Kyutec KT1050 Manual de usuario
CAMERA WATCH
Kamera-Uhr
INSTRUCTION MANUAL
BEDIENUNGSANLEITUNG
Page size: 50 x 55 mm
2
EN
Safety Guidelines
• Read the information in this user manual about
safety when using the product carefully.
• Always keep this user manual ready at hand.
• Check if the product is undamaged and all parts are
present and undamaged.
• Keep children away from the packaging material.
• Store the product away from children.
Intended Use
• Use the product only according to the description
in this user manual.
• The product is not a toy. Keep children away from
the product.
• Do not use the product in the bathroom.
• Protect the product from impact and falling from
shelves, tables or furniture.
• Protect the product from wetness, moisture, heat
and strong sunlight.
• The product does not contain any parts you are
3
EN
able to repair. Do not open the case of the product.
Unauthorized opening or repairs can lead to serious
damage of the product and injuries of the operator.
• Let only an authorized specialist dealer repair
the product.
• Make sure that only original parts or parts with
specications stated in the product characteristics
are used for repair or replacement.
Electrical Connection
• Make sure before charging the device with the
charger that there are no exterior damages, kinks
or cracks.
• During thunderstorm or danger of voltage
uctuations remove the charger cable.
• Make sure that the charger cable is not kinked,
hangs over sharp edges and does not touch warm
surfaces during operation.
• Do not allow the charger cable to contact with
water or other liquids.
• Attention: Please insert the USB cable rst into the
watch and then to PC, to avoid short circuits.
Do not replace any parts yourself.
4
EN
Items to observe during Operation
• Do not use the device, if it does not function
properly, has fallen down or has been damaged,
became wet or has been submerged in water.
• Note the conditions for proper storage and the
information about care and cleaning in this user
manual
Your Watch with integrated Camera
Contents
1x watch with integrated camera
1x Mini Smart Phone Macro Lens
1x USB charger cable
1x additional crown
1x user manual
5
EN
Use of the Device
Inserting Batteries
This camera has a built-in lithium-ion rechargable
Battery. For charging, connect the watch to your
PC with the included charger cable. Turn othe
corresponding crown (USB charger connector)
Operating mode
Photo / Audio
USB/Charger
connection
Power on/o
Operating mode Video
Built-in camcorder
Status LED
Microphone
Time Adjust
6
EN
and connect the charger cable. The red LED lights
continuously ashes while the device is being
charged.
When the battery becomes too low during use, the
device switches oautomatically and saves the
recorded le.
Switching On:
Press the power on/okey for about 3 seconds until
the red LED lights up. When the LED changes from
red to continuous blue, the device is operational
standby mode.
Switching Off:
Press the power on/okey until the red LED ashes
quickly three times. Attention: In stand-by mode the
device switches oautomatically after 3 minutes,
when no video, photo or audio is recorded.
7
EN
Selection of Recording Mode:
The device possesses 3 recording modes, which can
be selected and operated with the mode key; Video
recording, Photo shooting and Audio recording.
• After switching on the device is in Video mode. The
Blue LED lights up continuously.
• Press the mode key to change to Photo/Audio
mode. Red LED ligths indicate.
Recording a Video:
In video mode press the recording key briey. The
recording starts. This is conrmed by the Blue LED
ashing three times. During recording no LED
ashes. Press the recording key twice briey to stop
the recording. Start recording again is conrmed by
the blue LED ashing three times.
8
EN
Taking Photos:
In Photo mode press the recording key briey. The
recording is conrmed by a short ashing of the Red
LED. The photo is saved, afterwards the blue LED
lights up and the device is operational again.
Audio Recording
In Audio mode press the recording key 2 seconds.
The reording is conmred by alternative ashing of
the Red LED. Press the operation key briey to stop
the recording, the audio is saved, afterwards the blue
LED lights up and the device is operational again.
Time and Date Stamp:
This device displays the recording date in the format
(year, month: day hour: minute: second), this data is
also recorded. To synchronize the device with the
current data, do the following:
• Create on your PC a text le with the editor (right-
9
EN
click on the desktop, “new” text document)
• Enter in the rst line for example.
• 01.01.2012, 20:30 o’clock and 10 seconds: 2012.01.01
20:30:10.
• Save this le as “time” (the sux .txt should be
entered automatically).
• Connect the watch to your PC.
• Copy the le to the main folder of your watch.
• Remove the USB cable and restart the device.
After switching on the data is taken over. (the le
disappears from the main folder, the settings are
kept)
Transfering Image to PC
Charge the built-in battery
/ charge the build - in battery
10
EN
Switch offthe device
Unscrew the “USB connector” cover, and then insert
the cable to connect to the PC. The red LED lights
ashes continously while the data is transferring or
the device is beging charged.
Setting the Time:
Pull out the crown (Time Adjust) to stop the watch
and turn it to set the desired time.
Storage
• Turn othe device.
• Keep the device in the original packaging in a clean
and dry place.
• Protect the device from dirt, dust, heat, moisture
and wetness.
Switch off the device and
unscrew
Tabla de contenidos
Idiomas:
