KitchenAid KSM3300 Series Manual de usuario

KSM3300 Series

PARTS AND FEATURES

PARTS AND ACCESSORIES

Pouring shield*

Flex Edge

beater*

Wire whip

Dough hook

Speed control

*Available with select models only and available as an accessory purchase.

**Bowl type may vary. Bowls are also available for purchase as separate accessories.

Motor head

Attachment hub

Beater shaft

Flat

beater

Bowl**

ENGLISH

STAND MIXER SAFETY | 3

STAND MIXER SAFETY

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should always be

followed, including the following:

1. Read all instructions.

2. To protect against risk of electrical shock, do not put Stand Mixer in water or

other liquid.

3. This appliance is not intended for use by persons (including children) with

reduced physical, sensory, or mental capabilities, or lack of experience and

knowledge, unless they are closely supervised and instructed concerning use

of the appliance by a person responsible for their safety. Close supervision is

necessary when any appliance is used by or near children. Children should be

supervised to ensure that they do not play with the appliance.

4. Turn the appliance OFF, then unplug from the outlet when not in use, before

assembling or disassembling parts, and before cleaning. To unplug, grasp the

plug and pull from the outlet. Never pull from the power cord.

5. Avoid contacting moving parts. Keep hands, hair, and clothing, as well

as spatulas and other utensils, away from beater during operation to reduce

the risk of injury to persons and/or damage to the Stand Mixer.

4 | STAND MIXER SAFETY

STAND MIXER SAFETY

6. Do not operate any appliance with a damaged cord or plug or after the appliance

malfunctions, or is dropped or damaged in any manner. Return appliance to the

nearest Authorized Service Center for examination, repair, or adjustment.

7. The use of accessories not recommended or sold by KitchenAid may cause

re, electric shock, or injury.

8. Do not use the Stand Mixer outdoors.

9. Do not let the cord hang over the edge of table or counter.

10. Remove the beaters, wire whip, or dough hook from the Stand Mixer before

washing.

SAVE THESE INSTRUCTIONS

This product is designed for household use only.

ELECTRICAL REQUIREMENTS

Voltage: 120 V

Frequency: 60 Hz

Wattage: 250 Watts max

NOTE: The power rating for your Stand

Mixer is printed on the serial plate.

Do not use an extension cord. If the

power supply cord is too short, have a

qualified electrician or service technician

install an outlet near the appliance.

The maximum rating is based on the

attachment that draws the greatest

load (power). Other recommended

attachments may draw significantly

less power.

ENGLISH

USING THE STAND MIXER | 5

USING THE STAND MIXER

ACCESSORY CHART BY MODEL

CHOOSING THE RIGHT ACCESSORY

MODEL ACCESSORIES INCLUDED

KSM3306 Glass bowl, Flex Edge beater, wire whip, dough hook

KSM3311 Brushed stainless steel bowl (no handle), ﬂat beater, wire

whip, dough hook

KSM3316 Polished stainless steel bowl with handle, ﬂat beater, wire

whip, dough hook

KSM3317 Polished stainless steel bowl with handle, Flex Edge beater,

wire whip, dough hook

ACCESSORY USE TO MIX DESCRIPTION

FLAT BEATER

FLEX EDGE BEATER*

Normal

to heavy

mixtures

Cakes, creamed frostings, candies,

cookies, biscuits, pie pastry, meat loaf,

mashed potatoes

WIRE WHIP Mixtures

that need air

incorporated

Eggs, egg whites, heavy cream,

boiled frostings, sponge cakes,

mayonnaise, some candies

DOUGH HOOK Mixing and

kneading yeast

doughs

Breads, rolls, pizza dough, buns

*Available with select models only and available as an accessory purchase.

6 | USING THE STAND MIXER

FOR DETAILED INFORMATION ON USING THE STAND MIXER:

Visit kitchenaid.com/quickstart for additional instructions with videos, inspiring recipes,

and tips on how to use your Stand Mixer.

USING THE STAND MIXER

SPEED CONTROL GUIDE

All speeds have the Soft Start®feature which automatically starts the Stand Mixer

at a lower speed to help avoid ingredient splash-out and “ﬂour puff” at start-up,

then quickly increases to the selected speed for optimal performance.

