La Crosse Technology LTV-R2 Manual de usuario

Model: LTV-R2

DC: 090517

Rain Sensor

Insert 2- AA batteries into the rain sensor according to polarity.

1. Flip open both locking tabs on your rain sensor and lift o the funnel portion.

2. Pull up on the battery cover and remove.

3. Install 2-AA batteries according to polarity. Reposition the battery cover over the battery compartment,

and ﬁrmly push down to lock it back into place

5. Remove cardboard and any tape around the rocker before use. These were used to protect the

sensor from unwanted movement during shipping.

6. Place the funnel portion back over the sensor and re-secure the locking tabs.

Power

Funnel

Battery Cover

Locking Tab

Remove piece under

rocker of rain sensor

Position Rain Sensor

LTV-R2 Rain Sensor

Lets identify the parts of the rain sensor.

• Mount your rain sensor in an open area for a more accurate rain count.

• Placing the rain sensor on the ground provides the most accurate rainfall measurement as there is no

wind shear. Unfortunately, since insects think of rain sensors as personal hotels, placing your sensor

3-6 feet above ground may deter the insects.

• This is a self-emptying sensor, but be sure your unit is not sitting in a depression that would prevent

rain from draining out of the bottom

• Your rain sensor should be accessible to allow for periodic cleaning of leaves or other debris that may

clog the funnel.

• Install the Rain sensor on a level platform that is stationary and has a direct line of sight to your station.

• Insert mounting screws through the holes in the base of the rain sensor. Do not over tighten.

• Use the bubble level inside your sensor to be sure it is level.

• Avoid other wireless rain sensors as this can cause inaccuracy due to signal interference.

• The maximum wireless transmission range to the rain station is over 400 feet (121 meters) in open air,

not including walls or ﬂoors.

• For video instruction, please visit: http://bit.ly/Rain_SensorMounting

Top (Funnel)

Battery Cover

Locking Tabs

Rocker

Mounting Screw (3 total) Bubble Level

Clean Rain Sensor

1. Press the Locking Tabs on each end and lift o the funnel.

2. Gently remove debris or insects inside the rain sensor.

3. Clear debris from drain vents.

4. Clear debris from the rain funnel itself.

5. Reinstall the rain funnel.

Note: Do not oil the rain sensor.

Sensor ID

Standalone station:

Your rain sensor has a bar code and ID number. This ID number locks your sensor into

your station. Follow the instructions in your station manual to delete the sensor ID

for sensor replacement.

La Crosse View™ compatible system:

The rain sensor ID and bar code are recognized by the La Crosse View™ app if you are using

this rain sensor as an add-on to your existing La Crosse View™ compatible system.

To add this sensor to your existing La Crosse View™ compatible system:

1. Open your La Crosse View™app to add sensors.

2. From Main Menu - select “Devices” under “Add/Edit”

3. On Edit Devices page - select “ADD DEVICE”

4. Scan Device ID - Scan the bar code on your sensor or press inside the Device ID search box to enter

your code manually. Once entered, select “Search”.

5. On Conﬁrm Device page - Conﬁrm the sensor image and model number are correct and select “YES”

6. On Enter Device and Location Names page - enter Device Name and select a location or enter

a Location Name for your sensor. Select “DONE”.

Note: This rain sensor cannot connect to the La Crosse View app without a La Crosse View compatible

station. Station’s that are La Crosse View compatible have built-in Wi-Fi capabilities that send your rain

sensor’s data to the La Crosse View app. For more information about our new connected stations visit:

http://www.lacrossetechnology.com/products/connected

Note: When multiple rain sensors are used in close proximity false readings may occur.

JOIN THE CONVERSATION

giveaways.

Let’s Be Social!

Warranty and Support

La Crosse Technology, Ltd. provides a 1-year limited time warranty (from date of purchase) on this product relating to

manufacturing defects in materials & workmanship. Before returning a product, please contact our friendly customer support

with questions or visit our online help:

Phone: 1-608-782-1610

Online Product Support and Registration: www.lacrossetechnology.com/support

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the

equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device must not be co-located or operating in conjunction with any other antenna or transmitter.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation.

Caution!

The manufacturer is not responsible for any radio or TV interference caused by unauthorized changes or modiﬁcations to this

equipment. Such changes or modiﬁcations could void the user authority to operate the equipment.

