS-1913IT Hoja de especificaciones

La Crosse Technology

La Crosse Technology TX-440-TH Manual de usuario

La Crosse Technology

La Crosse Technology WS-8157U-IT Manual de usuario

La Crosse Technology

La Crosse Technology 328-1415 Manual de usuario

La Crosse Technology

La Crosse Technology 308-146v2 Manual de usuario

La Crosse Technology

La Crosse Technology WW85784 Manual de operación y mantenimiento

La Crosse Technology

La Crosse Technology ED31411 Manual de usuario

La Crosse Technology

La Crosse Technology WS-1913U-IT Manual de usuario

La Crosse Technology

La Crosse Technology WS-7026U Manual de usuario

La Crosse Technology

La Crosse Technology TX5U Manual de usuario

La Crosse Technology

La Crosse Technology 308-1425B Manual de usuario

La Crosse Technology

La Crosse Technology WS-7047TWC Manual de usuario

La Crosse Technology

La Crosse Technology T83646 Manual de usuario

La Crosse Technology

La Crosse Technology WS-2810U-IT Hoja de especificaciones

La Crosse Technology

La Crosse Technology 308-1414M Manual de usuario

La Crosse Technology

La Crosse Technology WS-9035TWC Manual de usuario

La Crosse Technology

La Crosse Technology V21V3 Dimensiones

La Crosse Technology

La Crosse Technology K84315 Manual de usuario

La Crosse Technology

La Crosse Technology WS-9118U Manual de usuario

La Crosse Technology

La Crosse Technology WS6821A Manual de usuario

La Crosse Technology

La Crosse Technology C87214 Guía de instalación

Manuales populares de Estación meteorológica de otras marcas

Auriol

Auriol AHFL 433 A1 Manual de usuario

NexSens

NexSens G2-HYDROMET Manual de usuario

Hyundai

Hyundai WS 2202 Manual de usuario

IROX

IROX HBVR761 UV-X Manual de usuario

ADE

ADE WS 1711 Manual de usuario

Auriol

Auriol z29592 Manual de usuario

Auriol

Auriol 296289 Manual de usuario

Hyundai

Hyundai WS 2266 Manual de usuario

Ventus

Ventus W177 Manual de usuario

National Geographic

National Geographic VA Colour RC Manual de usuario

Renkforce

Renkforce 1208067 Manual de usuario

Levenhuk

Levenhuk Discovery Report WA40 Manual de usuario

Instant Transmission

Instant Transmission MA 10410 Manual de usuario

Lutron Electronics

Lutron Electronics PHB-318 Manual de usuario

WAREMA

WAREMA EWFS Weather station eco Manual de usuario

TFA

TFA 30.3013.IT Manual de usuario

Alecto

Alecto WS-1200 Manual de usuario

Oregon Scientific

Oregon Scientific RMR966PA Manual de usuario