NOTE: The speed control can be set between the speeds listed in the chart to obtain

speeds 1, 3, 5, 7, and 9 if a finer adjustment is required. Do not exceed Speed 2 when

preparing yeast doughs as this may cause damage to the Stand Mixer.

SPEED ACCESSORY ACTION DESCRIPTION

STIR

For starting all mixing procedures, slow

stirring, combining, and mashing. Use to

add ﬂour and dry ingredients to batter,

and to add liquids to dry ingredients.

Do not use Speed 1 to mix or knead

yeast doughs.

SLOW MIXING

For slow mixing, mashing, and faster

stirring; start mashing potatoes or other

vegetables; cut shortening into flour.

Use to mix and knead yeast doughs,

heavy batters, and candies; mix thin or

splashy batters.

MIXING,

BEATING

For mixing semi-heavy batters, such

as cookies, or to combine sugar and

shortening. Medium speed for cake

mixes.

Use to add sugar to egg whites for

meringues.

BEATING,

CREAMING

For medium-fast beating (creaming),

or whipping. Use to finish mixing cake,

doughnut, and other batters. High

speed for cake mixes.

For medium-fast whipping of

ingredients requiring incorporation of

air, such as egg whites.

8FAST BEATING,

WHIPPING

For whipping cream, egg whites,

and boiled frostings.

FAST WHIPPING

For whipping small amounts of cream

or egg whites; for final whipping of

mashed potatoes.

NOTE: To move the speed control lever with ease, lift slightly up as you move it across

the settings in either direction.

ENGLISH

USING THE STAND MIXER | 7

USING THE STAND MIXER

ASSEMBLING THE STAND MIXER

1Check to be sure that the Stand

Mixer is unplugged, and the speed

control is turned to “0”. 2

Raise the motor head: Slide the

locking lever to the unlock position

and lift the motor head. Once lifted,

slide the locking lever to the lock

position to keep the motor head up.

Attach the bowl: Place the bowl on

the bowl clamping plate and gently

turn it in a clockwise direction to

lock it into place.

Attach any accessory: Slip the

accessory onto the beater shaft and

press upward as far as possible. Turn

the accessory counterclockwise to

hook the accessory over the pin on

the shaft.

NOTE: To move the speed control lever

with ease, lift slightly up as you move it

across the settings in either direction.

8 | USING THE STAND MIXER

USING THE STAND MIXER

IMPORTANT: Your Stand Mixer is

adjusted at the factory so that the ﬂat

beater just clears the bottom of the bowl.

If, for any reason, the ﬂat beater hits the

bottom of the bowl or is too far away

from the bowl, you can easily correct the

clearance.

NOTE: When properly adjusted, the flat

beater will not strike on the bottom or

sides of the bowl. If the flat beater or the

wire whip is so close that it strikes the

bottom of the bowl, coating may wear off

the beater or wires on the whip may wear.

ASSEMBLING THE STAND MIXER

(OPTIONAL) To adjust beater to

bowl clearance: Tilt the motor head

back; then turn the screw slightly

counterclockwise (left) to raise the

beater, or clockwise (right) to lower the

beater. Adjust the beater so that it just

clears the surface of the bowl. If you

over-adjust the screw, the bowl lock

lever may not lock into place.

(OPTIONAL) Place the pouring shield*:

Slide the pouring shield* from the

front of the Stand Mixer over the bowl

until the pouring shield* is centered.

The bottom rim of the pouring shield*

fits inside of the bowl. The pouring

chute will be just to the right of the

attachment hub as you face the

Stand Mixer.

Lower the motor head: Slide the

locking lever to the unlock position

and guide the motor head down.

Make sure motor head is completely

down, then slide the locking lever

to the lock position. Before mixing,

test lock by attempting to raise

motor head.

*Available with select models only and available as an accessory purchase.

ENGLISH

USING THE STAND MIXER | 9

USING THE STAND MIXER

OPERATING THE STAND MIXER

NOTE: The Stand Mixer may warm up during use. Under heavy loads with extended

mixing time, the top of the unit may become hot. This is normal.

Plug the Stand Mixer into a

grounded 3 prong outlet. Always

set the speed control lever on

lowest speed to start, then gradually

increase speed to avoid splashing

ingredients. See the “Speed control

guide” to select the best speed for

your recipe.

Do not scrape the bowl while

the Stand Mixer is operating.

