Koehler HKV4000 Guía
Operation and Instruction Manual
REV C
Koehler Instrument Company, Inc.
1595 Sycamore Avenue • Bohemia, New York 11716-1796 • USA
Toll Free: 1-800-878-9070 (US only) • Tel: +1 631 589 3800 • Fax: +1 631 589 3815
http://www.koehlerinstrument.com • e-mail: info@koehlerinstrument.com
Petroleum Testing & Analysis Instrumentation • Custom Design & Manufacturing
HKV4000
High Temperature Kinematic Viscosity Bath
CERTIFICATE OF CONFORMANCE
High Temperature Kinematic Viscosity Bath, HKV4000
K238X2
This certificate verifies that part number K238X2, High Temperature
Kinematic Viscosity Bath, was manufactured in conformance with the
applicable standards set forth in this certification.
Specifications: ASTM D445
ASTM D2532
ASTM D6074
ASTM D6158
IP 71
ISO 3104
DIN 51550
FTM 791-305
NF T 60-100
This unit is tested before it leaves the factory, to ensure total functionality
and compliance to the above specifications and ASTM standards. Test and
inspection records are on file for verification.
Jesse Kelly
Application Engineer
Koehler Instrument Company
HKV4000 High Temperature Kinematic Viscosity Bath
Operation and Instruction Manual
HKV4000-Manual - 1 -
HKV4000 High Temperature Kinematic Viscosity Bath
Operation and Instruction Manual
HKV4000-Manual - 2 -
HKV4000 High Temperature Kinematic Viscosity Bath
Operation and Instruction Manual
HKV4000-Manual - 3 -
WEEE Directive Compliance Statement
Background
The goal of the WEEE Directive is to encourage design of environment-friendly products that
increase reuse, recycling and other forms of recovery to reduce waste streams and applies to
listed Electronic and Electrical Equipment (EEE) and Koehler's equipment falls broadly into
Appendix 1A; Section 9 Monitoring and Control Equipment: Measuring, weighing or adjusting
appliances for household or as laboratory equipment.
Any associated non-embedded equipment such as Lighting (Saybolt Color) and PCs/Printers also
fall under WEEE. If provided with an order these ancillary items must be WEEE compliant. For
these and other reasons (printer cartridges are regionalized) the equipment must be supplied
through a third party supplier in Europe.
The WEEE Directive applies to electrical and electronic equipment falling under the categories
set out in Annex IA provided that the equipment concerned is not part of another type of
equipment that does not fall within the scope of this Directive. Annex IB contains a list of
products which fall under the categories set out in Annex IA.
http://eur-lex.europa.eu/LexUriServ/LexUriServ.do?uri=OJ:L:2003:037:0024:0038:en:PDF
We do not qualify for any of the 10 exemption categories.
http://www.dpa-system.dk/en/WEEE/Products/Exemptions
Professional use
For equipment defined for ’professional use’ local authorities have no role to play. Producers and
importers are basically responsible for collection of WEEE recyclables from the professional user
and for subsequent management. A separate statement is given cataloging the items that
require separation from the equipment along with basic information on subsequent processing or
recycling prior to disposal of the equipment.
http://www.dpa-system.dk/en/WEEE/Products/Private-or-professional-use
Responsibility for Registration and Annual Reporting:
Koehler will not sell directly to end users in the EU and so has no responsibility to register within
each EU state and to make annual reports. Koehler declares that this responsibility is born by the
importer who is the first level of the distribution chain and is subject to producer responsibility.
We will communicate this in writing to our distributor/importers in the EU stating they are
responsible to satisfy WEEE registration and reporting requirements in the EU states where they
conduct sales activities.
It is illegal to market electrical and electronic equipment covered by producer responsibility
without being registered.
http://www.dpa-system.dk/en/WEEE/Producers/Whoissubjecttoproducerresponsibility
Product Design
Koehler's designs allow for complete disassembly to a modular level which usually allows for
standard recycling. A qualified refrigeration system technician must be consulted when
disassembling and de-commissioning any equipment with refrigeration systems.
Koehler's scientific testing equipment is robustly designed to function over a long service life and
are typically repaired many times over the course of years rather than being replaced. We
believe that re-use and refurbishment is the very best form of re-cycling.
All batteries must be readily removable not soldered in place.
Recycling instructions
In the event that replacement becomes necessary, we will include instructions, particularized to
each instrument that informs the customer of their recycling responsibilities and giving them
HKV4000 High Temperature Kinematic Viscosity Bath
Operation and Instruction Manual
HKV4000-Manual - 4 -
guidance in doing this. All Koehler equipment has been placed on the market since 13th August
2005 and so Koehler is defined as a "new WEEE producer". As such we must provide information
on refurbishment, treatment, and re-use.
Our instrument manual will include this compliance statement and indicate that any collection of
materials will be handled by their authorized distributor. In the event that the distributor is
unreachable or is no longer a distributor for Koehler Instrument, Co., other arrangements may be
made including accepting the materials directly.
