Heinrichs Messtechnik GmbH
Introduction
I. Shipping and storage; product inspection
Shipping and Storage
The device is to be safeguarded against moisture, dirt (especially the meters internal), impact and
damage. The storage temperature limits are to be observed. Depending on the device size the area
flowmeters float may be secured. This transport protection must be removed before the device is
installed.
Product inspection
Upon receipt of the product, the consignment should be checked for completeness. The data of the
device have to be compared with the packing slip and the order documents
Notify us of any shipping damage immediately upon receipt of the product. Any damage claim
received at a later time will not be honoured.
II. Warranty
Your flow meter was manufactured in accordance with the highest quality standards and was
thoroughly tested prior to shipment. However, in the event any problem arises with your device, we
will be happy to resolve the problem for you as quickly as possible under the terms of the warranty
which can be found in the terms and conditions of delivery. Your warranty will only be honoured if
the device was installed and operated in accordance with the instructions for your device. Any
mounting, commissioning and/or maintenance work is to be carried out by qualified and authorized
technicians only.
III. Maintenance, Repair and Hazardous substances
When used in the intended manner no special maintenance is required. However, the flowmeter
should be checked within the context of routine maintenance of the facility and the pipelines. Should
a repair, calibration or maintenance become necessary, be sure to clean the device thoroughly and
follow the steps in section 2.5 “Returning your flowmeter for servicing or calibration” on page 8
before returning the device to Heinrichs Messtechnik. The operator is liable for any substance
removal or personal damage costs arising from inadequate cleaning of a device sent for repair.
IV. Disposal
Observe the regulations applicable to disposal in the country of installation!
V. Supplementary operating instructions
Supplement operating manuals are available for special features, interfaces and operations relating
to your device, request your copy from our service department.
VI. Operating manual of explosion-proof flowmeters
For installation of the flowmeter within hazardous areas read the operation manual of explosion-
proof flowmeters. It contains all the EX-relevant information for your flowmeter.
Warning
Only devices designated as EX-certified on their rating plates may be used in
areas of potentially explosive atmospheres!
The use of standard equipment in EX-hazardous areas is strictly prohibited.
