Kodak Slide Projector Manual de usuario

Operating Manual

CONSUMER IMAGING

KODAK

CAROUSEL®

Slide Projector

Important Safety Instructions

When using your projector, always follow basic safety precautions:

1. Read and understand all instructions before using this equipment.

2. Operate this projector with 110- to 125-volt 60 Hz current only. Incorrect voltage can cause projector

malfunction.

3. Close supervision is necessary when any appliance is used by or near children, or others who may not

understand the need for these precautions. Do not leave the projector unattended during use.

4. Be careful not to touch hot parts. For lamp replacement, allow the module to cool before touching the

lamp and the surrounding area. Do not place the lamp module on heat-sensitive surfaces.

5. Do not operate your projector if the cord is damaged or if the projector has been dropped or damaged

(see “How to Obtain Service” on page 29).

6. Position the cord so that it is not tripped over, pulled, or placed in contact with hot surfaces.

7. If an extension cord is necessary, use a cord with a current rating at least equal to that of the projector.

Cords rated for less amperage than the projector may overheat.

8. Always unplug the projector from the electrical outlet before cleaning and servicing and when it is not

in use.

9. Allow the projector to cool before storing.

10. Do not immerse this equipment in water or other liquids.

11. Do not disassemble this projector. Use a qualified service technician when service or repair is required.

Incorrect reassembly can cause electric shock the next time the projector is used.

12. Use only safety electrical low-voltage (SELV) devices.

13. The use of an accessory attachment not recommended by the manufacturer may increase risk of

damage.

14. Keep the air-flow vents unobstructed.

Save These Instructions

Operating Manual

KODAK

CAROUSEL

Slide Projector

KODAK CAROUSEL® Slide Projector 1

Contents

Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . .Inside Front Cover

Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2

Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3

Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4

Startup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4

Loading the Slide Tray . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5

Projecting Your Slides . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9

Editing Your Presentation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16

Clearing a Gate Jam . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17

Using the Built-In Viewer (Model 5600 Only) . . . . . . . . . . . . . . . . . .18

Shutdown . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .19

Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .20

Changing the Projection Lamp . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .21

Cleaning the Condenser, Heat-Absorbing Glass, and Mirror . . . . . . .22

Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .26

Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .28

How to Obtain Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .29

Serial Number

The serial number of your projector is printed on the label afﬁxed to the power

cord retainer on the base of the projector. Record this number, as well as the

model identiﬁcation, date, and place of purchase, for future reference.

2 KODAK CAROUSEL® Slide Projector

Introduction

Congratulations!

You have just purchased a KODAK CAROUSEL Slide Projector which:

• triples lamp life

• provides brighter and more vivid colors!

Introduction

Take the time to read the instructions in this operating manual to become

familiar with your KODAK CAROUSEL®Slide Projector and how to operate

it properly.

KODAK CAROUSEL® Slide Projector 3

Overview

FRONT RIGHT

BACK RIGHT

BASE

1 – Tray

2 – Lock Ring

3 – Storage Compartment/Remote

4 – Elevating Foot

5 – Elevating Adjustment Wheel

6 – Elevating Foot Release Button

7 – Lens

8 – Viewer (Model 5600)

9 – Focus Knob

10 – Select Bar

11 – Timer (Model 5600)

12 – Reverse

13 – Forward

14 – Power/Fan/Lamp

15 – Tray Release Latch

16 – Lamp Module

17 – Reading Light

18 – Room Light Outlet (Model 5600)

19 – Remote Control Receptacle

20 – Power Cord

21 – Power Cord Retainer

22 – Leveling Foot

4 KODAK CAROUSEL® Slide Projector

Operation

Startup

Open the storage compartment and remove the remote control.

Plug the 5-pin cable remote connector into the remote-control receptacle,

aligning the raised dot with the metallic rivet head.

Plug the power cord into a grounded outlet with 110- to 125-volt 60 Hz

current only.

KODAK CAROUSEL® Slide Projector 5

Operation

Loading the Slide Tray

A KODAK CAROUSEL®140 Slide Tray is designed to hold up to 140 slides.