Recycling is free of charge. Shipping is the responsibility of the end users. Whether shipping to a
distributor or to Koehler directly, safe, properly declared, and labeled packaging and shipping
expenses are the sole responsibility of the end user.
WEEE Marking
Since Koehler products are subject to the WEEE Directive we must display the WEEE symbol
shown above in accordance with European Standard EN 50419 on the equipment. It must be
indelible, at least 5mm in height, and clearly legible. If the equipment is too small the mark must
be in the product literature, guarantee certificate, or on the packaging. Rules on marking are
established in section 49 of the WEEE Order.
Koehler Instrument Company, Inc.
c/o RECYCLING
1595 Sycamore, Ave.
Bohemia, NY 11716
As a minimum the following substances, preparations and components have to be removed from
any separately collected WEEE:
- Mercury containing components, such as switches or backlighting lamps (compact fluorescent
lamps, CFL),
- Batteries
- Printed circuit boards if the surface of the printed circuit board is greater than 10 square
centimeters (about 4 sq in.),
- Toner cartridges, liquid and pasty, as well as color toner,
- Chlorofluorocarbons (CFC), hydrochlorofluorocarbons (HCFC) or hydrofluorocarbons (HFC),
hydrocarbons (HC)
- Liquid crystal displays (together with their casing where appropriate) of a surface greater than
100 square centimeters and all those back-lighted with gas discharge lamps,
- External electric cables
- Components containing refractory ceramic fibers as described in Commission Directive
97/69/EC of 5 December 1997 adapting to technical progress Council Directive 67/548/EEC
relating to the classification, packaging and labeling of dangerous substances (2),
- Electrolyte capacitors containing substances of concern (height > 25 mm, diameter > 25 mm or
proportionately similar volume)
2. The following components of WEEE that is separately collected have to be treated as
indicated:
- Equipment containing gases that are ozone depleting or have a global warming potential (GWP)
above 15, such as those contained in foams and refrigeration circuits: the gases must be properly
extracted and properly treated. Ozone-depleting gases must be treated in accordance with
Regulation (EC) No 2037/2000 of the European Parliament and of the Council of 29 June 2000
on substances that deplete the ozone layer (4).
HKV4000 High Temperature Kinematic Viscosity Bath
Operation and Instruction Manual
HKV4000-Manual - 5 -
Table of Contents
1Introduction.................................................................................................7
1.1 Koehler’s Commitment to Our Customers ..................................................................... 7
1.2 Recommended Resources and Publications................................................................. 7
1.3 Instrument Specification................................................................................................. 8
2Safety Information and Warnings..............................................................8
3Getting Started............................................................................................9
3.1 Packing List.................................................................................................................... 9
3.2 Unpacking ...................................................................................................................... 9
3.3 Setup............................................................................................................................ 10
4Descriptions..............................................................................................11
4.1 Instrument Controls...................................................................................................... 11
4.2 Accessories for Running Tests .................................................................................... 11
4.3 Temperature Controller Operation............................................................................... 13
4.4 Recommended Accessories ........................................................................................ 13
5Operation...................................................................................................14
5.1 Bath.............................................................................................................................. 14
5.2 Start Up........................................................................................................................ 15
5.3 Control Panel Operation............................................................................................... 15
5.4 Test Procedure............................................................................................................. 16
6Safety Features.........................................................................................18
6.1 Over-Temperature Protection ...................................................................................... 18
6.2 Over-Power Protection................................................................................................. 18
7Troubleshooting........................................................................................18
7.1 Unit does not power-up................................................................................................ 18
7.2Unit is on and keeps resetting into start up routine...................................................... 18
7.3 Unit is on but bath does not heat up ............................................................................ 18
7.4 Bath heats up but temperature does not stabilize........................................................ 19
8Maintenance..............................................................................................19
8.1 Routine Maintenance ................................................................................................... 19
8.2 Bath Cleaning............................................................................................................... 19
8.3 Draining / Changing Bath Medium............................................................................... 19
8.4 Changing Bath Lamp / Bulb......................................................................................... 20
HKV4000 High Temperature Kinematic Viscosity Bath
Operation and Instruction Manual
HKV4000-Manual - 6 -
8.5 Replacement Parts....................................................................................................... 21
9Wiring Diagrams .......................................................................................22
9.1 K23802 Wiring (115V).................................................................................................. 22
9.2 K23892 (220V) Wiring.................................................................................................. 23
10 Service.......................................................................................................24
11 Storage ......................................................................................................24
12 Warranty....................................................................................................24
13 Returned Goods Policy............................................................................24
Tabla de contenidos
Otros manuales de Equipo de laboratorio de Koehler
Manuales populares de Equipo de laboratorio de otras marcas
Agilent Technologies
Agilent Technologies 5800 ICP-OES Manual de usuario
Endress+Hauser
Endress+Hauser Cleanfit CPA875 Manual de usuario
NI
NI PXI-5422 Manual
Collomix
Collomix Aqix Manual de usuario
SPEX SamplePrep
SPEX SamplePrep 6875 Freezer/Mill Series Manual de usuario
Ocean Insight
Ocean Insight FLAME-NIR+ Manual de usuario