This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this

transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located

or operating in conjunction with any other antenna or transmitter

electronic, mechanical or chemical process without the written permission of the publisher. This booklet may contain errors or

misprints. The information it contains is regularly checked and corrections are included in subsequent editions. We disclaim

any responsibility for any technical error or printing error, or their consequences.

All trademarks and patents are recognized.

Speciﬁcations

• Rainfall: 0-393.6 inches (0-9999 mm)

• Transmission Range: 400 ft (121 m) RF 915MHz open air

• Batteries: 2-AA, IEC, LR6 batteries (not included)

• Battery Life: over 24 months with reputable batteries

• Dimensions: 7.14” L x 3.43” W x 4.94” H (18.13cm L x 8.72cm W x 12.54cm H)

If you have ideas for features or support solutions you’d like to see us make, please let us know! We truly want to make own-

ing a La Crosse Technology product not only a practical experience, but also a fun one.

So email us at: store@lacrossetechnology.com

Help Us, Help You!

Tabla de contenidos

Otros manuales de Accesorios de La Crosse Technology

La Crosse Technology

La Crosse Technology TX6 Manual de usuario

La Crosse Technology

La Crosse Technology TX9U Manual de usuario

La Crosse Technology

La Crosse Technology LTV-THP1-T1 Manual de usuario

La Crosse Technology

La Crosse Technology CA79097 Manual de usuario

La Crosse Technology

La Crosse Technology TX60U-IT Manual de usuario

La Crosse Technology

La Crosse Technology CYCLONE PRO SENSOR Manual de usuario

La Crosse Technology

La Crosse Technology TX24U Manual de usuario

La Crosse Technology

La Crosse Technology TX21U Manual de usuario

La Crosse Technology

La Crosse Technology LTV-POOLv2 Manual de usuario

La Crosse Technology

La Crosse Technology LTV-R1 Manual de usuario

La Crosse Technology

La Crosse Technology TX-63U-IT Manual de usuario

La Crosse Technology

La Crosse Technology D012.104.E1 Manual de usuario

La Crosse Technology

La Crosse Technology Breeze Pro LTV-WSDTH03 Manual de usuario

La Crosse Technology

La Crosse Technology TX146 Manual de usuario

La Crosse Technology

La Crosse Technology TX14RBL Manual de usuario

La Crosse Technology

La Crosse Technology TX5 Manual de usuario

La Crosse Technology

La Crosse Technology TX-23U Manual de usuario

La Crosse Technology

La Crosse Technology TX23U Manual de usuario

La Crosse Technology

La Crosse Technology TX8U Manual de usuario

La Crosse Technology

La Crosse Technology WCLTV-WSDR1 Manual de usuario

La Crosse Technology

La Crosse Technology Alerts TX60U-IT Manual de usuario

La Crosse Technology

La Crosse Technology Outdoor Temperature/Humidity Sensor TX7U Manual de usuario

La Crosse Technology

La Crosse Technology TX141-B4 Manual de usuario

La Crosse Technology

La Crosse Technology TX15U Manual de usuario

Manuales populares de Accesorios de otras marcas

Hillco

Hillco 2810 Manual de usuario

Siemens

Siemens QSA2700D Manual del operador

Contours

Contours ZY024 Manual de usuario

Saivod

Saivod VS621 Manual de usuario

Virtuox

Virtuox VirtuCLEAN 2.0 Manual de usuario

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Manual de usuario

Z-Wave

Z-Wave HSD-200Z Manual de usuario

turck

turck FMX-IM-2UPLI63FX Manual de usuario

Decagon Devices

Decagon Devices 10HS Manual de usuario

UPPAbaby

UPPAbaby Cup Holder Manual de usuario

Elko

Elko SmartSensor Leakage Wireless Manual de usuario

Grizzly

Grizzly H8371 Manual de usuario

Panasonic

Panasonic HG-T Series Manual de usuario

IFM Electronic

IFM Electronic Efector 250 Series Guía de referencia

DigiDesign

DigiDesign 888/24 I/O Manual de usuario

PROZIS

PROZIS QUAY Manual de usuario

patagonia

patagonia PSI Vest Manual de usuario

SFC Energy

SFC Energy EFOY GO! Manual de usuario