Kimo MP130 Manual de usuario

MP130 manometer with sealing kit

for gas network

ON : Switch-on

OFF : Switch-off

Escape : Return to previous screen

1x : ''Hold'' : measure holding

2x : ''Min/Max'' : display of minimum and

maximum values from channel 1 since last

request

3x : Back to held measure

''Function'' key

''On / off'' key

''Select'' key

See table

'' unctions available from main screen''

1x Level 1

2x Level 2

3x No backlight

''Backlight'' screen

''OK'' key

1x ''To validate''

or ''Self-calib ation'' see below

Key description of MP130 manometer

Functions available from main screen

Select pressure unit Press to scroll down unit.

Automatic shut-off Press to scroll down minutes.

Beep Press to activate or deactivate

Self-calibration 1x Start self-calibration countdown*

Validate with

*Self-calibration is performed by disconnecting the two pressure inlets of the sensor, then by pressing AutoZ key.

● Connect the cone adapter (the most suitable to the transversal section of the tube) to the male connector of the

sealing kit, and the female connector to the positive inlet of the manometer, as below :

● Isoler l'installation : fermer le robinet du compteur et bloquer les connecteurs fournis à l'installation

Gas meter

ilter and

throttle

● Connect the cone adapter to the connector downstream the counter.

● Switch-on the manometer.

● Inject air or gas to test the installation at the good pressure :

- when feeding with air, pressurize the system with the supplied pump ; once the desired pressure is reached, close

the tap.

- when using combustible or inert gases, close the tap and pressurize the system.

Checking point for new,

renovated and under use

installations

Positive inlet of the manometer

Preliminary operations to use the MP130 manometer with its sealing kit

● Isolate the installation : close the tap of the counter and block the supplied connectors to the installation.

MP 130

Pump

Cone adapter

NTang – MP130 – 29/03/10– RCS (24) Périgueux 349 282 095 Non-contractual document – We reserve the right to modify the characteristics of our products without prior notice.

Otros manuales de Instrumento de medición de Kimo

Manuales populares de Instrumento de medición de otras marcas

Suaoki

Suaoki D40 Manual de usuario

Elster

Elster BK-G1.6 Manual de usuario

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manual

Duratool

Duratool D03128 Manual de usuario

Vega

Vega VEGAPULS 65 Manual de usuario

Tonghui

Tonghui TH2618B Manual de usuario

Tenmars

Tenmars TM-801 Manual de usuario

MSR

MSR 145 Manual de usuario

TPS

TPS WP-82 Manual de usuario

ELMETRON

ELMETRON CP-511 Manual de usuario

PCB Piezotronics

PCB Piezotronics 003C30 Manual de usuario

Tenma

Tenma 72-10465 Manual de usuario

Endress+Hauser

Endress+Hauser Proline Promag 50 Especificaciones técnicas

Siemens

Siemens SITRANS F Coriolis FCT030 Manual de lista de piezas

KLINGER

KLINGER CMF V Series Manual de usuario

EXFO

EXFO FTB-2 Manual de operación y mantenimiento

Keysight

Keysight M8290A Manual de usuario

ADTEK

ADTEK MW-5 Manual de usuario