La Crosse Technology WS-9055TWC Manual de usuario

WS-9055TWC

Wireless 433 MHz

Weather Station

Instruction Manual

TABLE OF CONTENTS

Topic Page

Quick Setup 3-5

Inventory of Contents 6-7

Detailed Setup Guide

Battery Installation 7

Setting the Time 8

Features

Minimum and Maximum

Temperatures 9

Resetting Minimum and

Maximum Temperatures 10

Adding additional remote

temperature sensors

(optional)

10-11

Weather Forecast 12

Weather Icons 13-14

Tendency Arrow 14

Mounting 15-16

Troubleshooting 16-18

Maintenance and Care 18-19

Specifications 19-20

Warranty Information 21-26

QUICK SETUP

Hint: Use good quality Alkaline

Batteries and avoid rechargeable

batteries.

1. Have the indoor temperature

station and remote temperature

sensor 3 to 5 feet apart.

2. Batteries should be out of both

units for 10 minutes.

3. Place the batteries into the

remote temperature sensor first

then into the indoor temperature

station.

(All remote temperature sensors must

be started before the indoor

temperature station)

4. DO NOT PRESS ANY

BUTTONS FOR 15 MINUTES.

In this time the indoor temperature

station and remote temperature sensor

will start to talk to each other and the

display will show both the indoor

temperature and an outdoor

temperature. If the indoor

temperature station does not display

both temperatures after the 15

minutes please retry the set up as

stated above. After both indoor and

outdoor temperatures are displayed

for 15 minutes you can place your

remote temperature sensor outdoors

and set your time.

The remote temperature sensor

should be placed in a dry, shaded

area. The remote temperature sensor

has a range of 80 feet. Any walls that

the signal will have to pass through

will reduce distance. An outdoor

wall or window can have up to 30

feet of resistance and an interior wall

can have up to 20 feet of resistance.

Your distance plus resistance should

not exceed 80 ft. in a straight line.

NOTE: Fog and mist will not harm

your remote temperature sensor but

direct rain must be avoided.

To complete the set up of your indoor

temperature station after the 15

minutes have passed please follow the

steps in the detailed set up guide on

page 8.

INVENTORY OF CONTENTS

1. The indoor weather station (Figure

2. The remote temperature sensor

(TX6U) and mounting bracket.

(Figure 2)

3. 3 each, 1/2” Philips screws.

4. One strip of double sided adhesive

tape.

5. Instruction Manual and Warranty

Card.

ADDITIONAL EQUIPMENT

(not included)

1. 1 Philips screwdriver.

2. 2 Fresh AA Alkaline batteries.

3. 2 Fresh AA Alkaline batteries

DETAILED SETUP

GUIDE

Battery Installation

Figure 2

Holder

Figure 1

1. Install 2 AA batteries in the remote

temperature sensor. Make sure they

do not spring free, or start-up

problems may occur.

2. Install 2 AA batteries in the indoor

weather station. Do not press any

buttons for

at least

fifteen

minutes.

Setting the time

1. Press and hold the “SET” key for 4

seconds.

2. The hour will flash.

3. Press and release the “+” key to

advance the hour.

4. Press and release the “SET” key.

5. The minute is flashing.

6. Press and release the “+” key to

advance the minutes.

7. Press and release the “SET” key to

exit programming.

FEATURES

Minimum and Maximum

Temperatures

1. Press and release the “MIN/MAX”

button, “MAX” appears between the

indoor and remote temperatures.

2. The recorded maximum indoor and

remote temperature is displayed.

3. Press and release the “MIN/MAX”

button.

4. “MIN” appears between the indoor

and remote temperatures.

5. The recorded minimum temperature

is displayed.

6. Press and release the “MIN/MAX”

button to exit min/max mode.

7. To view optional additional sensors,

press and release the “CH” button

while viewing the minimum or

maximum temperatures.

Resetting Min and Max Temperatures

To reset both the minimum and

maximum temperatures—press and

hold the “MIN/MAX” button for 5

seconds.

