La Crosse Technology WS-9002U Manual de usuario

WS-9002U

Wireless 433 MHz

Temperature Station

Instruction Manual

TABLE OF CONTENTS

Topic Page

Inventory of Contents 3

Quick Setup 4-6

Detailed Setup Guide

Battery Installation 7-8

Features

Minimum and Maximum

Temperatures 9

Resetting Minimum and

Maximum Temperatures 9

Additional remote

temperature sensors

(optional)

10-12

Mounting 12-14

Troubleshooting 14-16

Maintenance and Care 16

Specifications 17-18

Warranty Information 19-23

INVENTORY OF CONTENTS

1. The indoor temperature station (Figure

2. The remote temperature sensor (TX6U)

and mounting bracket. (Figure 2)

3. 3 each, 1/2” Philips screws.

4. One strip of double sided adhesive tape.

5. Instruction Manual and Warranty Card.

ADDITIONAL EQUIPMENT

(not included)

1. 1 Philips screwdriver.

2. 2 Fresh AAA 1.5V batteries.

3. 2 Fresh AA 1.5V batteries.

Figure 2

Figure 1

QUICK SETUP

Hint: Use good quality Alkaline

Batteries and avoid rechargeable

batteries.

1. Have the indoor

temperature station and

remote temperature sensor

3 to 5 feet apart.

2. Batteries should be out of

both units for 10 minutes.

3. Place the batteries into the

remote temperature

sensor first then into the

indoor temperature station.

(All remote temperature sensors must be

started before the indoor temperature

station) 4. DO NOT PRESS ANY

BUTTONS FOR 15

MINUTES.

In this time the indoor temperature

station and remote temperature sensor

will start to talk to each other and the

display will show both the indoor

temperature and an outdoor temperature.

If the indoor temperature station does

not display both temperatures after the

15 minutes please retry the set up as

stated above. After both indoor and

outdoor temperatures are displayed for

15 minutes you can place your remote

temperature sensor outdoors and set

your time.

The remote temperature sensor should

be placed in a dry, shaded area. The

remote temperature sensor has a range

of 80 feet. Any walls that the signal

will have to pass through will reduce

distance. An outdoor wall or window

will have up to 20 feet of resistance and

an interior wall will have up to 10 feet

of resistance. Your distance plus

resistance should not exceed 80 ft. in a

straight line.

NOTE: Fog and mist will not harm

your remote temperature sensor but

direct rain must be avoided.

DETAILED SETUP GUIDE

I. BATTERY INSTALLATION

A. REMOTE TEMPERATURE

SENSOR

1. Remove the mounting bracket.

2. Remove battery cover

3. Observing the correct polarity, install

2 AA batteries—make sure they do not

spring free, or start-up problems may

occur. Replace cover.

B. INDOOR TEMPERATURE

STATION

Note: After the batteries are installed, DO

NOT press any buttons. This may interfere

with the signals, causing temperatures to

1. Remove the battery cover on the

backside.

2. Observing the correct polarity, install

2 AAA batteries.

3. Replace battery cover.

4. Wait 15

minutes before

pressing any

buttons.

II. FEATURES

A. MINIMUM AND MAXIMUM

TEMPERATURES

1. Press and release the “MIN/MAX”

button, “MIN” appears in the

temperature LCD’s and the recorded

minimum temperatures are displayed.

2. Press and release the “MIN/MAX”

button to toggle to the maximum

temperatures.

B. RESETTING THE MINIMUM AND

MAXIMUM TEMPERATURES

1. To reset both the minimum and

maximum temperatures—press and

hold the “MIN/MAX” button for 5

seconds.

C. ADDING ADDITIONAL

REMOTE TEMPERATURE

SENSORS (OPTIONAL)

1. The WS-9002U is able to receive

signals from 3 different remote

temperature sensors. Following are

some brief instructions for the basic

set-up of remote temperature sensor

units with the WS-9002U. These extra

sensors can be purchased through the

same dealer as this unit, or by

contacting La Crosse Technology

directly. A TX6 will monitor

temperature only, a TX3U will

monitor temperature and display the

temperature on its LCD, and the

TX3UP will monitor the temperature

via a probe for use in pools, spas, etc.

Note: When setting up multiple units it

is important to remove the batteries

from all existing units in operation,

then to insert batteries first into all the

remote temperature sensor units, and in

numeric sequence. Second, install

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Estación meteorológica de La Crosse Technology

La Crosse Technology

La Crosse Technology WS-7090U Manual de usuario

La Crosse Technology

La Crosse Technology 308-1415BWV2 Manual de usuario

La Crosse Technology

La Crosse Technology WS-1516-IT Guía de instalación

La Crosse Technology

La Crosse Technology WS-7391U Manual de usuario

La Crosse Technology

La Crosse Technology WS-9520U Manual de usuario

La Crosse Technology

La Crosse Technology WS1600IT Manual de usuario

La Crosse Technology

La Crosse Technology 9730IT Manual de usuario

La Crosse Technology

La Crosse Technology WS-9124TWC-IT Manual de usuario

La Crosse Technology

La Crosse Technology WS-7075U Manual de usuario

La Crosse Technology

La Crosse Technology WS-2812U-IT Manual de usuario

La Crosse Technology

La Crosse Technology WS-7044U Manual de usuario

La Crosse Technology

La Crosse Technology WS-9611U Manual de usuario

La Crosse Technology

La Crosse Technology WS 550 US Manual de usuario

La Crosse Technology

La Crosse Technology T84237 Manual de operación y mantenimiento

La Crosse Technology

La Crosse Technology WD-2511U Guía de instalación

La Crosse Technology

La Crosse Technology WS-9014 Manual de usuario

La Crosse Technology

La Crosse Technology V21v4 Manual de usuario

La Crosse Technology

La Crosse Technology C75747-AU Manual de usuario

La Crosse Technology

La Crosse Technology WS-3512 Manual de usuario

La Crosse Technology

La Crosse Technology 308-1416v2 Manual de usuario

La Crosse Technology

La Crosse Technology WS-7013U Manual de usuario

La Crosse Technology

La Crosse Technology WS-7091 Manual de usuario

La Crosse Technology

La Crosse Technology WS-2310 Manual de usuario

La Crosse Technology

La Crosse Technology 308-1414MBv2 Manual de operación y mantenimiento

Manuales populares de Estación meteorológica de otras marcas

Auriol

Auriol AHFL 433 A1 Manual de usuario

NexSens

NexSens G2-HYDROMET Manual de usuario

Hyundai

Hyundai WS 2202 Manual de usuario

IROX

IROX HBVR761 UV-X Manual de usuario

ADE

ADE WS 1711 Manual de usuario

Auriol

Auriol z29592 Manual de usuario

Auriol

Auriol 296289 Manual de usuario

Hyundai

Hyundai WS 2266 Manual de usuario

Ventus

Ventus W177 Manual de usuario

National Geographic

National Geographic VA Colour RC Manual de usuario

Renkforce

Renkforce 1208067 Manual de usuario

Levenhuk

Levenhuk Discovery Report WA40 Manual de usuario

Instant Transmission

Instant Transmission MA 10410 Manual de usuario

Lutron Electronics

Lutron Electronics PHB-318 Manual de usuario

WAREMA

WAREMA EWFS Weather station eco Manual de usuario

TFA

TFA 30.3013.IT Manual de usuario

Alecto

Alecto WS-1200 Manual de usuario

Oregon Scientific

Oregon Scientific RMR966PA Manual de usuario