KodaCloud OAP30 Manual de usuario
OAP30 Dual Band
Installation Guide
Access Point
Installation Guide
Package Contents
Step 1 - Connect the Access Point
A Connect one end of the Ethernet cable to the LAN1 Port (PoE of the access point and
the other end to the LAN + PoE (Power-over-Ethernet .
B Screw on the antennas (supplied separately as shown in the following illustration.
C Connect the ground wire to the access point.
Note: The access point supports both IEEE 802.3at PoE (Power-over-Ethernet) supplie by a
switch, or using a PoE Injector. You may use either one as the power source. DO NOT
use both at the same time.
Step 2 – Mount the Access Point
Wall Mounting
A Determine where the AP is to be placed and mark location on the surface for the four
mounting holes. You may adjust the position with a level.
B Use the appropriate drill bit to drill four 8 mm diameter and 37 mm depth holes in the
markings and hammer the bolts into the openings.
C Place the lock and flat washer on the round head screws and drive the screws to attach
mounting base to the back of the access point.
D Attach the device onto the wall by tightening the bolt’s flat washers and nuts to secure
the mounting base to the mounting surface. Connect the ground wire (not shown to a
grounding point.
Pole Mounting
A Place the lock and flat washer on the round head screws and drive the screws to attach
the mounting base to the back of the access point.
B Determine which placement to be assembled. Drive the four round head screws to attach
the pole mount bracket to the mounting base.
C Thread the open end of the pole strap through the two tabs on the pole mount bracket.
D Determine where the AP is to be fastened. Lock and tighten pole strap to secure pole
mount bracket to the pole. Connect the ground wire (not shown to a grounding point.
Tabla de contenidos
Otros manuales de Punto de acceso inalámbrico de KodaCloud
