Kohler K-2276 Manual de usuario

Installation Guide

Self-Rimming/Above Countertop Lavatory

Mproduct numbers are for Mexico (i.e. K-12345M)

Los números de productos seguidos de

Mcorresponden a México (Ej.

K-12345M)

Français, page “Français-1”

Español, página “Español-1”

K-2276

1018897-2-A

Tools and Materials

Thank You For Choosing Kohler Company

We appreciate your commitment to Kohler quality. Please take a few

minutes to review this manual before you start installation. If you

encounter any installation or performance problems, please don’t

hesitate to contact us. Our phone numbers and website are listed on

the back cover. Thanks again for choosing Kohler Company.

Before You Begin

Observe all local plumbing and building codes.

Never rest or store the lavatory on the drain surface.

CAUTION: Risk of personal injury or product damage. This

lavatory is made of glass. Always use the same extreme care

appropriate for ﬁne china when handling to avoid breakage.

Prior to installation, unpack the new lavatory and inspect it for

damage. Return the lavatory to its protective carton until you are

ready to install it.

Inspect the drain and supply tubing. Replace if necessary.

These instructions are for installing the lavatory to wood frame

construction. For other installations, supply suitable bracing and

fastening devices of sufficient size and strength.

Do not substitute another sealant if one is supplied with this

lavatory.

Use the template supplied with the lavatory.

Plus:

1/2" drill bit

Hole saw

Safety shoes

50/50 mix of isopropyl

alcohol and water

Pencil Drill

Keyhole Saw

Scissors Sealant

Template

(supplied)

Tape

Measure

Adjustable

Wrench

Safety

Glasses

1018897-2-A 2KohlerCo.

Before You Begin (cont.)

For replacement installations, make sure the existing cutout is the

same size or smaller than needed for the new lavatory.

Refer to the roughing-in information to ensure proper installation

for ADA applications.

Use these instructions for wall-mount, self-rimming and above

counter installations. Follow only the instructions that apply to

your installation.

You can choose between a wall-mount or countertop faucet

installation, depending upon the setting and styling you desire. A

wall-mount faucet is recommended.

To ease forming of the supplied adhesive seal, install this lavatory

when the temperature is between 70° (21 C) and 100° F (38 C).

KohlerCo.31018897-2-A

1. Preparation

Install the water supplies and drain piping according to the

roughing-in information.

Wall-Mount Bracket Installations

Install the lavatory according to the instructions packed with the

bracket.

Self-Rimming Installations

Determine the faucet centerline location. Consider the faucet and

handle escutcheon diameters, the length of the spout, and the

clearance between the spout and the lavatory rim.

Calculate the faucet centerline measurement by ﬁrst dividing the

escutcheon diameter by 2, and then add 1/4″(6mm) to the result.

If necessary, round the calculation up to the nearest 1/16″(2mm).

Carefully draw the calculated faucet centerline on the cut-out

template. Choose the most suitable location based upon the

following factors:

•compliance with all local plumbing codes

•minimum 2″(5.1cm) distance from the water stream to the

lavatory rim edge. This is important to ensure adequate clearance

for hand washing

•a minimum 1/4″(6mm) distance between the faucet spout and

the lavatory rim

Countertop

2" (5cm)

Min.

Backsplash

Locator Line Faucet

Centerline

Self-Rimming

Cut-Out

Above Counter

Cut-Out

Template

1" (2.5cm)

Min.

Clearance

1/4" (6mm) Min.

2" (5cm)

Min.

Divide Escutcheon

Diameter in Half,

Then Add 1/4" (6mm)

1018897-2-A 4KohlerCo.

Preparation (cont.)

Redraw the faucet centerline as needed to meet these

requirements.

Draw a line on the cut-out template a minimum of 2″(5.1cm)

behind the ﬁnal faucet centerline. This is the minimum

backsplash locator line.

NOTE: Some Kohler faucets require a minimum of 2-1/2″(6.4cm)

behind the ﬁnal faucet centerline.

Cut along the backsplash locator line on the template.

Cut out the template along the inside of the template cut-out line

labeled ″Self-Rimming Cut-Out″.

Position the template on the countertop to ensure clearance

between the lavatory, faucet, and backsplash.

Verify cabinet clearance beneath the countertop.

Use a pencil to trace the template on the countertop.

Check the clearance between the lavatory, faucet, backsplash, and

cabinet. Adjust the traced cut-out line accordingly.