Adding Additional Remote

Temperature Sensors (optional)

The WS-9055U is able to receive

signals from 3 different remote

temperature sensors. Following are

some brief instructions for the basic

set-up of remote temperature sensor

units with the WS-9055U. These extra

remote temperature sensors can be

purchased through the same dealer as

this unit, or by contacting La Crosse

Technology directly. A TX6U will

monitor temperature only, a TX3U

will monitor temperature and display

the temperature on its LCD, and the

TX3UP will monitor the temperature

of water or soil via a probe.

When setting up multiple remote

temperature sensors, it is important to

remove the batteries from all existing

units in operation, then to insert

batteries first into all the remote

temperature sensors. Second install

batteries into the indoor weather

station and do not press any buttons

for ten minutes. Transmission

problems will arise if this is not done

correctly.

To view the temperature of a different

remote temperature sensor unit, press

and release the “CH” button. A shift

from one number to the next should

be observed in the OUTDOOR LCD.

Otros manuales para WS-9055TWC

Tabla de contenidos

Otros manuales de Estación meteorológica de La Crosse Technology

La Crosse Technology

La Crosse Technology WS1506 Manual de usuario

La Crosse Technology

La Crosse Technology WS-9023U-IT Dimensiones

La Crosse Technology

La Crosse Technology W85777 Manual de usuario

La Crosse Technology

La Crosse Technology WS-9014TWC Manual de usuario

La Crosse Technology

La Crosse Technology 308-1425CA Manual de usuario

La Crosse Technology

La Crosse Technology WW85777v2 Manual de operación y mantenimiento

La Crosse Technology

La Crosse Technology 79400 Manual de usuario

La Crosse Technology

La Crosse Technology 328-10618 Manual de usuario

La Crosse Technology

La Crosse Technology WS-2811U-IT Hoja de especificaciones

La Crosse Technology

La Crosse Technology WS-2306 Manual de usuario

La Crosse Technology

La Crosse Technology V22-WRTHV2 Manual de usuario

La Crosse Technology

La Crosse Technology Tomorrow's Weather Today WS-7394U-IT Manual de usuario

La Crosse Technology

La Crosse Technology WS-9037U-IT Manual de usuario

La Crosse Technology

La Crosse Technology L78571 Manual de usuario

La Crosse Technology

La Crosse Technology Wireless Weather Station Manual de usuario

La Crosse Technology

La Crosse Technology WS-9611U-IT Manual

La Crosse Technology

La Crosse Technology CA85176 Manual de usuario

La Crosse Technology

La Crosse Technology WS-7078UF Manual de usuario

La Crosse Technology

La Crosse Technology WS-2310 Manual de usuario

La Crosse Technology

La Crosse Technology WS-1516-IT Guía de instalación

La Crosse Technology

La Crosse Technology WS-9005TWC-IT Manual de usuario

La Crosse Technology

La Crosse Technology CA79103v2 Manual de usuario

La Crosse Technology

La Crosse Technology C85845v4 Manual de usuario

La Crosse Technology

La Crosse Technology WS-9037U-IT Manual de usuario

Manuales populares de Estación meteorológica de otras marcas

Auriol

Auriol AHFL 433 A1 Manual de usuario

NexSens

NexSens G2-HYDROMET Manual de usuario

Hyundai

Hyundai WS 2202 Manual de usuario

IROX

IROX HBVR761 UV-X Manual de usuario

ADE

ADE WS 1711 Manual de usuario

Auriol

Auriol z29592 Manual de usuario

Auriol

Auriol 296289 Manual de usuario

Hyundai

Hyundai WS 2266 Manual de usuario

Ventus

Ventus W177 Manual de usuario

National Geographic

National Geographic VA Colour RC Manual de usuario

Renkforce

Renkforce 1208067 Manual de usuario

Levenhuk

Levenhuk Discovery Report WA40 Manual de usuario

Instant Transmission

Instant Transmission MA 10410 Manual de usuario

Lutron Electronics

Lutron Electronics PHB-318 Manual de usuario

WAREMA

WAREMA EWFS Weather station eco Manual de usuario

TFA

TFA 30.3013.IT Manual de usuario

Alecto

Alecto WS-1200 Manual de usuario

Oregon Scientific

Oregon Scientific RMR966PA Manual de usuario