Kodak CHERISH F680 Manual de usuario


Page | 2 Introduction
1 x Power adapter for
Home Unit
1 x Home Unit(Camera)
WELCOME ASSEMBLY
Thank you for buying the KODAK CHERISH F680
Battery Operated Wi-Fi Home Monitor.
With your mobile device, now you can monitor your
baby sleeping in another room anywhere, anytime!
Please keep your original dated sales receipt. You will
need to produce a copy of your dated sales receipt to
conirm warranty status.
For product-related questions, please send an email
to: support@kodaksmarthome.com.
This User’s Guide covers all the information you’ll need
to get the most from your product.
Prior to using the Home Monitor, we recommend that
you fully charge the battery. This way, the device will
continue to work even if you disconnect it from the
power supply to carry it to another location. Please
read the Safety Instructions on page 12 carefully
before installation.
Check List:

Page | 4 Home Unit Overview
HOME UNIT OVERVIEW
1. Camera Lens
2. IR Lens
3. Microphone
4. Pair Button
5. SD Card Cover
6. Lens Frame
7. LED Power Indicator
8. Power ON/OFF Switch
9. Speaker
10. Charging Socket
11. Ball Joint Arm
12. Thermometer and
humidity sensor
13. Battery Door
7
6
10
12
13
11
8
4
5
1
2
3
9

Page | 6 Behaviors for Home Unit
Camera is OFF, battery is charging: Solid Red
Camera powering up: Solid Blue for irst few seconds
Camera locating router: Blue blinking every one second
Camera connected to router: Solid Blue
Camera in pair mode: Blinking Blue & Red
Firmware upgrading. DO NOT SWITCH OFF THE CAMERA:
Blinking Purple, Red & Blue
Camera is OFF, battery is fully charged: No Light
LED Behaviors for Home Unit

Page | 8 Guidelines to Install Your Home Monitor
• The signal strength may also be reduced by
other solid structures, like walls or electrical
equipment, such as radios, TVs, computers,
cordless or mobile phones, luorescent lights or
dimmer switches.
• Use of other 2.4 GHz products, such as wireless
networks (Wi-Fi routers), Bluetooth systems, or
microwave ovens, may cause interference with
this product, so keep the Home Monitor at least
5 feet from these types of products, or turn them
o if they appear to be causing interference.
ESSENTIAL GUIDELINES FOR INSTALLING YOUR HOME MONITOR
• If the signal is weak, try moving the Home
monitor to another position in the room.

Page | 10 Table of Contents
1. Safety Instructions
2. Getting Started
3. Using the Home Monitor
3.1 Setting Up
3.2 Power On or Off the Home Unit
4. Disposal of the Device (Environment)
5. Cleaning
6. Troubleshooting
7. “KODAK Smart Home” In-App Setup
TABLE OF CONTENTS
8. Monitoring Your Home Via App
9. Grant Access
10. Further Information
• Exclusion
• How to Obtain Warranty Service or Other
Information?
• FCC, IC And CE Regulations
• Warning
• EC Declaration of Conformity
11. Technical Speciications
12
14
16
18
19
20
22
34
38
42
56

Page | 12 Safety Instruction
Strangulation Hazard: Children have STRANGLED in
cords.
Keep this cord out of the reach of children (more than 3ft
away). Do not remove this tag. NEVER use extension cords
with AC Adapters. Only use the AC Adapters provided.
Home Unit Set Up & Use:
• Determine a location for the Home Unit that will
provide the best view of your monitoring area
• Place the Home Unit on a lat surface, such as a
dresser, bureau, or shelf or mount the Unit to a wall
securely using the keyhole slots in the underside of
the stand.
• NEVER place the Home Unit or cords within the cot.
This Home Monitor is compliant with all relevant standards
regarding electromagnetic ields and is, when handled
as described in the User’s Guide, safe to use. Therefore,
always read the instructions in this User’s Guide carefully
before using the device.
• Adult assembly required. Keep small parts away from
children when assembling.
1. SAFETY INSTRUCTION
WARNING:
• This product is not a toy. Do not allow children to
play with it.
• This Home Monitor is not a substitute for responsible
adult supervision.
• Keep this User’s Guide for future reference.
• Do not place the Home Unit or cords in the cot or
within reach of the sound (the Unit and cords should
be more than 3 feet away).
• Keep the cords out of reach of children.
• Do not cover the Home Monitor with a towel or
blanket.
• Test this monitor and all its functions so that you are
familiar with it prior to actual use.
• Do not use the Home Monitor in damp areas or close
to water.
• Only use the chargers and power adapters provided.
Do not use other chargers or power adapters as this
may damage the device and battery pack.
• Only insert a battery pack of the same type.
• Do not touch the plug contacts with sharp or metal
objects.
• Connect the power adapters to easily accessible
electrical outlets.
CAUTION:
• Risk of explosion if battery is replaced by an
incorrect type.
• Dispose of used batteries according to their
instructions.