Mark the faucet and handle centerline on the countertop.

Above-Counter Installation

Cut out the template along the inside of the template cut-out line

labeled ″Above-Counter Cut-Out″.

Position the template on the countertop.

For Wall-Mount Faucets: Provide sufficient spout overhang into

the lavatory basin. The faucet spout length must be at least 5″

(12.7cm) to provide proper performance.

For Countertop Faucets: Pay special attention to the spout and

handle ﬁt clearance when locating the faucet. Use the template to

locate the faucet spout hole centerline on the countertop. This

centerline is recommended to provide adequate clearance

between the edge of the lavatory and the spout.

Check for adequate clearance between the backsplash, faucet

spout and handles, and lavatory. Kohler Co. recommends a

clearance of at least 1″(2.5cm). See illustration.

Refer to the faucet installation instructions for required clearance,

and mark the preferred faucet hole locations using a soft lead

pencil.

KohlerCo.51018897-2-A

Preparation (cont.)

Trace the template on the countertop.

1018897-2-A 6KohlerCo.

2. Install the Lavatory

Cut out the opening by carefully following the pencil line traced

from the template.

CAUTION: Risk of personal injury or product damage. This

lavatory is made of glass. Always use the same extreme care

appropriate for ﬁne china when handling to avoid breakage.

Temporarily position the lavatory in the countertop cutout so the

“Kohler” logo is visible. The logo is on the inside basin, near the

rim, and should be positioned near the faucet.

Verify proper clearance between the lavatory, faucet, and

backsplash.

Remove the lavatory from the cutout, and return it to its

protective carton. Do not rest or store the lavatory on the drain

surface.

Drill the faucet holes.

Install the faucet to the countertop according to the

manufacturer’s instructions.

NOTE: Apply a generous amount of clear silicone sealant when you

install the drain.

Install the drain to the lavatory according to the drain installation

instructions.

"Kohler" Logo

Adhesive

Seal Self-Rimming Installation Above Counter Installation

Adhesive

Seal

KohlerCo.71018897-2-A

Install the Lavatory (cont.)

For tile, wood, or other porous materials, apply waterproof sealer

around the cutout area of the countertop surface. Follow all

manufacturer’s instructions and warnings. Allow the sealer to dry

before proceeding.

Use a 50/50 mixture of isopropyl alcohol and water to clean the

countertop surface around the cutout area. Wipe dry with a clean

cloth.

NOTE: Install the adhesive seal when the temperature is at least 50°

F (10° C). The preferred temperature range to apply the adhesive

seal is 70° (21° C) to 100° F (38° C).

Self-Rimming Installation

Loosely apply the adhesive seal (included) around the entire

countertop cutout so it is about 3/16″(5mm) from the cutout.

Adjust the placement of the seal before removing the backing

material. Cut off any excess seal material. Carefully remove the

adhesive seal backing material.

Above-Counter Installation

Loosely apply the adhesive seal (included) around the entire

countertop cutout so it is alongside the cutout hole. Adjust the

placement of the seal before removing the backing material. Cut

off any excess seal material. Carefully remove the adhesive seal

backing material.

All Installations

Note the location of the “Kohler” logo. The lavatory should be

installed so the logo is visible after installation.

Carefully position the lavatory in the cutout, and press down

ﬁrmly.

Connect and tighten the trap to the drain, and complete the water

supply connections to the faucet according to the instructions

packed with the faucet.

Run water into the lavatory and check for leaks.

Clean up with a non-abrasive cleaner.

1018897-2-A 8KohlerCo.

Guide d’Installation

Lavabo Sur Comptoir

Outils et Matériaux

Merci d’avoir choisi un produit KOHLER

Nous apprécions votre engagement envers la qualité KOHLER. S’il

vous plait, prenez quelques minutes et lisez attentivement ce guide

avant de commencer votre installation. N’hésitez pas à nous contacter

en cas de problème d’installation ou de fonctionnement. Nos numéros

de téléphone et notre adresse du site Internet sont au verso. Merci

encore d’avoir choisi un produit KOHLER.

Avant De Commencer

Respectez tous les codes locaux de plomberie et de bâtiment.

Ne pas laisser reposer le lavabo sur son drain.

ATTENTION : Risque de blessures ou d’endommagement du

produit. Ce lavabo est fait en porcelaine cèramique. Manipulez

le lavabo avec précaution pour éviter de l’endommager.