Be sure that your slide mounts are in good condition; frayed or bent mounts

may fail to drop into the projector. A variety of slide trays are available with

capacity up to 140 slides. See your dealer in Kodak products for a complete

list of Kodak trays and accessories.

Note: Do not attempt to project slides mounted with sticky or loose tape.

Place the tray over the center post of the projector. Align the "0" slot with the

gate index; the tray will drop into position.

If your 140-slide tray does not drop easily, secure the lock ring, invert the

tray, and align the index hole with the index notch. Slide and hold the tray

release latch in the direction of the arrow, and turn the bottom plate until the

index hole and notch align. Then release the latch. If you use an 80-slidetray,

rotate the metal plate on the bottom of the tray until it locks into position.

140-Slide Tray 80-Slide Tray

6 KODAK CAROUSEL® Slide Projector

Operation

Adding Your Slides Remove the lock ring by turning it counterclockwise and lifting it off.

Check each slide’s orientation (horizontal or vertical), and arrange them in the

order you wish to show them. Then turn the slides upside down.

Number each mount in the upper right-hand corner of the film’s shiny side.

Insert your first slide into the first slot in the tray so that the number is visible

on the outer circumference of the tray. Insert your second slide in the second

slot with the emulsion (dull side) facing your ﬁrst slide, and so on.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Proyector de Kodak

Kodak

Kodak Pocket Pico Projector Manual de usuario

Kodak

Kodak Carousel S-AV 1050 Manual de usuario

Kodak

Kodak DP2000 - Digital Projector Manual de usuario

Kodak

Kodak BC4401 - Carousel 4400 Projector Guía de configuración

Kodak

Kodak DP1100 - Digital Projector Manual de usuario

Kodak

Kodak Ektapro 4020 Manual de usuario

Kodak

Kodak FLIK X7 Manual de usuario

Kodak

Kodak Carousel 850H Instrucciones de funcionamiento

Kodak

Kodak DP1050 ULTRA Manual de instalación y operación

Kodak

Kodak Pocket Pico Projector Manual de usuario

Kodak

Kodak DP1100 - Digital Projector Manual de usuario

Kodak

Kodak V600 Manual de usuario

Kodak

Kodak EKTAGRAPHIC AFT Manual de usuario

Kodak

Kodak Carousel S-AV 2050 Manual de funcionamiento

Kodak

Kodak iSow 1000 Manual de usuario

Kodak

Kodak CAROUSEL S-AV2020 Manual de usuario

Kodak

Kodak DP2000 - Digital Projector Manual de usuario

Kodak

Kodak LUMA 450 Manual de usuario

Kodak

Kodak EKTAPRO 7010 Manual de usuario

Kodak

Kodak Carousel S-AV 1030 Manual de usuario

Kodak

Kodak FLIK X4 Manual de usuario

Kodak

Kodak EKTALITE Manual de usuario

Kodak

Kodak EKTASOUND 235 Manual de usuario

Kodak

Kodak 960 Guía del usuario

Manuales populares de Proyector de otras marcas

iEmmet

iEmmet MP-312 Manual de usuario

Epson

Epson VS400 Manual de usuario

Sony

Sony VPL-HS10 Marketing Specifications & Features Manual de usuario

Sony

Sony VPL-HW65ES Manual de servicio

Toshiba

Toshiba TLP-791U Manual de usuario

Philips

Philips LC1341 Guía de referencia

Panasonic

Panasonic PTL735NTU - LCD PROJECTOR-NETWORK IB Manual de usuario

NEC

NEC NP600S EDU Manual de usuario

BenQ

BenQ SH753P Manual de usuario

Eiki

Eiki EK-623U series Manual de usuario

Epson

Epson PowerLite Pro Cinema 6020UB Manual de usuario

Epson

Epson PowerLite Home Cinema 705HD Manual de usuario

Christie

Christie LHD700 Manual de usuario

Navitar

Navitar FX Manual de usuario

InFocus

InFocus LitePro 560 Manual de usuario

Sony

Sony SRX-R815P Manual de usuario

Vivitar

Vivitar DP1500 X Manual de usuario

Acer

Acer C20 Series Manual de usuario