Page | 14 Getting Started
2. GETTING STARTED
1. Insert the small end (USB) of the Home Unit’s power
adapter (Output 5V, 1500mA) into the USB socket
in the back of the Home Unit.
2. Insert the other end of the power adapter into a
suitable electrical outlet.
3. Slide the ON/OFF switch to the ON position to
switch on the Home Unit. The power indicator
lights up in blue.
4. Slide the ON/OFF switch to the OFF position to
switch o the Home Unit. The power indicator
lights up in red, indicating that the battery is being
charged.
*IMPORTANT: Only use the supplied power
adapter.*
Home Unit Power Supply

Page | 16 Using the Home Monitor
3. USING THE HOME MONITOR
• Make sure that the Home Unit is switched on.
• Place the Home Unit in a convenient location (e.g.
on a table) and point the camera lens towards the
area you want to monitor.
NOTE:
• Do not place the Home Unit within reach of a child
or baby! If there is interference with the picture or
sound, try moving the units to dierent locations,
and ensure that they are not close to any other
electrical equipment.
• If you hear a high pitched noise. This is not a fault.
The unit is designed to be operated at some
distance apart. So move the units further apart.
• It is recommended to use a Class 10 SD Card.
(Insert the SD card with the labels facing towards
you)
• Slide the ON/OFF switch to the ON position to
switch on the Home Unit. The power indicator
lights up in blue.
• Slide the ON/OFF switch to the OFF position to
switch o the Home Unit. The power indicator goes
o if the battery is not being charged, or lights up
in red if it is charging.
3.1 Setting Up 3.2 Power On or Off the Home Unit
Please read these instructions carefully, and be aware
that Home Monitor is only intended as an aid.
It is not a substitute for responsible adult supervision.

Page | 18 Disposal of The Device Cleaning
4. PROPER DISPOSAL OF THE DEVICE
When the product comes to the
end of its lifecycle, you should not
dispose of it with normal household
waste. Take the product to a
collection point for the recycling
of its electrical and electronic
components.
This is indicated by the symbol on the product,
User’s Guide and/or packaging.
Some of the product materials may be reused if you
take them to a recycling point. By reusing some parts
or raw materials from used products, you make a
signiicant contribution to environmental conservancy.
Please contact your local authorities if you required
any further information on the collection points in your
area.
Please dispose of the battery pack in an
environmentally-friendly manner in accordance with
your local regulations.
Wipe your Home Monitor with a slightly moistened or
anti-static cloth. Refrain from using cleaning agents or
abrasive solvents.
Cleaning and Maintenance
• Never clean any part of the product with thinners
or other solvents and chemicals – this may result
in permanent damage to the product which is out
of the scope of coverage of the Warranty.
• Make sure that your Home Monitor stays away
from hot, humid areas or conditions, strong
sunlight and avoid moisture.
• We have made every eort to ensure that your
Home Monitor is highly reliable. Yet, if anything
goes wrong, please do not try to repair it yourself
– instead, contact our Customer Service for help.
Note:
Always turn o and disconnect the power adapter prior
to cleaning your Home Monitor.
5. CLEANING YOUR DEVICE
Este manual sirve para los siguientes modelos
2
Tabla de contenidos
Otros manuales de Cámara de seguridad de Kodak