Avant l’installation, déballez le nouveau lavabo et examinez le

pour en déceler tout dommage. Remettre le lavabo dans son

emballage de protection en attendant de commencer l’installation.

Vériﬁez l’état du drain et les tuyaux. Remplacez si besoin.

Kohler Co. Français-1 1018897-2-A

Avant De Commencer (cont.)

Ces instructions sont pour l’installation d’un lavabo mural avec

un cadre de support en bois. Pour tous autres types d’installation,

fournissez les supports et ﬁxations ayant les dimensions et la

résistance appropriés.

Utilisez uniquement le mastic fourni avec le lavabo.

Utilisez le plan de découpe fourni avec le lavabo.

Pour le remplacement d’un lavabo, assurez vous que la découpe

originale soit de la même taille ou plus petite que celle requise

pour le nouveau lavabo.

Reportez-vous au plan pour garantir une installation ADA

conforme.

Utilisez ces instructions pour des installations murales, à rebord

intégré et encastré. Suivez uniquement les instructions qui

s’appliquent à votre installation.

Vous pouvez choisir entre un robinet mural ou monté sur

comptoir, selon le style désiré. Un robinet mural est conseillé.

Pour faciliter l’adhérence du mastic adhésif, installez le lavabo

quand la température de la pièce est comprise entre 70° (21º C) et

100°F (38º C).

1018897-2-A Français-2 Kohler Co.

Otros manuales para K-2276

Tabla de contenidos

Idiomas:

Otros manuales de Accesorio de baño de Kohler

Kohler

Kohler TRESHAM K-2607X Instrucciones de montaje

Kohler

Kohler K-8515 Manual de usuario

Kohler

Kohler K-5264 Manual de funcionamiento

Kohler

Kohler K-T15601 Manual de usuario

Kohler

Kohler KUMIN 18656IN-ND Series Manual de usuario

Kohler

Kohler Englefield Valencia Elite Manual de usuario

Kohler

Kohler Levity K-706012-L Manual de usuario

Kohler

Kohler K-97630 Instrucciones de montaje

Kohler

Kohler Archer Heated BubbleMassage K-1124-GHLAW Manual de usuario

Kohler

Kohler K-702010 Manual de usuario

Kohler

Kohler K-701805T-FMSW Manual de usuario

Kohler

Kohler K-2221 Instrucciones de montaje

Kohler

Kohler K-45765 Series Instrucciones de montaje

Kohler

Kohler K-425 Instrucciones de montaje

Kohler

Kohler K-704410 Instrucciones de montaje

Kohler

Kohler MasterShower K-8520 Manual de usuario

Kohler

Kohler K-4777 Instrucciones de montaje

Kohler

Kohler K-6791 Manual de usuario

Kohler

Kohler ACCLIV 33088T-4-CP Manual de usuario

Kohler

Kohler Mira Platinum Dual Manual de usuario

Kohler

Kohler K-8502 Manual de usuario

Kohler

Kohler K-T9474 Instrucciones de montaje

Kohler

Kohler K-4637 Manual de usuario

Kohler

Kohler K-852-HB Guía de inicio rápido

Manuales populares de Accesorio de baño de otras marcas

DURAVIT

DURAVIT C.1 C15240 0090 Manual

Heatstore

Heatstore HSTRL500WTN Manual de usuario

Sunshower

Sunshower PURE SOLO Manual de usuario

Delabie

Delabie Delabie Sporting 714700 Manual de usuario

ESS

ESS Container TCL-11 Manual de usuario

Mustee

Mustee 22C Manual de usuario

VITRA

VITRA V-Flow Manual de usuario

baliv

baliv DUK-80.30 T Manual de usuario

Malmet

Malmet B105BT Manual de usuario

bathstore

bathstore Transition H1690MM Guía

BELLOSTA

BELLOSTA Edward 0800/M Manual de usuario

baliv

baliv DU-5160 Manual de usuario

Franke

Franke PRTR0006 Manual de usuario

Gessi

Gessi RILIEVO 59011 Manual de usuario

noken

noken VITAE 100188525-N299998810 Manual de usuario

Allen + Roth

Allen + Roth 1142VA-30-201 Manual de usuario

Britex

Britex HBDA Manual de usuario

GRE

GRE DSALC32W Manual de usuario