The bowl and beaters are designed

to provide thorough mixing without

frequent scraping. Scraping the

bowl once or twice during mixing

is usually sufficient.

NOTE: To move the speed control lever

with ease, lift slightly up as you move it

across the settings in either direction.

10 | USING THE STAND MIXER

USING THE STAND MIXER

DISASSEMBLING THE STAND MIXER

NOTE: The pouring shield* can be

used to avoid ingredients splashing

out of the bowl when mixing, as well

as to easily pour ingredients in the

bowl while mixing.

Raise the motor head: Check to

be sure that the Stand Mixer is

unplugged, and the speed control is

turned to “0”; then slide the locking

lever to the unlock position and lift

the motor head. Once lifted, slide

the locking lever to the lock position

to keep the motor head up.

(OPTIONAL) Remove the pouring

shield*: Lift the front of the pouring

shield* clear of the rim of the bowl,

and pull away from the Stand Mixer.

Remove the accessory: Turn the

speed control to “0”, unplug the

Stand Mixer, and tilt the motor head

back. Then, press the accessory

upward as far as possible, turn the

accessory clockwise, and pull it off of

the beater shaft.

3Remove the bowl: Gently turn

the bowl counterclockwise to release

it from the bowl clamping plate.

(OPTIONAL) Pour ingredients into the

bowl through the pouring chute.

*Available with select models only and available as an accessory purchase.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Idiomas:

Otros manuales de Electrodoméstico de cocina de KitchenAid

KitchenAid

KitchenAid KSVC 3610 Manual de usuario

KitchenAid

KitchenAid 5FGA Guía rápida

KitchenAid

KitchenAid KHB1231 Manual de usuario

KitchenAid

KitchenAid KUBL204E Manual de usuario

KitchenAid

KitchenAid 5KSMMGA Manual de usuario

KitchenAid

KitchenAid KJG02A Series Manual de usuario

KitchenAid

KitchenAid KSS3121 Manual de usuario

KitchenAid

KitchenAid KSM45 Series Manual de usuario

KitchenAid

KitchenAid KPS2CL Manual de usuario

KitchenAid

KitchenAid 5KGB Manual de usuario

KitchenAid

KitchenAid KSM2SCA Manual de usuario

KitchenAid

KitchenAid ARTISAN KEA28AMANA Manual de usuario

KitchenAid

KitchenAid KEC56 Manual de usuario

KitchenAid

KitchenAid KBCS24 Manual de lista de piezas

KitchenAid

KitchenAid 5KSM5SSBCE Manual de usuario

KitchenAid

KitchenAid 5KSM2CB5B Series Manual de usuario

KitchenAid

KitchenAid KHIP365510 Manual de usuario

KitchenAid

KitchenAid 5KSM5SSB Manual de usuario

KitchenAid

KitchenAid KBCO24LSBX - 24" Wine Cooler Manual de lista de piezas

KitchenAid

KitchenAid KSMSCA Manual de usuario

KitchenAid

KitchenAid KSM2CB5 Manual de usuario

KitchenAid

KitchenAid KUBR204ESB00 Manual de usuario

KitchenAid

KitchenAid Artisan 5 Series Manual de usuario

KitchenAid

KitchenAid 5KFE5T Manual de usuario

Manuales populares de Electrodoméstico de cocina de otras marcas

Tayama

Tayama TYG-35AF Manual de usuario

AEG

AEG 43172V-MN Manual de usuario

REBER

REBER Professional 40 Guía del usuario

North American

North American BB12482G / TR-F-04-B-NCT-1 Manual de usuario

Presto

Presto fountain popper Manual de usuario

Westmark

Westmark 1035 2260 Manual de usuario

Zanussi

Zanussi ZCG64396XA Manual de usuario

HOFFEN

HOFFEN SM-9302M Manual de usuario

Philips

Philips HD3133 Manual de usuario

Ronco

Ronco Beef Jerky Manual de usuario

Hendi

Hendi 470411 Manual de usuario

Livoo

Livoo MEN386 Manual de usuario

Vogue

Vogue D446 Manual de usuario

croydon

croydon WR-10313-700 Manual de usuario

ADE

ADE AUTOMATIC-L Manual de usuario

Chefman

Chefman RJ43-SQ Series Manual de usuario

Vacmaster

Vacmaster VP680 Manual de usuario

Jetmaster

Jetmaster 900HG Manual de usuario